Icom IC-78 Handleiding

Icom Receiver IC-78

Lees hieronder de 📖 handleiding in het Nederlandse voor Icom IC-78 (48 pagina's) in de categorie Receiver. Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/48
INSTRUCTION MANUAL
HF TRANSCEIVER
i78
This device complies with Part 15 of the FCC rules. Operation is sub-
ject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
IMPORTANT
READ THIS INSTRUCTION MANUAL
CAREFULLY before attempting to operate the
transceiver.
SAVE THIS INSTRUCTION MANUAL. This
manual contains important safety and operating in-
structions for the IC-78.
EXPLICIT DEFINITIONS
i
PRECAUTIONS
RWARNING HIGH VOLTAGE! NEVER at-
tach an antenna or internal antenna connector during
transmission. This may result in an electric shock or
burn.
RNEVER apply AC to the [DC13.8V] jack on the
transceiver rear panel. This could cause a fire or ruin
the transceiver.
RNEVER apply more than 16 V DC, such as a 24 V
battery, to the [DC13.8V] jack on the transceiver rear
panel. This could cause a fire or ruin the transceiver.
RNEVER let metal, wire or other objects touch any
internal part or connectors on the rear panel of the
transceiver. This may result in an electric shock.
NEVER expose the transceiver to rain, snow or any
liquids.
AVOID using or placing the transceiver in areas with
temperatures below –1C (+14°F) or above +60°C
(+140°F). Be aware that temperatures on a vehicle’s
dashboard can exceed 80°C (+176°F), resulting in per-
manent damage to the transceiver if left there for ex-
tended periods.
AVOID placing the transceiver in excessively dusty en-
vironments or in direct sunlight.
AVOID placing the transceiver against walls or putting
anything on top of the transceiver. This will obstruct
heat dissipation.
During mobile operation, operate the trans-DO NOT
ceiver without running the vehicle’s engine. When the
transceiver power is ON and your vehicle’s engine is
OFF, the vehicles battery will soon become ex-
hausted.
Make sure the transceiver power is OFF before start-
ing the vehicle. This will avoid possible damage to the
transceiver by ignition voltage spikes.
During maritime mobile operation, keep the transceiver
and microphone as far away as possible from the mag-
netic navigation compass to prevent erroneous indica-
tions.
BE CAREFUL! The heatsink will become hot when op-
erating the transceiver continuously for long periods.
BE CAREFUL! If a linear amplifier is connected, set
the transceiver’s RF output power to less than the lin-
ear amplifier’s maximum input level, otherwise, the lin-
ear amplifier will be damaged.
Use Icom microphones only (supplied or optional).
Other manufacturer’s microphones have different pin
assignments, and connection to the IC-78 may dam-
age the transceiver.
WORD DEFINITION
RWARNING Personal injury, fire hazard or electric
shock may occur.
CAUTION Equipment damage may occur.
NOTE Inconvenience only. No risk of per of
personal injury, fire or electric shock.
1
1
TABLE OF CONTENTS
q
w
e r
IMPORTANT .............................................................. i
EXPLICIT DEFINITIONS ........................................... i
PRECAUTIONS ........................................................ i
1 TABLE OF CONTENTS ....................................... 1
SUPPLIED ACCESSORIES ..................................... 1
2 PANEL DESCRIPTION ................................... 2 7
Front panel ....................................................... 2
Function display ............................................... 4
Rear panel ........................................................ 5
Microphone (HM-36) ........................................ 7
3 INSTALLATION AND CONNECTIONS ......... 8 12
Unpacking ........................................................ 8
Selecting a location .......................................... 8
Grounding ......................................................... 8
Antenna connection .......................................... 8
Required connections ....................................... 9
Power supply connections .............................. 10
Advanced connections .................................... 11
External antenna tuners ................................. 12
4 OPERATION ................................................. 1327
Selecting a channel ......................................... 13
Frequency indication ....................................... 14
Lock function ................................................... 14
Scan function................................................... 14
Basic voice receive and transmit..................... 15
Mode selection ................................................ 15
RF gain and Squelch....................................... 15
Functions for transmit...................................... 16
Functions for receive ....................................... 19
Filter selection ................................................. 21
Filter setting..................................................... 22
Functions for CW............................................. 23
Functions for RTTY ......................................... 25
Channel comment programming ..................... 27
5 SET MODE ................................................... 2833
General............................................................ 28
Quick set mode items...................................... 29
Initial set mode items....................................... 31
6 EXTRA FEATURES...................................... 34–36
Instruction........................................................ 34
VFO operation ................................................. 34
2-Tone alarm operation ................................... 36
7 INSTALLATION AND CONNECTIONS ........ 37–38
Opening the transceivers case ...................... 37
Optional bracket and carrying handle.............. 37
CR-338 HIGH STABILITY CRYSTAL UNIT ......... 38
Optional IF filters ............................................ 38
8 MAINTENANCE ........................................... 39–40
Troubleshooting .............................................. 39
Fuse replacement ........................................... 40
Resetting the CPU .......................................... 40
9 REMOTE JACK INFORMATION.................. 41–42
CI-V remote control ......................................... 41
Data cloning between transceivers ................. 42
10 SPECIFICATIONS ........................................... 43
12 OPTIONS .................................................. 44– 45
SUPPLIED ACCESSORIES
The transceiver comes with the following accessories.
Qty.
qDC power cable .................................................... 1
wHand microphone (HM-36) .................................. 1
eFuse (FGB 20 A; for DC cable) ............................ 1
rFuse (FGB 4 A; internal use) ............................... 1


Product specificaties

Merk: Icom
Categorie: Receiver
Model: IC-78

Heb je hulp nodig?

Als je hulp nodig hebt met Icom IC-78 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Receiver Icom

Handleiding Receiver

Nieuwste handleidingen voor Receiver