Metra 99-7413 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Metra 99-7413 (4 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 20 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4
99-7413
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR PAGE
NISSAN
Altima 1993-97........................................................... 1
Altima 1998-01........................................................... 2
KIT COMPONENTS
TOOLS REQUIRED
Cutting tool
Wrench
Phillips screwdriver
Equalizer
Dummy Plate
(6) #6 Self-tapping
Screws
(4) 5mm Flat-head
Screws
Radio Housing
Faceplate
ISO-DIN
Spacers
Mounting
Brackets
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
the shifter cover and (4) Phillips screws
exposed. Remove (2) screws from the
driver's side knee bolster and lower.
Remove (1) screw from the left corner of the
radio triim bezel. Remove (2) screws above
the radio opening and unclip the bezel.
Remove (4) screws from the factory head
unit assembly and disconnect the wiring.
Using the raised lines as a guide, cut and
remove the ends of each Mounting Bracket
("A").
Align the holes in the Mounting Brackets
with the holes in the and Radio Housing
mount with (6) #6 Self-tapping Screws
supplied.
Remove (4) screws securing the cupholder
to the factory head unit assembly and
remove. Slide the cupholder into the bottom
of the Radio Housing and mount with the
same (4) screws. Skip to the Installation
Instructions for ALL VEHICLES on Page #3.
NISSAN Altima 1993-97
1
4
2
3
1
"A"
Disconnect the negative battery terminal to
prevent an accidental short circuit. Unclip
the gear shifter trim bezel and remove (2)
Phillips screws exposed. Remove (2)
Phillips screws above the radio opening.
Unclip the radio trim bezel. Remove (4)
Phillips screws from the factory head unit
and disconnect the wiring.
Locate the corner of each lower mounting
tab on the Mounting Brackets ("A").
Using the corner of each mounting tab as a
guide, cut and remove the ends of the
cupholder mounts from the Mounting
Brackets ("B").
NISSAN Altima 1998-01
1 2
3
2
Align the OUTER holes in the Mounting
Brackets Radio with the holes in the
Housing and mount with (6) #6 Self-
tapping Screws supplied. (The Brackets
will mount on an angle). Skip to the
Installation Instructions for ALL VEHICLES
on Page #3.
4
"A"
"B"


Product specificaties

Merk: Metra
Categorie: Niet gecategoriseerd
Model: 99-7413

Heb je hulp nodig?

Als je hulp nodig hebt met Metra 99-7413 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Metra

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd