Onkyo SKS-3600 Handleiding

Onkyo Speaker SKS-3600

Lees hieronder de 📖 handleiding in het Nederlandse voor Onkyo SKS-3600 (4 pagina's) in de categorie Speaker. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4

Speaker System

SKS-3600

SKC-3600 Center Speaker System

SKM-3600 Surround Speaker System

Instruction Manual

Thank you for your purchase of the Onkyo speaker

system.

Please read this manual thoroughly before using it.

Following the instructions in this manual will enable

you to obtain optimum performance and listening

enjoyment from your new speaker system.

Please retain this manual for future reference.

Contents

Supplied accessories 2

Placement 2

Using the included cork

spacers and installation

brackets 2

Connections 3

Precaution on use 3

Speaker care 4

Use with a TV set or

computer 4

Speciﬁcations 4

SKC-3600 (center speaker)

× 1

SKM-3600 (surround speaker)

× 2

Speaker cord

× 3 (green: 3 m, blue, gray: 9 m)

Bracket

× 4

Screw

× 4

Cork spacer

× 12

SKC-3600 (Center speaker)

Complements the sound effects from front left and right

speakers to enrich and clear the sound image and move-

ment. In movies, an actor’s speech comes mainly from

the center speaker.

Place the center speaker as close as possible to the TV

or monitor, pointing it towards the listener’s ears. Also,

keep the center speaker’s height at the same level as the

front left and right speakers.

SKM-3600 (Surround left and right speakers)

Enhance the sensation of being at a live performance by

giving three-dimensional sound movement to the sound

effects. Place the surround speakers at the side of the

listener or at a position diagonally from the listener. Ide-

ally, speakers should be placed symmetrically.

Place these speakers so that their height is 1 meter

higher than that of the listener’s ears.

The speaker cabinet is made of wood and sensitive to

extreme temperatures and humidity. Avoid placing the

speaker system in locations subjected to direct sunlight

or in humid places such as near an air conditioner, bath-

room, or kitchen.

We recommend that you use the included cork spacers

so you can enjoy superior sound. The cork spacers also

prevent the speakers from slipping.

Mounting on a wall

Wall-mount the speakers upside down. Layer two spac-

ers and attach them to two locations. The plaques rotate

so that you can position the speakers upside down.

Attaching the brackets:

Use the included screws to attach the brackets to the

back of the speakers.

Caution:

• Make sure that the walls are rigid enough for support-

ing the speaker’s weight.

• The weight a mounting screw can support varies

greatly depending on the wall material and the posi-

tion of the reinforcing ribs embedded in the wall. Use

the thickest and longest possible mounting screws

whose head diameter is less than 10 mm and shank

diameter is less than 4 mm (consult with your

installer).

Supplied accessories

Placement

Using the included cork spacers and

installation brackets

Cork spacer

Bottom of SKM-3600

Bottom of

SKC-3600

Cork spacer SKM-3600

Bracket

Screw

SKC-3600

Bracket

Screw

Cork spacer

• Be sure to turn off your ampliﬁer before connecting

the speaker system. Connecting it while the ampliﬁer

is on may result in damage to the ampliﬁer or the

speaker system.

• The nominal impedance of this speaker system is 8

Ω.

Use only ampliﬁers capable of handling this imped-

ance.

• Use the supplied speaker cables to connect between

the speaker’s input terminals and the ampliﬁer’s

speaker terminals as illustrated below.

• Be sure to connect the Center, Surround Right and

Left speakers with the ampliﬁer’s corresponding

speaker terminals. Also, be sure that you are connect-

ing the speaker’s positive (+) and negative (–) input

terminals with the ampliﬁer’s corresponding positive

and negative speaker terminals. Otherwise, undesir-

able sound ﬁeld or impaired bass-range reproduction

will result.

• Before turning on the ampliﬁer’s power switch, pull

lightly on the speaker cables to ensure that they are

connected securely.

• To prevent damage to cir-

cuitry, never short-circuit the

positive (+) and negative (–)

speaker wire.

The surround speaker bottom and rear are equipped

with screw holes so that you can attach commercially-

available stands or mounting ﬁxtures for a variety of

mounting options. (Two M5 screw holes, 60 mm pitch

on the bottom and one M5 screw hole on the rear.)

Note:

When attaching an

accessory item to a

speaker, be careful

of the length of the

screws used. Use

only screws that

provide the required strength with a screw length

between 7 and 12 mm.

• This speaker system can handle the speciﬁed input

power when it is used for ordinary music reproduc-

tion. If the following abnormal signals are fed to the

speaker, however, an overcurrent may ﬂow in the

internal circuits, causing burning or breakage of the

wires even if the input power is below the speciﬁed

rating.

1. Noise produced when FM station is not tuned in

2. Sound produced when fast-forwarding cassette

tape deck

3. High-frequency sound generated by an oscillator,

an electronic musical instruments, etc.

4. Oscillating ampliﬁer signals

5. Special test signals produced by audio checking

CD, etc.

6. Sound produced when connecting or disconnect-

ing audio connection cables (Always turn off the

ampliﬁer’s power before connecting or discon-

necting cables.)

7. Howling when a microphone is used

• Do not place magnetic objects such as screwdrivers

and iron parts near the speaker system since they use

speakers with strong magnets. Otherwise, the objects

may be attracted, causing injury or damaging the dia-

phragm.

Connections

SURROUND BACK

SPEAKER

FRONT

SPEAKERS SURROUND

SPEAKERS CENTER

SPEAKER

A B

SKF-3600

Front right

speaker

SKF-3600

Front left

speaker

SKC-3600

Center speaker

SKM-3600

Surround right

speaker

SKM-3600

Surround left

speaker

Gray

Green

Blue

1. Strip the insulation of speaker

cables, and twist the core wires

tightly.

2. While pressing the lever, insert

the wire into the hole, and then

release the lever.

3. Make sure that the terminals

are gripping the core wires, not

the insulation.

Installation using commercially-

available stands and ﬁxtures

Precaution on use

M5 screw

5 mm

7 ~ 12 mm

Product specificaties

Merk:	Onkyo
Categorie:	Speaker
Model:	SKS-3600

Heb je hulp nodig?

Als je hulp nodig hebt met Onkyo SKS-3600 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Speaker Onkyo

Onkyo HT-S3405 Handleiding

22 Juni 2023

Onkyo HTP-2S Handleiding

27 Mei 2023

Onkyo SKS-4700 Handleiding

23 Mei 2023

Onkyo SKS-3600 Handleiding

5 Mei 2023

Onkyo D-407F Handleiding

2 Mei 2023

Onkyo D-309H Handleiding

1 Mei 2023

Onkyo SKS-HT230 Handleiding

16 April 2023

Onkyo SKR-L500 Handleiding

11 April 2023

Onkyo SKS-101 Handleiding

10 April 2023

Onkyo Smart Speaker G3 VC-GX30 Handleiding

4 April 2023

Handleiding Speaker

Nieuwste handleidingen voor Speaker

OTTO Bluetooth Revo NC2 Handleiding

20 April 2024

REL Acoustics Strata Handleiding

20 April 2024

REL Acoustics Strata III Handleiding

20 April 2024

Soen Transit Handleiding

18 April 2024

Miller & Kreisel MP300RC Handleiding

18 April 2024

Soen Transit XS Handleiding

18 April 2024

Miller & Kreisel MP7 Handleiding

18 April 2024

Qian QRBT1801 Handleiding

17 April 2024

Focal Twin6 Handleiding

17 April 2024

Kenwood KFC-WPS1000F Handleiding

16 April 2024