O2 Cool FD10006AU Handleiding

Bekijk gratis de handleiding van O2 Cool FD10006AU (5 pagina’s), behorend tot de categorie Ventilator. Deze gids werd als nuttig beoordeeld door 16 mensen en kreeg gemiddeld 4.4 sterren uit 4 reviews. Heb je een vraag over O2 Cool FD10006AU of wil je andere gebruikers van dit product iets vragen? Stel een vraag

10” SMARTPOWER FAN

Model: FD10006AU

- Once the rechargeable batteries have reached their end of life, they cannot be

replaced, but you can continue to use the fan with the alternative power

sources.

USING ALKALINE BATTERIES:

- slide fan switch to OFF and unplug. To open Before installing batteries,

battery covers, turn fan upside down. Using the arrows, push and slide the

two battery compartments open. Install 8 D-size batteries following (+/-)

markings on the battery compartment. Please refer to the numerical battery

order in the gure installation. below for easiest

- To extend alkaline battery life, turn fan to OFF position and unplug when not in

use.

OPERATING THE FAN:

- to HIGH or LOW. To operate the fan, slide the switch on the side of the fan

- To swivel, hold the base and move the fan cage up and down.

USING USB CHARGING PORT:

- To use USB charging port, plug charging cord into USB port on left side of enclosure. Turn switch to the HIGH or LOW position

if you are charging your device while the fan is operating or in STOP position if fan is not operating. When in the OFF position,

the USB charging port will only operate if the AC or car adapter plugged in. is

- The green LED next to the port shows that the charger is energized. When energized, you can plug your charging cord into

your device (cell phone, MP3 player, etc.). If the green LED is not lit, check that an AC adapter or car adapter is installed or

that the rechargeable batteries are fully charged or that the alkaline batteries are fresh.

- mA of current (standard USB) when alkaline batteries are fresh or rechargeable batteries The USB port will provide at least 500

are fully charged. When all the power sources are low, it may not provide enough power for the USB power port.

- For quickest results when charging a device from the USB port, switch the fan to STOP position.

- Using the USB charging port will decrease the number of hours that the fan can run on the batteries.

TROUBLESHOOTING

If the rechargeable batteries are fully discharged, slide switch to OFF, install AC or car adapter and switch to HIGH, STOP or

LOW for the Smart Power® controller to reset.

Following information applies when unit is supplied with USB power adapter.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

Product specificaties