InSinkErator HWT-F1000S Handleiding
InSinkErator
Water dispenser
HWT-F1000S
Bekijk gratis de handleiding van InSinkErator HWT-F1000S (51 pagina’s), behorend tot de categorie Water dispenser. Deze gids werd als nuttig beoordeeld door 5 mensen en kreeg gemiddeld 4.9 sterren uit 3 reviews. Heb je een vraag over InSinkErator HWT-F1000S of wil je andere gebruikers van dit product iets vragen? Stel een vraag
Pagina 1/51
We are delighted that you have chosen the InSinkErator
®
Instant Hot Water Dispenser
to be a part of your home. This unique appliance will save you time and effort in the kitchen,
and you’ll enjoy discovering new uses for it each day. That’s exactly why millions of people are
now using an InSinkErator Instant Hot Water Dispenser.
We are confident that by following our step-by-step instructions, you’ll soon be enjoying the
convenience of instant hot water.
For your satisfaction and safety, read all instructions, cautions and warnings before installing or using this instant
hot water dispenser.
This particular unit is not intended for commercial use.
Make sure that all electrical wiring and connections conform to local codes.
A standard 115-volt grounded electrical outlet is required under the sink for the dispenser’s electrical power.
The wall outlet powering your dispenser must have power supplied to it continuously.
This outlet must be fused and should not be controlled by the same wall switch that operates the disposer, unless
you have a SinkTop Switch
™
from InSinkErator
®
.
It is recommended that a dedicated control valve be installed on the cold water line supplying water to this system.
If you suspect elevated levels of chlorine in your water, or your water has a rusty appearance before the installation
of this unit, it is recommended to use our water filtration system.
This product contains stainless steel. The manufacturer cannot guarantee against rusty water because of the
number of factors that are involved beyond the manufacturer’s control. However, the sudden appearance of rusty
water discharged from the hot water dispenser may indicate the need for service or replacement of this product.
The use of a water filter should NOT result in the water pressure to drop below 30 psi (207kPa). If it does, this will
prevent your unit from operating properly.
Moving parts inside the tank causing a rattling noise is normal.
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
n Phillips and flat blade screwdrivers
n Pencil
n Tape measure
n Level
Equipment You May Need:
Equipment Required:
n Drill
n T-fitting
n Dedicated control valve
n Adjustable wrench
n Philips Screw Driver
n Pencil
n Tape Measure
Anchors for drywall
Hole saw
Basin wrench
Hole punch
If you intend to use the sprayer hole in your sink for your dispenser, you may need a basin wrench and a
1/8" plug or a 1/4" cap (not supplied) for the faucet spray hose line. See Step 1B.
If you need to cut a mounting hole in your stainless steel sink, you may need a 1
1
⁄4" - 1
1
⁄2" hole saw made
for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface other
than stainless steel.
WHAT YOU NEED TO GET STARTED
2
Product specificaties
| Merk: | InSinkErator |
| Categorie: | Water dispenser |
| Model: | HWT-F1000S |
Heb je hulp nodig?
Als je hulp nodig hebt met InSinkErator HWT-F1000S stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Water dispenser InSinkErator
29 Maart 2025
29 Maart 2025
29 Maart 2025
22 Juni 2023
Handleiding Water dispenser
- Fetco
- Primo
- Tiger
- Morphy Richards
- Cal-Mil
- Bartscher
- Electrolux
- Emerio
- Crathco
- Arcelik
- Caso
- Avalon
- Aarke
- Oasis
- Hoshizaki
Nieuwste handleidingen voor Water dispenser
7 Juli 2025
17 Juni 2025
16 Juni 2025
10 Juni 2025
10 Juni 2025
10 Juni 2025
9 Juni 2025
25 Mei 2025
25 Mei 2025
25 Mei 2025