Intermatic PF1222TB1 Handleiding

Bekijk gratis de handleiding van Intermatic PF1222TB1 (4 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 24 mensen en kreeg gemiddeld 5.0 sterren uit 2 reviews. Heb je een vraag over Intermatic PF1222TB1 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

MODEL: PF1222TB1 SUBPANEL

TWO CIRCUIT POOL EQUIPMENT CONTROL WITH FREEZE AND HEATER PROTECTION

IN INDOOR/OUTDOOR ENCLOSURE

PANEL RATING: 60 AMP. 120/240 VOLT, 607 HZ.

This Pool Equipment Control is designed to automatically operate the Filter Pump, Cleaner Pump and also to provide

freeze protection for the pool equipment. Nevertheless this product is not intended to be a substitute for insulation,

coverings, or maintenance.

THE FILTER PUMP TIME SWITCH is located in the upper

left side of the enclosure and operates the Filter Pump, as

set by the trippers on the yellow dial, on a 24 hour

schedule. For setting the schedule, refer to page 3 of this

Manual.

THE FIREMAN SWITCH (heater protection mechanism) is

located next to the manual lever and its function is to stop

the heating process 20 minutes before the Time Switch

turns OFF the Filter Pump. By doing so, the circulating

water cools the heat exchanger thus preventing excess

heat build-up.

THE CLEANER PUMP TIME SWITCH is located in the

upper right side of the enclosure and operates the Cleaner

Pump (Booster Pump). The trippers of this Time Switch

should be set so that the operation of the Cleaner Pump

falls within the operation of the Filter Pump. To avoid

equipment damage, the two Time Switches are interlocked

and the Cleaner Pump would not operate unless the Filter

Pump is already operating.

THE FREEZE PROTECTION THERMOSTAT is located in

the lower left side of the enclosure and turns ON the Filter

Pump when the air temperature (where the Control Panel

is located) drops below the temperature set by the dial

(between 33˚F and 42˚F).

INSTALLATION

OPERATION &

SERVICE MANUAL

PF1000 SERIES

FREEZE PROTECTION CONTROLS

Risk of drowning!

Do not permit unsupervised children to use pool or spa.

Close supervision of children required at all times.

DANGER

Turn power off at main panel before servicing this switch or the equipment it controls. This control panel must be

installed according to the National Electrical Code and local code requirements. Use MIN 75˚C Copper conductors ONLY.

Install interchangeable circuit breakers with an interrupting current rating of 10000 symmetrical amperes, or higher.

Follow manufacturers instructions for installing and testing of ground fault circuit breakers (GFCB) and interrupters

(GFCI). Install only LISTED receptacle(s) and/or wiring device(s) inside the enclosure. When panel is outdoors, a LISTED

rainproof cover must be installed over the wiring device in the side knockouts. This control should not be connected

to any equipment which would cause bodily injury or property damage should it be activated unexpectedly.

Reinstall safety guard after wiring.

WARNING

Risk of Fire or Electrical Shock

GENERAL INFORMATION

Product specificaties