PAC RadioPRO Advanced FD1A-RSX Handleiding
Pagina's 5 Niet gecategoriseerd
Bekijk de handleiding van PAC RadioPRO Advanced FD1A-RSX gratis online of download de PDF. 11 mensen vonden deze handleiding nuttig. Vraag over dit model? Stel een vraag
Radio Replacement and Steering Wheel Control
Interface for Ford / Lincoln / Mercury Vehicles
FD1A-RSX
© 2025 Stinger Solutions. All rights reserved. PAC is a Power Brand of Stinger Solutions
PAC-audio.com
C
Page 1
Rev: 1
Date: 8/28/25
Introduction and Features
Important Notes
Wiring Connection Chart
The FD1A-RSX interface allows the replacement of a factory radio in select Ford/Lincoln/Mercury vehicles with MSCAN
databus radios. Using this interface will retain factory features such as steering wheel controls (SWC), rear seat
entertainment (RSE), rear seat controls (RSC) and the THX or Sony amplier when the original radio is removed. Use of
this interface also allows you to program two radio functions to each SWC button by using short press long press dual
command functionality. The FD1A-RSX also provides data bus driven outputs such as retained accessory power (RAP),
vehicle speed sensor (VSS), illumination, reverse trigger and parking brake.
1. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the
interface into the vehicle (see next page for setting chart).
2. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless
you wish to re-assign the SWC functions or utilize short press long press dual command functionality. The SWC can always
be restored to default settings by pressing and releasing the program button on the side of the interface once and waiting 7
seconds for the LED to ash 4 times.
3. 2005-07 Ford Freestyle, Mercury Montego, and Ford Five Hundred - In order for SWC to function in these vehicles, you must
re-calibrate the SWC using the procedure outlined on page 4.
4. RSC buttons that are identical to the SWC will mimic the SWC one for one. All other buttons cannot be programmed.
5. The LED will ash whenever a SWC button is pressed.
6. When used in a vehicle equipped with an LCD screen, the screen will display the SWC functions as they are pressed on
the steering wheel. It will also display “Programming Mode” whenever the programming button on the side of the interface is
pressed.
7. The RSC must be in AM mode for track +/- to function. RSC must be set to AUX mode to pass audio to aftermarket radio.
8. Vehicles equipped with a factory amplied system must disconnect SYNC if they wish to use the voice button. Not disconnecting
SYNC will result in the rear speakers muting every time the voice button is pressed.
9. Feeding too strong of an audio signal into the headrest monitors will cause the audio output to shut down. If this happens you
must turn the tv off, then on, and lower the audio signal.
Light GreenParking Brake
Output (-)
PinkVehicle Speed
Output
Blue / WhiteAmp Turn On Input
RedAccessory Output
(10 amp)
Orange / WhiteIllumination Output
(+)
Violet / WhiteReverse Output (+)
Interface Connector
YellowBattery +12v
BlackGround
BlueAntenna On Input
WhiteFront L + input
White / BlackFront L - input
GrayFront R + input
Gray / BlackFront R - input
GreenRear L + input
Green / BlackRear L - input
PurpleRear R + input
Purple / BlackRear R - input
Vehicle Connector
SWC Connector
Blue / YellowKenwood, Newer
JVC
3.5mm JackAlpine, Axxera, JVC,
Clarion, Fusion,
Pioneer, Sony, Dual,
Lightning Audio,
Jensen, Nakamichi
Rockford Fosgate
Product specificaties
| Merk: | PAC |
| Categorie: | Niet gecategoriseerd |
| Model: | RadioPRO Advanced FD1A-RSX |
Heb je hulp nodig?
Als je hulp nodig hebt met PAC RadioPRO Advanced FD1A-RSX stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Niet gecategoriseerd PAC
PAC CAM-GM51 Handleiding PAC BCI-FD21 Handleiding PAC MCI-GM53 Handleiding PAC NU-GM4 Handleiding PAC SRK-RAM13HX Handleiding PAC SRK-GM14HX Handleiding PAC AAI-TY3 Handleiding PAC RadioPRO Advanced CH2A-RSX Handleiding