Megger TDR500/3 Handleiding
Megger
Meetapparatuur
TDR500/3
Bekijk gratis de handleiding van Megger TDR500/3 (18 pagina’s), behorend tot de categorie Meetapparatuur. Deze gids werd als nuttig beoordeeld door 106 mensen en kreeg gemiddeld 4.4 sterren uit 53.5 reviews. Heb je een vraag over Megger TDR500/3 of wil je andere gebruikers van dit product iets vragen? Stel een vraag
Pagina 1/18
Page 1 1 of
M
TDR1000/3
TDR1000/3P
CFL510G
TDR500/3
Time Domain Reflectometers
User Manual
Page 3 3 of
G SAFETY WARNINGS
■ Safety warnings and precautions must be read and understood before the instrument is used. All Safety warnings and
precautions must be observed during use.
■ The circuit under test must be switched off, de energised, securely isolated - and proved safe before test connections are
made.
■ Use the correct lead se the Megger fused lead set must be used. Refer to the Test Lead selection t. On power systems page
in this user guide to identify the correct lead set.
■ The operator must verify that the circuit is safe before testing and take the appropriate precautions.
■ Ensure that hands remain behind guards of probes/clips when testing.
■ The instrument should not be used if any part of it is damaged. Also all test leads, probes and crocodile clips must be in
good order, clean and with no broken or cracked insulation.
■ Disconnect the test leads before removing the battery cover. The battery cover must be in place whilst conducting tests.
■ This product contains no user service parts.
■ All relevant safety procedures must be followed.
THE INSTRUMENT MUST ONLY BE USED BY SUITABLY
TRAINED AND COMPETENT PERSONS
Page 4 4 of
Symbols
The following symbols are used on this instrument
G
CAUTION: RISK OF DANGER
t
EQUIPMENT PROTECTED THROUGHOUT BY DOUBLE INSULATION OR REINFORCED
INSULATION
c
EQUIPMENT COMPLIES WITH RELEVANT EU DIRECTIVES
EQUIPMENT COMPLIES WITH AUSTRALIAN EMC REQUIREMENTS (C tick) (NOT FOR SAFETY)-
THIS EQUIPMENT SHOULD BE RECYCLED AS ELECTRONIC WASTE
Product specificaties
| Merk: | Megger |
| Categorie: | Meetapparatuur |
| Model: | TDR500/3 |
Heb je hulp nodig?
Als je hulp nodig hebt met Megger TDR500/3 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Meetapparatuur Megger
17 November 2024
17 November 2024
10 Juni 2024
7 Juni 2024
19 Maart 2024
14 Maart 2024
6 Maart 2024
27 Juli 2023
9 Juli 2023
7 Juli 2023
Handleiding Meetapparatuur
- BJZ
- Crowcon
- Vimar
- TFA
- Beckmann & Egle
- Burg-Wachter
- Westfalia
- Albrecht
- Apollo Ultrasonic
- Weidmüller
- Senseca
- BAXTER
- Entes
- ABB
- Cablexpert
Nieuwste handleidingen voor Meetapparatuur
17 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025
15 Juni 2025