LigoWave MACH 5 Handleiding

LigoWave Access point MACH 5

Lees hieronder de 📖 handleiding in het Nederlandse voor LigoWave MACH 5 (4 pagina's) in de categorie Access point. Deze handleiding was nuttig voor 26 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4

iPoll 3

Wireless Internet service provider Linkfor, operating in Belgogrod region, is a client of LigoWave‘s distributor in Russia - WMD.

Linkfor has over 3300 commercial clients in total and 345 of those clients are connected with LigoWave devices.

Linkfor recently set up a network with 72 CPEs connected to LigoDLB 5 -90 base-station with an integrated dual-polarized 90

degree sector antenna. The base station comes with a 18 dBi dual-polarized 90° sector antenna. All of the CPEs used for this

network were LigoDLB 5 – 15s. The devices were operating in iPoll 3 mode. LigoWave’s iPoll 3 PTMP (point-to-multipoint) pro-

prietary protocol is an innovative solution to eliminate transmission congestion and close cluster interference created in PTMP

wireless installations.

The throughput was measured to be between 55 and 60 Mbps with all 72 CPEs connected. Linkfor offers the following plans for

their customers: 8 Mbps, 6 Mbps and 4 Mbps. The distribution of clients with different speed plans was set as follows: 8 Mbps

for 10% of clients, 6 Mbps for 20% of clients and 4Mbps for 70% of clients.

Stats

Firmware version APCPE.QM-1.v7.54-DEVEL.17819

Mode Access point (iPoll 3)

Channel width 20 MHz

Number of connected CPEs 72 (LigoDLB 5-15)

CPE distances 10% - 2.5-3 km/1.5-1.8 miles

50% - 3-4 km/1.8-2.4 miles

40% - 4-5 km/2.4-3 miles

Customer service Internet access

The distribution of speed plans

10 %

20 %

70 %

8 Mbps 6 Mbps 4 Mbps

CASE STUDY

Signal, dBm -55 / -60 -60 / -65 -65 / -70

Percentage of CPEs within this signal 16 % 60% 24%

Common Tx rate, Mbps 115 115 86

Common Rx rate, Mbps 130 104 104

The table above shows signal levels and data rates of the client devices connected to the LigoDLB 5-90 base-station

within 5 km range. 16% of the devices fall into the category of signal levels of -55/-60, achieving common Tx/Rx rates

115/130 Mbps. More than half of the CPEs reached a signal level of -60/-65 with the common Tx/Rx rates of 115/104

Mbps. And 24% of the CPEs reached the signal level of -65/-70 dBm with the common Tx/Rx rate of 85/104 Mbps. The

signal levels of even the most distant clients are within the acceptable range with the 15 dBi antenna gain.

Tower

LigoDLB 5-90

Tower

Map of the deployment area

Signal levels and data rates of CPEs connected to the AP within 5 km/3 mile distance

The graph above shows the throughput history of the AP with 70+ clients. The average throughput in the middle of the

day is around 15 Mbps. During the evening period when client activity reaches its peak it can be seen that maximum

throughput can reach up to 55 Mbps. It is important to mention, that AP is operating on a 20 MHz channel width.

50 M

40 M

30 M

20 M

10 M

bites / s

18 19 20 21 22 23 24

MikroTik_X86_Volokonovka - Traffic - CS50

Inbound

Outbound

Current: 2.74 M

Current: 19.72 M

Average: 1.31 M

Average: 15.21 M

Maximum: 5.65 M

Maximum: 54.62 M

Weekly (30 Minute Average)

The second graph is taken during the evening period when network activity is the highest. Usually in asymmetric links the

downlink takes the highest portion of the wireless medium. In this case 75% of wireless medium is taken by the downlink.

This is trafc coming from the AP to the CPEs. This is normal when clients are browsing or downloading various content

from the Internet. The speed plans for customers are limiting both the upload and download speed. The upload is more

limited compared to the download which is common practice in asymmetric link installations.

50 M

40 M

30 M

20 M

10 M

bites / s

18:40 19:00 19:20 19:40 20:00 20:20 20:40 21:00 21:20 21:40 22:00 22:20

MikroTik_X86_Volokonovka - Traffic - CS50

Inbound

Outbound

Current: 1.61 M

Current: 21.36 M

Average: 2.16 M

Average: 30.06 M

Maximum: 5.92 M

Maximum: 53.18 M

Hourly (1 Minute Average)

Product specificaties

Merk:	LigoWave
Categorie:	Access point
Model:	MACH 5
Kleur van het product:	Wit
Gewicht:	3300 g
Breedte:	387 mm
Diepte:	379 mm
Hoogte:	80 mm
Internationale veiligheidscode (IP):	IP67
LED-indicatoren:	LAN, Power, WLAN
Bedrijfsmodi:	Access Point (AP), WDS
Plaatsing:	Ceiling, In-wall, Wall, Window
Frequentieband:	5.150 - 5.850 GHz
Inclusief AC-adapter:	Ja
Vermogensverbruik (max):	4.5 W
Certificering:	FCC, IC, CE
Modulatie:	16-QAM, 64-QAM, BPSK, OQPSK
Gevoeligheid ontvanger:	-97 - -75
Ethernet LAN, data-overdrachtsnelheden:	10, 100 Mbit/s
Netwerkstandaard:	IEEE 802.11a, IEEE 802.11n
Ondersteunde beveiligingsalgoritmen:	WPA2-EAP, WPA2-PSK
Antennas quantity:	1
Antenne versterkingsniveau (max):	23 dBi
Ondersteunde netwerkprotocollen:	IPv6
Draadloos LAN data-overdrachtsnelheid (max):	300 Mbit/s
Web-gebaseerd management:	Ja
Luchtvochtigheid bij opslag:	0 - 90 procent
DHCP server:	Ja
Maximale overdrachtssnelheid van gegevens:	300 Mbit/s
2,4 GHz:	Nee
5 GHz:	Ja
Kanaalbandbreedte:	40 MHz
Quality of Service (QoS):	Ja
DHCP client:	Ja
Power over Ethernet (PoE):	Ja
Antennefuncties:	Ingebouwde antenne
Bandbreedte:	5.85 GHz
Maximum outdoorbereik:	30000 m
WAN-poort:	Ethernet (RJ-45)
Beheerprotocollen:	HTTP(S) GUI, SSH, SNMP read, WNMS, Telnet
Zendvermogen:	29 dBmW
Hoog vermogen:	Ja
AC-ingangsspanning:	100 - 240 V
Relatieve vochtigheid in bedrijf (V-V):	-40 - 65 procent
Inclusief PoE-adapter:	Ja