EtherWAN EL2242-BT Handleiding

Bekijk gratis de handleiding van EtherWAN EL2242-BT (2 pagina’s), behorend tot de categorie Audio/video-converter. Deze gids werd als nuttig beoordeeld door 55 mensen en kreeg gemiddeld 4.0 sterren uit 5 reviews. Heb je een vraag over EtherWAN EL2242-BT of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Copyright 2021 EtherWAN Systems, Inc. Page 1

All Rights Reserved

EL2242-BT

7/15/2021

EL2242-BT Hardened PoE Media Converter

Installation Guide

1 Unpacking

Unpack the items. Your package should include:

➢One EL2242-BT PoE Media Converter

➢Power input terminal block

➢Wall and DIN-Rail mounting hardware

brackets

If items are missing or damaged, notify your

EtherWAN representative. Keep the carton and

packing material.

More information available at:

https://www.etherwan.com/us

For warranty information, visit:

https://www.etherwan.com/us/support/warrant

y-policy

2 Equipment Needed

➢Category 5e or better cable for RJ-45 port

➢SFP Module

➢Single Mode/Multimode Fiber Cable

➢Power supply with supplied voltage within

specified range of 52 to 56VDC

3 Select a Location

➢DIN-rail installations: Attach the bracket on

the unit using the included screws and then

mount on a DIN-rail.

➢Wall installations: Attach the brackets on the

unit using the included screws and then

mount on a wall.

➢Identify a power source within 6 feet (1.8

meters).

➢Choose a dry area with ambient temperature

between -40 and 75ºC (-40 and 167ºF).

➢Keep away from heat sources, sunlight, warm

air exhausts, hot-air vents, and heaters.

➢Make sure there is adequate airflow.

4 Connect to the Ports

The EL2242-BT has the following ports:

➢1 10/100/1000 Mbps copper port

➢1 dedicated 100/1000 SFP slot

10/100/1000BASE-T Port

Port can be connected to a switch, a router or a

PoE device (PD).

SFP Slot

100/1000BASE SFP slot.

5 Connect Power

Terminal Block

Connect the unit to a suitable power supply using

appropriate wire, 18-24AWG, rated for 105°C or

higher.

Redundant power is supported. However, only

one power input is required to operate the unit.

1.Connect power wires to the appropriate

V1+/- or V2+/- pins on the terminal

block.

2.Connect the grounding wire to the ground

screw.

3.Plug the terminal block into the socket.

6 Front Panel LEDs

LED Panel Layout

LED

Color

Status

Power

1 & 2

Green

ON = power detected

OFF = power not detected

PoE

Amber

ON = PDis detected

Off = No PD detected

RJ-45

Link/Act

Green

ON – TX port is detected

FLASHING –TX data is

transmitting

SFP

Link/Act

Green

ON – FX port is detected

FLASHING – FX data is

transmitting/receiving

Product specificaties