Homedics Modulair Calf Wrap SR-CMC10H Handleiding
Pagina's 160 Massage apparaat
Bekijk de handleiding van Homedics Modulair Calf Wrap SR-CMC10H gratis online of download de PDF. Deze handleiding is 1 keer bekeken. Vraag over dit model? Stel een vraag

Modulair™ compression
complete compression system
3 YEAR GUARANTEE
hand wrap
calf wrap
knee wrap
foot wrap
universal controller
SR-CM10 Series

PRODUCT FEATURES:
The modulair™ Controller Module is equipped with our intelligent SMRTex
chip. This technology gives our controller module the ability to detect which
modulair™ compression wrap it’s docked into and perform the programmes
specic to that wrap. This allows you to add on to your system and build a
compression regimen that ts your needs, all while doing it with the same
battery module.
A / POWER q - To turn the massager on/o,
press the power button. The ring around the
power button will illuminate white to indicate
that the unit is on.
NOTE: The massager will begin on mode A and
60% intensity with no heat.
B / BATTERY INDICATOR - The colour
indicates the battery level remaining.
• Solid White: 40% - 100% Charge
• Solid Red: 20 - 40% Charge
• Flashing Red: ≤20% Charge
C / HEAT INDICATOR - The colour
indicates the intensity of the heat selected.
• Green: Low
• Blue: Medium
• Purple: High
D / HEAT BUTTON - To select between
three levels of heat therapy (Low, Medium, and
High), press the heat button to reach the
desiredlevel.
E / INTENSITY - Press the intensity
button to select your preferred level of pressure.
The intensity level is indicated on the LED screen
to the left of the button.
• 20%
• 40%
• 60%
• 80%
• 100%
F / MODE BUTTON - Press the mode
button to select between the four massage
modes. The mode is indicated on the LED screen
directly above the button.
• (A) Alternating
• (B) Full
• (C) Sequential
• (D) Pulsing
A
B
C
FED
GB I 2

INSTRUCTIONS FOR USE:
Congratulations on your purchase of a Homedics modulair™ product. Modulair™
is the rst pneumatic compression system that allows you to customize your
experience by oering compression wraps and products for all parts of the body
all using the same controller module for complete exibility. To start using your
modulair™ system, you’ll need at least one modulair™ controller module
(ModelSR-CMX10) and at least one modulair™ compression wrap.
1. Your modulair™ compression system uses a modulair
controller module (SRCMX10). To start, when opened, your
controller module may require charging. To charge the
battery, plug one end of the USB cord into the unit and plug
the other end into an adapter. Your controller module will
be fully charged after a maximum of 5 hours charge time,
and the charge will last up to 5 hours.
NOTE:This device only comes with a USB cord, not an
adapter. A USB charger will also charge the units. Do not
attempt to use a cord that is not a USB-type cord. Use only
with Listed/Certied ITE Power Supply. The units will not
operate when charging. Use a 5V/2A (or 5V/1A, slower)
charger, but not higher than 5V.
2. Your compression wrap can be used on either the left or rightside.
3. Use the fastening tape to adjust the wrap so it’s snug but comfortable. Do
not overtighten.
4. Connect your controller module to the compression wrap, sliding it into the
dock until it “clicks” into place. See image to the right.
5. Press the power button to turn on the unit. The display will illuminate to
conrm the unit is on.
6. Press the “MODE” button to select between the 4 massage modes. Press the
“HEAT” button to toggle between 3 levels of heat. Press the “INTENSITY”
button to adjust the intensity of the air compression.
7. The unit will turn o automatically after 15 minutes.
CAUTION: To avoid injury, always remain seated when using massager.
GB I 3
Product specificaties
| Merk: | Homedics |
| Categorie: | Massage apparaat |
| Model: | Modulair Calf Wrap SR-CMC10H |
Heb je hulp nodig?
Als je hulp nodig hebt met Homedics Modulair Calf Wrap SR-CMC10H stel dan hieronder een vraag en andere gebruikers zullen je antwoorden