My Wall HP 63 AL Handleiding

Bekijk gratis de handleiding van My Wall HP 63 AL (2 pagina’s), behorend tot de categorie Wandsteun. Deze gids werd als nuttig beoordeeld door 11 mensen en kreeg gemiddeld 4.7 sterren uit 5 reviews. Heb je een vraag over My Wall HP 63 AL of wil je andere gebruikers van dit product iets vragen? Stel een vraag

DEFAULT SETTING

Short press the “OK” button and the mount will automatically retract to the lowest position. To stop it, press the button again.

RESET MODE

Long press the “OK” button for 3 seconds until you hear a beep, and the mount starts to move downwards. Then the mount will move upwards a

little bit when reaching the lowest position and automatically come to a stop. The system resets successfully when the unit emits two beeps.

CONNECT THE MOUNT TO A NEW DEVICE

Short press the “mem2” button ve times, after each press you will hear a beep and at the fth press two beeps, which

indicates the mount is disconnecting from the current paired device. The disconnection is successful when the unit emits one beep.

Then follow the Guidebook of Tuya App Installation and Operation to connect the mount to a new device.

Note: lf the device is failed to search the mount when connecting, follow the above steps or restart the device to re-search the mount.

Remote control operation instructions

Coding of Remote Control and Control Box

STEP 1. When the mount is powered on, press the small button on the control box with a thin tool as shown.

The unit will emit a beep, indicating that the control box is on standby for program coding.

STEP 2. Press the “SET” button on the remote control, and you will hear repeated beeps for approximate 10 seconds indicating

that the remote control is being programmed. The unit will emit a beep again indicating success.

NOTE:Clear up the historical data when replacing a new remote control to pair. Press the small button on the control box with hearing a

beep, and hold for 5 seconds to conrm the data-cleaning process is completed until you hear a beep again.

Hereby, Transmedia Kabelverbindungen GmbH declares that the Motorized Monitor lift Stand (HP 63 AL) are in

compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:

https://www.transmedia-germany.com/download

Upward Movement

Press and hold the button to lift the

mount. (Tips: Clear up all obstacles

within the range of motion.)

Memory Setting

Long press the button for 3 seconds until you

hear a beep, indicating that the current position

has been saved to memory. The “mem” buttons

can each store a di󰀨erent position.

Downward Movement

Press and hold the button to lower the mount.

(Tips: Clear up all obstacles within the range of motion.)

Recall Memory

Press the button and the mount will

automatically get to the position saved in the

corresponding button “mem1”.

Recall Memory

Press the button and the mount will automatically get

to the position saved in the

corresponding button “mem2”.

Lowest Height Limit Setting

Short press the button ve times, after each press you

will hear a beep and at the fth press two beeps. This

indicates the current height is now saved as the lowest

height setting. The lowest height limit will be erased

should the remote control be reset.

Memory Setting

Long press the button for 3 seconds until you hear

a beep, indicating that the current position has

been saved to memory. The “mem” buttons

can each store a di󰀨erent position.

HP 63 AL

is powered by two AAA batteries (not included)

Never operate the mount without a TV installed!

Before power connection, be sure that bracket and the TV installed correctly.

Keep the children away from power.

!

Product specificaties