Marshall CV-RCP-100 Handleiding

Bekijk gratis de handleiding van Marshall CV-RCP-100 (1 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 3 mensen en kreeg gemiddeld 5.0 sterren uit 9 reviews. Heb je een vraag over Marshall CV-RCP-100 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

1. Connect the 12V Power Supply to the power input on RCP and plug into a

wall outlet to power up and initialize software (first boot up will take up to 30

seconds).

2. Source and connect the male end of a 3-pin XLR cable to the TOP of the

RCP unit.

3. Splice raw wires on other end and insert

into camera RS485 phoenix connector

(tighten) on camera models CV505/565/345/365 or directly into RS485 port on

rear panel of CV502/343/350 camera models.

4. Hold down first camera block assignment on upper left of RCP unit (4-5 seconds) and assign RCP Label

and Camera ID# to 1 (one) and match in OSD Menu of Camera under DISPLAY CONTROL > CAM ID > 0-7.

Assign Camera Model on RCP to correspond to Camera being used and push “Apply”.

5. Repeat up to 7 (seven) cameras on RCP and OSD Menu of

Camera to match control position on RCP, use Y-cable splitters at

each camera.

6. Once setup, try to make adjustments to White Balance, AE

OFFSET (Brightness), or RED/BLUE to see if control is operational.

7. NOTE: If control doesn’t work initially, swap the wires on the

phoenix connector of camera (will not damage either component).

8. For multi-camera setup please see “Multi-Camera Setup

Illustration” and download PDF Illustration.

9. Firmware updates are provided on the Marshall website under CV-RCP-100 landing page. See “Firmware

Update” instructions when “Firmware Update” software and PDF is downloaded.

CV-RCP-100

Touchscreen RCP Camera Control

Initial Startup & Connection Instructions for Marshall CV-RCP-100

• 1 x CV-RCP-100 Camera Control RCP Touchscreen unit

• 1 x Universal 12V Power Supply unit

CV-RCP-100 is setup with a button on each menu page, seen as “?”. Hold down “?” on touchscreen Self Help

when lost or need further explanation. The “?” will flash while in the help mode and specific functions will be

highlighted in blue. Press the highlighted function for a description of the function. Press the “?” button again to

exit the help mode.

Quick Start Guide

Package Contents

Help System

Connection Instructions

Toll Free: (800) 800-6608 | www.marshall-usa.com | [email protected]

JR10417a

USB Port

D-Sub 9

Setting Adjustment Knobs

12VDC

Power

Remote

Connector to

Camera

Serial

Selector

Switch

4.2” (107mm)

5.7” (145mm)1.7” (43mm)

Product specificaties