Mikrotik RouterBOARD PowerBox Pro Handleiding

Bekijk gratis de handleiding van Mikrotik RouterBOARD PowerBox Pro (3 pagina’s), behorend tot de categorie Router. Deze gids werd als nuttig beoordeeld door 88 mensen en kreeg gemiddeld 4.5 sterren uit 9 reviews. Heb je een vraag over Mikrotik RouterBOARD PowerBox Pro of wil je andere gebruikers van dit product iets vragen? Stel een vraag

RouterBOARD PowerBox Pro

Quick Setup Guide and Warranty Information

The PowerBox is an outdoor device with five Gigabit Ethernet ports. It has one USB 2.0 port, and supports PoE

power output to ports 2-5 (1A maximum per port, 2A total maximum).

First use

Connect your WAN cable to port 1, and the other devices to ports 2-5

Set client device IP configuration to automatic (DHCP)

The default IP address from ports 2-5 (LAN) is 192.168.88.1

Powering

The device accepts powering from the power jack or from the first Ethernet port (Passive PoE):

•direct-input power jack (5.5mm outside and 2mm inside, female, pin positve plug) accepts 12-57V DC

•The ether1 port accepts 802.3at/af/passive PoE input 12-57V DC

The power consump on of this device under maximum load is up to 8W

Power output

Device supports passive or standard 802.3at/af PoE input/output. Ethernet ports 2-5 can power other

PoE capable devices with the same voltage as applied to the unit. Less power adapters and cables to

worry about! It can power af/at mode B (4,5+)(7,8-) compatible devices, if 48-57 input voltage is

used. Maximum power output per port is 1A, and 2A total using input voltage 12v-30v. Using input

voltage 31v-57v power limit per port is 450mA. Once Power Output is enabled in RouterOS, the

Ethernet LED adds red color to it (green means Ethernet link is made, red means power but no link,

red and green both means there is link and power).

Booting process

This device doesn't come fitted with a Serial Port connector, so initial connection has to be done via the

Ethernet cable, using the MikroTik Winbox utility. Winbox should be used to connect to the default IP

address of 192.168.88.1 with the username admin and no password.

In case IP connection is not available, Winbox can also be used to connect to the MAC address of the

device. More information here: http://wiki.mikrotik.com/wiki/First_time_startup

In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the

RESET button of the device when starting it until the “ACT” LED light turns off, and the PowerBox will

start to look for Netinstall servers.

Extension Slots and Ports

Five individual Gigabit Ethernet ports, suppor ng automa c cross/straight cable correc on (Auto MDI/X),

so you can use either straight or cross-over cables for connec ng to other network devices.

Buttons and Jumpers

RouterBOOT reset button (RESET, front panel) has three functions:

www.routerboard.com110/04/17

Product specificaties