Fibaro FGWPG-111 Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor Fibaro FGWPG-111 (22 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 38 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/22
CONTENTS
#1: Description and features 3
#2: Basic activation 4
#3: Adding the device 5
#4: Removing the device 6
#5: Operating the device 7
#6: Power and energy consumption 9
#7: Association 10
#8: Z-Wave range test 11
#9: Z-Wave specication 12
#10: Advanced parameters 15
#11: Specications 21
#12: Regulations 22
FIBARO WALL PLUG
Type G with USB charger
FGWPG-121
O P E R A T I N G
M A N U A L EN
v1.0
2
Important safety information
Read this manual before attempting to install the device!
Failure to observe recommendations included in this manual
may be dangerous or cause a violation of the law. The manufacturer,
Fibar Group S.A. will not be held responsible for any loss or damage
resulting from not following the instructions of operating manual.
!
This product is intended for indoor use only in dry locations.
Do not use in damp or wet locations, near a bathtub, sink,
shower, swimming pool, or anywhere else where water or moisture
are present.
!
Caution!
To avoid risk of electrical shock, do not operate the device with
wet or moist hands.
!
This product is not a toy. Keep away from children and animals!
General information about
the FIBARO System
FIBARO is a wireless smart home automation system, based on the
Z-Wave protocol. All of available devices can be controlled through
a computer (PC or Mac), smartphone or tablet. Z-Wave devices are
not only receivers, but can also repeat the signal, increasing the
Z-Wave network’s range. It gives advantage over traditional wireless
systems that require direct link between transmitter and receiver, as
a result the construction of the building could aect network’s range
negatively.
Every Z-Wave network has its unique identication number (home
ID). Multiple independent networks can exist in the building without
interfering. Transmission security of FIBARO System is comparable to
wired systems.
Z-Wave technology is the leading solution in smart home automation.
There is a wide range of Z-Wave devices that are mutually
compatible, independently of manufacturer. It gives the system the
ability to evolve and expand over time. For more information visit:
www.baro.com.
Do not dismantle the device!
3
DESCRIPTION AND FEATURES
Main features of FIBARO Wall Plug:
• Compatible with type G sockets and plugs.
• Compatible with any Z-Wave or Z-Wave Plus Controller.
• Supports Z-Wave network Security Modes: S0 with AES-128
encryption and S2 Authenticated with PRNG-based encryption.
• Extremely easy installation - simply plug the device into the mains
socket.
• Equipped with USB charging port.
• Works as a Z-Wave signal repeater.
• Active power and energy consumption metering for plugged device
and the USB port.
• Current value of the load and operating mode are indicated by the
multi-colour LED frame.
FIBARO Wall Plug is a remotely controlled plug-in switch with the
ability to measure power and energy consumption.
It uses a LED frame to visualize the current load and operating mode
with colour changing illumination.
Our smart plug makes it possible to control electrical devices in a
convenient and maintenance-free way.
It is also equipped with a USB charging port with power metering.
#1: Description and features
FIBARO Wall Plug is a fully
compatible Z-Wave Plus device.
NOTE
This device may be
used with all devices
certied with Z-Wave
Plus certicate and
should be compatible
with such devices pro-
duced by other manu-
facturers.
i
NOTE
Z-Wave Controller
must support Z-Wave
Security Mode in or-
der to fully utilize the
product.
i


Product specificaties

Merk: Fibaro
Categorie: Niet gecategoriseerd
Model: FGWPG-111
Kleur van het product: Wit
Breedte: 56 mm
Diepte: 58.5 mm
Hoogte: 56 mm
Type stekker: Type G
Maximaal ingangsvermogen: 750 W
Ondersteuning voor plaatsing: Binnen
Connectiviteitstechnologie: Draadloos
Frequentiebereik: 0.8684 - 0.8698 GHz
Beschermingsklasse: I
Draadloze technologie: Z-Wave
Maximum indoorbereik: 40 m
Maximum outdoorbereik: 50 m
AC-ingangsspanning: 230 V
AC-ingangsfrequentie: 50/60 Hz
Bedrijfstemperatuur (T-T): 0 - 40 °C
Stroom (max.): 80 A

Heb je hulp nodig?

Als je hulp nodig hebt met Fibaro FGWPG-111 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Niet gecategoriseerd Fibaro

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd