Honeywell 5804BD Handleiding

Bekijk gratis de handleiding van Honeywell 5804BD (2 pagina’s), behorend tot de categorie Controller. Deze gids werd als nuttig beoordeeld door 13 mensen en kreeg gemiddeld 4.3 sterren uit 5 reviews. Heb je een vraag over Honeywell 5804BD of wil je andere gebruikers van dit product iets vragen? Stel een vraag

N8547V1 04/09

5804BD

TWO-WAY WIRELESS KEY

USER GUIDE

About 5804BD

5804BD is a four-button remote control for your alarm system. 5804BD can send a command to the alarm system,

such as to arm or disarm, as well as receive system status. Two LEDs and a speaker are used to indicate system

status. 5804BD is typically used for arming, disarming, and controlling devices. Check with your installer to

understand which functions the buttons have been assigned on your unit.

Operating the Buttons

Activating a Button

To activate a function, press and hold the appropriate button down until the yellow LED flashes (2 beeps will be

heard), and then release it.

NOTE: Transmission will not be successful if the key is not within range of the system’s receiver. If 5804BD does

not receive system status from the panel for approximately five seconds, it will generate a long (one second) beep.

Requesting System Status

You can check system status before arming or disarming your system.

Check the system status by momentarily pressing and releasing any button. The yellow LED will flash after you

release the button (one beep will be heard). After a second or two, the device will display the system status

through the LEDs and speaker (see the System Status Indications Table, below). If 5804BD does not receive

system status from the panel for approximately five seconds, it will generate a long (one second) beep and shut

itself down. It will also shut itself down if you do not press a button within five seconds of receiving a status update.

System Status Indications Table

LED LED Condition Sounds System Status

On Steady 2 Beeps Armed Away or Maximum

On Steady 3 Beeps Armed Stay or Instant

Flashing Pulsing Fire Alarm in progress

Flashing Steady Armed, Burglary Alarm in progress

Red

Flashing Silent Alarm Memory

Yellow (right) Flashing Silent Indicates RF transmission

Red & Green Alternately Flashing Silent In Enter House ID Mode

On Steady 1 Beep Disarmed, Ready to Arm

Flashing Silent Disarmed, Not Ready to Arm

Flashing Pulsing System in Trouble Condition

Green

Flashing 1 Beep System Not Ready

Multiple Button Operations

The 5804BD can generate the same responses as

keypad key pairs of [*] + [#] and [*] + [1] by

depressing “A” + “C” and “B” + “D”

button pairs,

respectively.

You must depress the button pair for

at least 2 seconds for the 5804BD to reco

gnize the

button pair command. These button pairs

allow you

to activate additional keypad functions

depending

on control panel programming. Check with

your

installer to understand which functions the buttons

have been assigned on your unit.

Product specificaties