Fluke 700LTP-1 Handleiding

Bekijk gratis de handleiding van Fluke 700LTP-1 (1 pagina’s), behorend tot de categorie Pomp. Deze gids werd als nuttig beoordeeld door 15 mensen en kreeg gemiddeld 4.9 sterren uit 2 reviews. Heb je een vraag over Fluke 700LTP-1 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

®

PN 2811813 April 2007 © 2007 Fluke Corporation. All rights reserved. Printed in U.S.A. 1

Fluke-700LTP-1

Low-Pressure Test Pump

Instruction Sheet

Introduction

The Fluke-700LTP-1 Low-Pressure Test Pump is a

portable, dual source of vacuum and pressure. Each pump

incorporates a vacuum and pressure selector and fine

adjustment control. The pump has the following

specifications:

•Output pressure: 0 to 100 psi / 0 to 6.9 bar

•Output vacuum: 0 to -13 psi / 0 to -900 mbar

•Exposed Materials: Aluminum, silicon, neoprene,

stainless steel, Buna-N

•Adjustment: Fine volumetric pressure and vacuum

adjuster

•Dimensions: 150 mm x 100 mm

•Weight: 226 grams or .5 lbs (pump only)

Box Contents

•Fluke 700LTP-1 Low-pressure Test Pump

•1/8 in NPT male/female tee

•(2) 1 m hoses

•(4) 1/8 in NPT male quick connects

•(2) 1/8 NPT female to 1/4 in BSP female

•Seal Kit

•Instruction Sheet

Contacting Fluke

To contact Fluke or for service, call one of the following

telephone numbers:

USA: 1-888-44-FLUKE (1-888-443-5853)

Canada: 1-800-36-FLUKE (1-800-363-5853)

Europe: +31 402-675-200

Japan: +81-3-3434-0181

Singapore: +65-738-5655

Anywhere in the world: +1-425-446-5500

Or, visit Fluke's Web site at www.fluke.com.

1

2

8

3

5

6

7

4

eus01f.eps

A

Pressure/vacuum release valve- Turn valve counter-

clockwise for vacuum, clockwise for pressure and

centered for release.

BFine adjustment control- Turn in or out to increase or

decrease pressure accordingly.

CMaster and test port tee

DQuick-fit connectors

EHose

F1/8 in NPT female to 1/4 in BSP female fitting

G

Pump Handle. If the pump has not been used for a

while, there may be some resistance on the first

stroke.

HCleanout ports (2)- See cleanout instructions

Figure 1. Features

Guidelines for Use

1.Connect a pressure calibrator or pressure module to

the quick-fit connector (item D) at the end of one of the

flexible hoses (item E).

2.Connect the unit under test to the quick-fit connector

(item D) at the end of the second flexible hose (item

E F), choosing correct adapters (item ) and seals.

3.Turn the fine adjustment control to mid-range.

4.Set control valve to pressure.

5.Operate handle (item G) until the pressure is close to

the required value.

Product specificaties