Kohler Artifacts K-22657 Handleiding

Bekijk gratis de handleiding van Kohler Artifacts K-22657 (4 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.1 sterren uit 6 reviews. Heb je een vraag over Kohler Artifacts K-22657 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Installation Guide

SKU#22657

USA/Canada: 1-800-4 KOHLER 1391083_2

www.kohler.com

Approved fastener

(Wire nut)

Electrical tape

PREPARATION

1.Record your model number for future reference.

2.DANGER: Risk of electric shock. To avoid electric shock, the power must be turned off at the circuit breaker or fuse box before

beginning the installation procedure.

3.DANGER: Risk of electric shock. To avoid electric shock, the outlet box must be properly grounded.

4.Important Information. Inspect the product for any damages. This product is for indoor use only. Observe all local codes.

5.Your product may appear different than the one illustrated. The installation procedures remain the same.

Please see next page for a larger installation image

TOOLS AND MATERIALS NEEDED

FIXTURE INSTALLATION

1.Remove the fixture and parts bag(s) from the carton. Put them onto a clean and

soft cloth to protect finish. Confirm all parts are included.

2.To adjust length of cord. Loosen the set screws (L) on the canopy (E) until the cords

(K) can slide. Be careful, do not remove the set screws. Pull cords through canopy (E)

to make sure fixtures and canopy have desired height. Then tighten set screws (L); be

careful not to pierce wiring. Make sure the 3 cords are of the same height.

3.Slide safety clips (M) down to touch canopy. Do not damage the cords insulation layer.

4.Cut excess cord to minimum 6” beyond mounting plate (C).

a)Trim cloth 2” from the end.

b)Strip insulation 5/8” from end of wire without cutting copper wire.

c)Twist each copper wire individually.

5.Attach mounting plate (C) onto outlet box with screws (B). Ensure the direction of

ground screw (N) and mounting screws (D) are as shown.

6.NOTICE: To avoid short circuit, make sure wires are not exposed.Fasten fixture green

or bare ground wire to the green or bare copper wire in outlet box with wire nut (A)

or fasten onto ground screw (N) on mounting plate. Fasten fixture white wires

together and then to the white wire in outlet box with wire nut (A). Wrap the wire

connector with electrical tape so that the tape seals the end of wire nut (A), see

diagram.

7.NOTICE: To avoid short circuit, make sure wires are not exposed.Fasten fixture black

wires to the black wire in outlet box with wire nut (A). Wrap the wire connector with

electrical tape so that the tape seals the end of wire nut (A), see diagram.

8.Tuck wires carefully inside outlet box. Let screws (D) protrude the hole on canopy (E).

Attach the canopy onto ceiling then secure it with nuts (F).

9.NOTICE: Do not exceed recommended wattage.Install lamp(s). Rated Max 40 W, Type B. (Bulb(s) not included).

10.Install the small (H) and medium-sized glasses (G) onto glass holder, with screws (I).

11.Restore power to circuit at breaker or fuse box.

CLEANING

Please clean fixture with a soft and dry cloth ONLY. Clean glass with a mild soap.

Phillips &

Flathead

Screwdriver

Slip Joint

Pliers

Small

Adjustable

Wrench

Wire

Cutter/stripper

Electrical

Current

Tester

Electrical

Tape

Allen

Wrench

Product specificaties