Honeywell T827K1017/U Handleiding

Honeywell Thermostaat T827K1017/U

Lees hieronder de 📖 handleiding in het Nederlandse voor Honeywell T827K1017/U (16 pagina's) in de categorie Thermostaat. Deze handleiding was nuttig voor 44 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16
Owner’s Manual
English: Page 1
Mode d’emploi
Français : Page 6
Manual de Uso
EspaĂąol: PĂĄgina 11
T834 Series
Thermostat
69-1944EFS-01
M37978
Check package contents:
• Thermostat
• Wall anchors & screws (2 each)
Before you begin, make sure you have:
• No. 2 Phillips & small pocket screw-
drivers
• Hammer
• Level (optional)
• Pencil
• Drill and bit (3/16” for drywall, 7/32” for
plaster)
Pre-installation checklist
This manual covers the following models:
Horizontal Mount: • Vertical Mount: T8034N T834N/T834L
Must be installed by a trained, experienced technician
Read these instructions carefully. Failure to follow these instructions
can damage the product or cause a hazardous condition.
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before
beginning installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not
place the old control in the trash. Contact your local waste management authority for
instructions regarding recycling and proper disposal.
T834 Series
69-1944EFS—01 2
System Types
• Gas, oil, or electric heat with air
conditioning
• Warm air, hot water, high-efficiency
furnaces, heat pumps, steam, gravity
• Heat only
• Heat only with fan
• Cool only
System Settings
• Heat, Off, Cool (T834N)
• Off, Cool (T834L)
Fan Settings
• Auto, On
Product application
This thermostat provides control of 24 Vac single-stage heating and cooling systems.
Electrical Ratings
Terminal Voltage (50/60Hz) Running Current
W Heating 2030 Vac 0.021.2 A
Y Cooling 2030 Vac 0.021.2 A
G Fan 2030 Vac 0.020.6 A
O Cooling Changeover 2030 Vac 0.020.5 A
B Heating Changeover 2030 Vac 0.020.5 A
Specifications
Temperature Range
• 50° to 90°F (10° to 32°C)
Operating Ambient Temperature
• 0° to 120°F (18° to 49°C)
Operating Relative Humidity
• 5% to 90% (non-condensing)
Dimensions (vertical model)
• 2.88W x 4.75H x 1.5D (inches)
• 73W x 121H x 38D (mm)
Dimensions (horizontal model)
• 4.75W x 2.88H x 1.5D (inches)
• 121W x 73H x 38D (mm)
English: Français : Español: Page 1 • Page 6 • Página 11
3 69-1944EFS—01
MCR37992
UP
VERT.
UP
HORIZ.
R
Rc
G
W
E
F
Y
0
UPHORIZ.
1. Pull wires through wire hole.
Position base on wall, level
and mark hole positions.
2. Drill holes (3/16” holes for
drywall, 7/32” holes for plas-
ter), then tap in supplied wall
anchors.
3. Pull wires through base, posi-
tion over anchors, and insert
screws. Check level if desired,
then tighten screws.
Base installation
1. Loosen screw terminals, insert bare wires
beneath screws, then re-tighten screws.
2. Push any excess wire back into the wall opening.
3. Plug the wall opening with nonflammable
insulation to prevent drafts from affecting
thermostat operation.
Terminal Designations
R Heating power. Connect to secondary
side of heating system transformer.
Rc Cooling power. Connect to secondary
side of cooling system transformer.**
G Fan relay.
W Heat relay.**
B Heat pump changeover valve energized in
heating.
O Heat pump changeover valve energized in
cooling.
Y Compressor contactor.
**Not present in the T834L model.
Wiring
NOTES
R & Rc Terminals
In single-transformer system, leave
metal jumper in place between R
& Rc. Remove metal jumper if two-
transformer system.
Heat pump systems
If wiring to a heat pump, use a small
piece of wire (not supplied) to connect
terminals .W and Y
Wire Specifications
Use 18-gauge thermostat wire. Shielded
wire is not required.


Product specificaties

Merk: Honeywell
Categorie: Thermostaat
Model: T827K1017/U

Heb je hulp nodig?

Als je hulp nodig hebt met Honeywell T827K1017/U stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Thermostaat Honeywell

Handleiding Thermostaat

Nieuwste handleidingen voor Thermostaat