Lancom OW-702 Handleiding
Pagina's 2 Access point
Bekijk de handleiding van Lancom OW-702 gratis online of download de PDF. Deze handleiding is 11 keer bekeken. Vraag over dit model? Stel een vraag
Hardware Quick Reference
Mounting & connecting
Before initial startup, please make sure to take notice of the information regarding the
intended use in the enclosed installation guide!
Operate the device only with a professionally installed power supply at a nearby power
socket that is freely accessible at all times.
Installing access points and/or external antennas without adequate lightning protection can
lead to serious damage to the devices and/or to the related network infrastructure.
Please observe the following when setting up the device
→The housing of the device may become warm during operation.
→If the device is operated with outside temperatures exceeding 60°C, it should be mounted with protection
against contact.
→When using customized outdoor Ethernet cables, make sure that the cables have a short plug kink
protection.
i
LANCOM, LANCOM Systems, LCOS, LANcommunity, LANCOM Service LANcare, LANCOM Active Radio Control, and AirLancer are registered trademarks. All other names or descriptions used may
be trademarks or registered trademarks of their owners. This document contains statements relating to future products and their attributes. LANCOM Systems reserves the right to change these
without notice. No liability for technical errors and/or omissions. 0326
LANCOM OW-702
➄
Ground connection (bottom of device)
Attach the enclosed grounding cable to the housing on one side with the enclosed M3 screw and to a
suitable grounding conductor on the other side.
➅
Antenna connectors
Screw the supplied dualband antennas to the corresponding connectors on the front and back of the device.
➆
LED block
Display of the operating states of the access point
➇
Ethernet interfaces ETH PoE
The device is simultaneously powered via the ETH PoE connection.
Prepare to install a waterproof Ethernet cable (e. g., LANCOM OW Ethernet Cable 15/30 m) by sliding the end
cap
AB and then the clamp ring over the Ethernet connector on the cable as shown in the adjacent figure. D
Then place the two seal halves
C between plug and clamp ring on the cable and join them together. DB
Next, insert plug
DE into LAN1 connector on the device, carefully push all previously assembled parts
towards plug
DA and screw the end cap to LAN1 connector on the device.E
Outdoor cable diameter: 6.5 mm to 8.5 mm
Connect the other end of the network cable to the ‚Power-Out‘ port of a suitable PoE injector. If required,
additionally connect the LAN2 interface to another network device via a waterproof Ethernet cable.
DCBAE
➈
Reset button (accessible after removing the cover)
To restore the default device configuration, carefully press the reset button in the device with a suitable
pointed object through the recess in the housing until the LEDs on the device go out. During the following
automatic restart, the device loads the default configuration.
RESET
ETH
PoE
WLAN1
Ant2
LEDRESETWLAN2
Ant1
WLAN1
Ant1
WLAN2
Ant2
➈
➄➅➆➇
➅
➅
➅
Product specificaties
| Merk: | Lancom |
| Categorie: | Access point |
| Model: | OW-702 |
Heb je hulp nodig?
Als je hulp nodig hebt met Lancom OW-702 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden