Extron SMP 401 Handleiding

Bekijk gratis de handleiding van Extron SMP 401 (4 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 30 mensen en kreeg gemiddeld 4.6 sterren uit 7 reviews. Heb je een vraag over Extron SMP 401 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

1

SMK F SF 10C Plus Kit • Setup Guide

This guide provides instructions for an experienced installer to install the Extron SMK F SF 10C Plus

oor mount kit for the SF 10C SUB subwoofer. The SMK F SF 10C Plus kit consists of four long legs

for mounting the speaker vertically, and four short legs for mounting the speaker horizontally. Each

kit includes 12 screws and locking nuts, and 24 washers.

NOTE:See the or for detailed instructions regarding the SF 10C SUB subwoofer.SF 10C SUB User Guide SF 10C SUB Setup Guide

ATTENTION:

• The SF 10C SUB must have rebreaks installed in the wall, above and below it, when it is protruding through a wall, to meet UL

requirements.

• Le SF 10C SUB doit disposer de systèmes coupe-feu installés au mur, au-dessus et au-dessous de l’unité, lorsqu’elle est placée

en saillie du mur, an de satisfaire les exigences de l’UL.

• The subwoofer must be securely fastened to the stud or other stationary surface when mounted in one of the vertical positions.

• Le caisson de grave doit être solidement xé au montant ou à une autre surface stationnaire lorsqu’il est monté dans l’une des

positions verticales.

NOTES:

• Remember that the sound from the unit is directed out the port. Therefore, the port needs to be pointed into the listening space.

• To ensure that the Extron grille ts fully into any masking wall or other partition, the center of the port tube must be at least

5-3/16 inches (132 mm) from the edge of the wall.

• The grille does not t if you install the legs on the subwoofer with the port tube down. Consider fabricating a small platform to lift

the subwoofer (see on the next page), or otherwise design your own way to dress your installation to give it a nished figure 2

look.

• Steps 3, 4, 5, and 8 are necessary only if you are installing the subwoofer in an adjoining space.

Installing Long Legs for Vertical Installation

The subwoofer can be set vertically on a oor using the included long legs as follows:

1. Determine where the subwoofer is to be placed and its orientation (port tube on top or port tube on the bottom).

2. Remove the grommets from the holes in the installation bracket.

3. Fasten two legs to each installation bracket using the three provided screws and locking nuts, two on one side of the foot (see

figure 1, 1) and one on the other side (2).

1221

Figure 1. Long Leg Installation

IMPORTANT:

Go to www.extron.com for the complete

user guide, installation instructions, and

specifications before connecting the

product to the power source.

Product specificaties