JL Audio C2-075ct Handleiding

JL Audio Speaker C2-075ct

Bekijk gratis de handleiding van JL Audio C2-075ct (5 pagina’s), behorend tot de categorie Speaker. Deze gids werd als nuttig beoordeeld door 14 mensen en kreeg gemiddeld 4.0 sterren uit 7.5 reviews. Heb je een vraag over JL Audio C2-075ct of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Download PDF

Pagina 1/5

OWNER’S MANUAL

Thank you for choosing a JL Audio Evolution™ C2 Component Tweeter

for your automotive sound system.

These Evolution™ Speakers have been designed and manufactured to

exacting standards in order to ensure years of musical enjoyment in your

vehicle. For maximum performance, we highly recommend that you have

your new speakers installed by an authorized JL Audio dealer. Your

authorized dealer has the training, expertise and installation equipment

to ensure optimum performance from this product. Should you

decide to install the speakers yourself, please take the time

to read this manual thoroughly so as to familiarize yourself

with its installation requirements and setup procedures.

If you have any questions regarding the instructions in this

manual or any aspect of your amplifier’s operation, please contact your

authorized JL Audio dealer for assistance. If you need further assistance,

please call the JL Audio Technical Support Department

at (954) 443-1100 during business hours.

0.75-inch (19 mm) Component Tweeters

2 | JL Audio - C5-075ct Owner’s Manual

C2-075ct SPECIFICATIONS

0.75 in. (19 mm) Silk Dome, Ferrofluid Cooling /

Damping, Neodymium Magnet

Continuous Power Handling: 60 Watts

Recommended Amp Power: 15-100 Watts / ch. (RMS)

Eff iciency: 91.0 dB @ 1W/1m | 91.5 dB @ 1W/0.5m

Sensitivity: 93.5 dB @ 2.83V/1m

Nominal Impedance: 8 ohm

Frequency Response: 4 kHz - 22 KHz ± 3 dB

Included Components and Parts:

• Two C2-075ct 0.75-inch (12 mm) Tweeters

• Two C2-075cthp In-Line, High-Pass Filters on

5.3 ft. (1.6 m) Wire Harnesses

• Two Metal Spring Clips (for tweeter flush mounting)

• Two Surface-Mount Tweeter Fixtures

• Four #6 x .85” (22 mm) Sheet Metal Screws

• Two 1/4-inch (6 mm) Machine Screws

GETTING STARTED

•Turnofftheaudiosystem.Itisalso

advisabletodisconnectthenegative

(–)terminalofyourvehicle’sbattery

wheneverperforminginstallationwork.

•Beforecutting,drillingorinsertinganyscrew,

checkclearancesonbothsidesoftheplanned

mountingsurface.Alsocheckforanypotential

obstacles,suchaswindowtracksandmotors,

wiringharnesses,etc.Checkbothsidesofthe

vehicle,manyvehiclesarenotsymmetrical!

•Alwayswearprotectiveeyewear.

Due to ongoing product development,

all specifications are subject to change without notice.

Tweeter Fixture Physical Dimensions Flush-Mount Surface-Mount

Fixture Outer Diameter (A) 1.75 in. / 44.5 mm 1.61 in. / 40.9 mm

Fixture Mounting Hole Diameter (B) 1.50 in. / 38.1 mm N/A

Fixture Mounting Depth (C) 0.56 in. / 14.2 mm N/A

Tweeter Frontal Protrusion (D) 0.36 in. / 9.1 mm 0.87 in. / 22.1 mm

4 | JL Audio - C5-075ct Owner’s Manual

BUILT-I N TWEETER PROTECTION CIRCUITRY

TheC2Crossovernetworksareequipped

withanadvancedelectronictweeterprotection

circuitdesignedtominimizethepossibilityof

tweeterfailure.Thiselectronicdevicemonitors

currentgoingtothetweeterandwilldisconnect

thetweeterfromthesignalwhenitsenses

overload.Shouldthisoccurwhilelisteningto

theaudiosystem,simplyreducethevolumefor

afewsecondsandtheprotectioncircuitwill

resetitselfautomatically.

TWEETER INSTALLATION

Thesetweetershavebeendesignedforsurface

orflushmounting.Beforechoosingamethod,

carefullyinspectthedesiredmountinglocation

todeterminewhichmethodwillworkbest.

Flush Mount:yieldsacustom-installed

appearance,butwillrequireatleast3/4-inch

(19mm)ofclearancebehindthemounting

surfaceofthetweeter.

Surface Mount:usesthesuppliedsurface

mountkitandhardwarerequiresthedrilling

ofthreeholes(oneforthewiresandtwoforthe

mountingscrews).Thisapplicationisuseful

whenmountingthetweeterstoapanelthathas

insufficientclearancebehinditforthetweeter’s

magnetstructure.

A R N I N G



Double check the clearance for both speakers

before proceeding. Many cars are different

from one side to the other!

Product specificaties

Merk:	JL Audio
Categorie:	Speaker
Model:	C2-075ct

Heb je hulp nodig?

Als je hulp nodig hebt met JL Audio C2-075ct stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Speaker JL Audio

JL Audio M3 Handleiding

3 April 2025

JL Audio C6-275cm Handleiding

7 Februari 2025

JL Audio CF-275mt Handleiding

8 April 2024

JL Audio C6-100ct Handleiding

8 April 2024

JL Audio C6-650 Handleiding

8 April 2024

JL Audio CF-350mt Handleiding

8 April 2024

JL Audio C6-650cw Handleiding

8 April 2024

JL Audio SA-TPOD-100-BK Handleiding

12 December 2023

JL Audio M6-100CT Handleiding

7 December 2023

JL Audio C1-690 Handleiding

12 Juni 2023

Handleiding Speaker

Nieuwste handleidingen voor Speaker

Valcom VIP-480AL-W-SA Handleiding

31 Juli 2025

Valcom VIP-410A-IC Handleiding

31 Juli 2025

Valcom FlexHorn VIP-581A Handleiding

31 Juli 2025

Valcom VIP-429A-A-SA Handleiding

31 Juli 2025

Valcom VIP-581A Handleiding

31 Juli 2025

Valcom InformaCast VIP-411A-IC Handleiding

31 Juli 2025

Valcom VIP-430A Handleiding

30 Juli 2025

Audac MBK622A Handleiding

30 Juli 2025

TW AUDiO M8 Handleiding

30 Juli 2025

Party Light & Sound PLUTON Handleiding

30 Juli 2025