JET A635 Handleiding
Pagina's 2 Niet gecategoriseerd
Bekijk de handleiding van JET A635 gratis online of download de PDF. Deze handleiding is 37 keer bekeken. Vraag over dit model? Stel een vraag
Assembly Instructions and Parts Breakdown
A635 Safety Shield
Assembly
To mount Safety Shield to your JET drill press or
milling machine, proceed as follows.
(Numbers in parentheses refer to index numbers in
Figure 1 and exploded view. Refer to exploded view
on reverse side if clarification is needed.)
1. If there are no existing mounting holes on your
machine, drill two threaded holes at least 1/2 in.
deep in left side of machine headstock. [If you
are using the provided M8 socket head screws
(#14), drill M8-1.25 holes.] Use bracket (#7) as
template for hole pattern.
NOTE: Make sure bracket location will allow
shield to clear front of headstock.
2. Install bracket assembly (#7) to headstock with
two M8X20 socket head screws (#14).
3. Install support arm (#11) and secure with hex
nut and spring washer (#12/13).
4. Install lower bracket bar (#9) and secure with
hex nut and flat washer.
5. Mount shield (#8) to lower bracket bar (#9)
using two socket head screws (#10) and flat
washers (#17).
6. Install limit switch (#18) if desired. (Wiring
connections must be made by qualified
electrician.)
Adjustments
Loosen lock handle (5) to adjust vertical positioning
of shield. Tighten lock handle before operating
machine.
Loosen knob (15) to adjust horizontal positioning of
shield. Tighten knob before operating machine.
Figure 1
JET
427 New Sanford Road
LaVergne, Tennessee 37086 Part No. M-A635
Ph.: 800-274-6848 Edition 1 12/2015
www.jettools.com Copyright © 2015 JET
Product specificaties
| Merk: | JET |
| Categorie: | Niet gecategoriseerd |
| Model: | A635 |
Heb je hulp nodig?
Als je hulp nodig hebt met JET A635 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden