Ozito PXMBC-002 Handleiding

Bekijk gratis de handleiding van Ozito PXMBC-002 (2 pagina’s), behorend tot de categorie Batterij-oplader. Deze gids werd als nuttig beoordeeld door 10 mensen en kreeg gemiddeld 4.3 sterren uit 9 reviews. Heb je een vraag over Ozito PXMBC-002 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS FOR

YOUR CHARGER.

1. Before using the charger read all instructions and cautionary markings on the charger, battery

pack and the product using the battery pack.

2. This charger is not intended for any uses other than charging Ozito Power X Change rechargeable

batteries. Any other use may result in risk of re, electric shock or electrocution.

3. Do not place any object on top of the charger or place the charger on a soft surface that may

result in excessive internal heat. Place the charger in a position away from any heat source.

4. To reduce risk of damage to the electric plug and cord, pull by the plug rather than the cord when

disconnecting the charger.

5. Make sure the cord is located so that it will not be stepped on, tripped over, or otherwise

subjected to damage or stress.

6. An extension cord should not be used unless absolutely necessary. Use of an improper extension cord

could result in the risk of re, electric shock or electrocution.

7. Do not operate the charger if it has received a sharp blow, been dropped or otherwise damaged in

any way. Have it checked by an electrician or power tool repairer.

8. Do not disassemble charger. Take it to an electrician or power tool repairer when service or repair

is required. Incorrect reassembly may result in a risk of electric shock, electrocution or re.

9. To reduce risk of electric shock, unplug the charger from the outlet before attempting any

cleaning. Removing the battery pack will not reduce this risk.

10. Never attempt to connect 2 chargers together.

11. The charger is designed to operate on standard household electrical power (240 volts). Do not

attempt to use it on any other voltage!

12. DO NOT USE the charger where the temperature may reach below 0° or exceed 40°C. If the

battery pack is too hot or too cold charging will cease and begin automatically only when battery

reaches correct charging temperature.

13. Do not incinerate the battery pack even if it is seriously damaged or is completely worn out. The

battery can explode in a re.

14. Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks

or cracks, immediately discontinue use and do not recharge.

15. During charging, the battery must be placed in a well ventilated area.

CHARGER SAFETY WARNINGS

ELECTRICAL SAFETY

WARNING!When using mains-powered tools, basic safety

precautions, including the following, should always be followed to

reduce risk of fire, electric shock, personal injury and material damage.

Read the whole manual carefully and make sure you know how to switch the tool off in an emergency,

before operating the tool.

Save these instructions and other documents supplied with this tool for future reference.

Note: The supply of 230V and 240V on Ozito tools are interchangeable for Australia and New Zealand.

This charger is double insulated therefore no earth wire is required.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly

qualied persons in order to avoid hazard.

Note: Double insulation does not take the place of normal safety precautions when operating this tool.

The insulation system is for added protection against injury resulting from a possible electrical insulation

failure within the tool.

Using an Extension Lead

Always use an approved extension lead suitable for the power input of this tool. Before use, inspect

the extension lead for signs of damage, wear and ageing. Replace the extension lead if damaged or

defective.

When using an extension lead on a reel, always unwind the lead completely. Use of an extension lead

not suitable for the power input of the tool or which is damaged or defective may result in a risk of re

and electric shock.

To reduce the risk of electric shock, we recommend the use of a residual current device (rated 30mA or

less).

This appliance is not intended for use by persons (including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge, unless they have been given supervision or

instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

CARING FOR THE ENVIRONMENT

Power tools that are no longer usable should not be disposed of with household

waste but in an environmentally friendly way. Please recycle where facilities exist.

Check with your local council authority for recycling advice.

Recycling packaging reduces the need for landll and raw materials. Reuse of

recycled material decreases pollution in the environment. Please recycle packaging

where facilities exist. Check with your local council authority for recycling advice.

2

SPECIFICATIONS

Input: 220-240V ~AC 50-60Hz

Output 1: 18V DC, 3.0A

Output 2: 18V DC, 3.0A

Battery Charge Time: 30Min - PXBP-150 (18V 1.5Ah)

40Min - PXBP-200 (18V 2.0Ah)

60Min - PXBP-300 (18V 3.0Ah)

75Min - PXBP-400 (18V 4.0Ah)

120Min - PXBP-520 (18V 5.2Ah)

100Min - PXUBP-520 (18V 5.2Ah Ultra)

1. Charging Unit

2. Charging Unit LEDs

ozito.com.au

1

MULTI BATTERY FAST CHARGER

INSTRUCTION MANUAL

PXMBC-002

ONLINE MANUAL

Scan this QR Code with your

mobile device to take you to the

online manual.

DESCRIPTION OF SYMBOLS

Double Insulated

Volts Hertz

AmperesAmp Hour

Read Instruction Manual

Indoor Use OnlyDo not dispose of in rubbish

Regulatory Compliance

Mark (RCM)

Do not charge battery in

temperatures exceeding 40C°

4.0A Slow Blow FuseWarning

>40°C

V Hz

A Ah

T4A

Product specificaties