NUVO Bento 60/4086 Handleiding

Bekijk gratis de handleiding van NUVO Bento 60/4086 (38 pagina’s), behorend tot de categorie Lamp. Deze gids werd als nuttig beoordeeld door 19 mensen en kreeg gemiddeld 4.3 sterren uit 3 reviews. Heb je een vraag over NUVO Bento 60/4086 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

ASSEMBLY INSTRUCTION

SKU#60/4085, 60/ 4086

NOTE:Please consult a qualied electrician if you are not certain of theinstallation or service.

CAUTION:Before starting the installation or service, disconnect the power by turning o the circuit breaker

or by removing the fuse at the fuse box.

1.Carefully unpack the xture, lay out all parts on a clean surface.

2.Fasten the mounting strap onto the outlet box by using provided 2 outlet box screws.

3.Screw the tube B to the nipple B. Place the cover over the nipple A. Slide the tube A down to the nipple A. Attach the

top of the curve arms to the cover, and insert the bottom of the curve arms to the xture body. Then place the washer

and decorative ball over the nipple A, fasten the loop to the nipple A.

4.Using two pliers, twist open links at two ends of the chain as show. Hook one link to the loop and the other link to the

screw collar loop. Close the links. Place a piece of cloth between the pliers jaws and the chain link to prevent

scratching the link nish.

5.Weave xture wires up through the tube B, through the nipple A, through the cover, through the tube A, through the

washer, through the decorative ball, through the loop, through the chain, through the ring, through the screw collar loop

and through the canopy and through the nipple on the mounting strap.

6.Tie the ground wires from xture and from outlet box to the ground screw on the mounting strap. Connect the wire

without writing on it (with raised ribs) from the xture to the white wire (neutral wire) from the supply circuit.

Connect the wire with writing on it from the xture to the black wire (live wire) from the supply circuit. Cover the

connections using provided wire connectors. Position wires back inside outlet box.

7.Place the canopy over the nipple all the way to the ceiling and tighten the ring onto the screw collar loop until the

canopy is held firmly against the ceiling.

8.Unscrew the socket rings and socket covers from the sockets. Place the shades and socket covers over the sockets,

refasten the socket rings to secure them.

9.Install the bulbs (Not included). Turn on the power.

A Satco Product

Product specificaties