Intermatic PA120 Handleiding

Bekijk gratis de handleiding van Intermatic PA120 (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.2 sterren uit 8 reviews. Heb je een vraag over Intermatic PA120 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

INSTALLATION INSTRUCTIONS

1. Disconnect ALL power from the Mini-Wave Control Panel.

2. Remove the Deadfront Cover from the panel.

3. Remove the Low-Voltage Divider to gain access to the Relay Screws. (See Figure 1-1)

4. Remove the filler plate on the Low Voltage Divider by bending the plate back and forth until

the plate breaks off. (See Figure 1-1).

5. Remove the two screws and install the Relay (PA120) with the same two screws. (See Figure 1-1).

6. Plug the 24VAC coil wires from the relay to any of the two available three-pin plugs on the upper

control board. (See Figure 1-2).

7. Re-install the Low Voltage Divider in your Mini-Wave Control Panel. (See Figure 1-1).

8. Re-install Deadfront.

9. When installation is complete, button <3> on the Hand-Held Remote and Membrane Pad will

operate the pump.

INSTALLATION

INSTRUCTIONS

MODEL: PA120

24 VAC BOOSTER / CLEANER PUMP RELAY

POOL/SPA CONTROL

ACCESSORIES

Low Voltage

Divider

Filler Plate

PA120

Relay

120 VAC

Coil

Relay

Screws

Low Voltage

Divider

Filler Plate

PA120

Relay

120 VAC

Coil

Relay

Screws

Button <3>Button <3>

Upper Control

Board

24VAC Coil

Wires

Lower Control

Board

Upper Control

Board

24VAC Coil

Wires

Lower Control

Board

Figure 1-1

Figure 1-2

Figure 1-3

Product specificaties