NUVO 67/110 Handleiding

Bekijk gratis de handleiding van NUVO 67/110 (4 pagina’s), behorend tot de categorie Verlichting. Deze gids werd als nuttig beoordeeld door 4 mensen. Heb je een vraag over NUVO 67/110 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

/ 4 PDF

1

Satco Products, Inc.

Brentwood, NY 11717

INSTALLATION AND SAFETY INSTRUCTIONS

IMPORTANT: Read before installing xture. Retain for future reference.

67-110: Double Face / Mirror / Green

67-111: Double Face / Mirror / Red

67-112: Single Face / Clear / Green

67-113: Single Face / Clear / Red

DETERMINE DIRECTION

• If indicator(s) is needed, carefully remove instruction lm only,

do not remove indicator(s).

• If indicator(s) is not needed, remove both the indicator(s) and

instruction lm.

WIRING DIAGRAM

• Make the proper supply wire

connections.

• If using 120VAC, connect the black

and white wires to the building utility.

• If using 277VAC, connect the orange

and white wires to the building utility.

• Cap off unused wires. In all cases,

use standard wire nuts to connect

to wires.

© Copyright 2023 Satco Products, Inc. 3/23 v1.3

WARNING: Risk of Fire or Electric Shock

• Disconnect power before installation or any maintenance

of the xture.

• To avoid damage, falling, electric shock or re, do not modify the

xture or replace accessories.

• Only authorized, qualied personnel should install this xture and

should follow the owner’s manual.

• Do not dismantle the xture.

• Do not touch the power supply when the xture is operating.

• For use in environments where an accumulation of non-conductive

dust on the xture may be expected.

• Damp rated. Do not use outdoors.

• Do not mount near gas or electric heaters.

• Do not let power cords touch hot surfaces.

• Use caution when servicing batteries. Avoid possible shorting.

• Equipment should be mounted in locations and at heights where it

will not readily be subjected to tampering by unauthorized personnel.

• The use of accessory equipment is not recommended and may cause

an unsafe condition.

• Do not use this equipment for other than intended use.

• Disconnect AC Power and unplug battery before servicing.

• Battery in this unit may not be fully charged. After the AC service is

supplied to unit, let the battery charge up for at least 24 hours before

performing any tests.

IMPORTANT: This product must be installed in accordance with the

applicable installation code by a person familiar with the construction and

operation of the product and the hazards involved.

MAINTENANCE: Battery may need to recharge upon initial power up.

We recommend that the equipment be tested regularly in accordance with

local codes. Replace the batteries as needed if discharge time does not

achieve 90 minutes.

OPERATION: Press the test button, unit luminance by battery backup

and the LED indicator will turn off, release the test switch, LED indicator

will turn on.

TROUBLE SHOOTING GUIDE: If LED indicator does not illuminate,

check the following:

1. Check AC supply – verify that unit has 24 hours AC supply.

2. Unit is shorted or battery is not connected.

3. Battery discharged. Permit unit to charge for 24 hours then re-test.

LED EXIT SIGNS

SURFACE MOUNT LED EXIT SIGNS / EMERGENCY

BATTERY BACKUP

Models: 67-110, 67-111, 67-112, 67-113

Product specificaties