EMOS P3534 Handleiding

EMOS Lamp P3534

Lees hieronder de 📖 handleiding in het Nederlandse voor EMOS P3534 (25 pagina's) in de categorie Lamp. Deze handleiding was nuttig voor 42 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/25
1441250920_31-P3534 105 × 130 mm
www.emos.eu
P3534
GB
Rechargeable LED CREE Headlight with IR Sensor
CZ
Nabíjecí LED CREE čelovka sIR sensorem
SK
Nabíjacia LED CREE čelovka sIR senzorom
PL
Akumulatorowa latarka czołowa LED CREE zczujnikiem podczerwieni
HU
Újratölthető CREE LED-es fejlámpa infravörös érzékelővel
SI
Polnilna LED CREE naglavna svetilka ssenzorjem IR
RS|HR|BA|ME
Naglavna svjetiljka LED CREE smogućnošću ponovnog punjenja iinfracrvenim senzorom
DE
Auadbare CREE-LED-Stirnlampe mit IR-sensor
UA
Зарядний світлодіодний CREE лобовий ліхтарик з IR датчиком
RO
LED CREE lanternă frontală reîncărcabilă cu sensor IR
LT
Įkraunamas LED CREE prožektorius ant galvos su IR jutikliu
LV
Laaditav LED CREE pealamp infrapunaanduriga
EE
Įkraunamas LED CREE prožektorius ant galvos su IR jutikliu
BG
Презареждащ светодиоден фенер за глава CREE с инфрачервен датчик
12
4 3 5 4
2
GB | Rechargeable LED CREE Headlight with IR Sensor
Characteristics
The headlight’s light source is apowerful CREE LED chip. The headlight has abuilt-in Li-Pol accumulator which can be recharged through
acable with micro-USB connector. The low weight and small size of the lamp make it ideal for outdoor activities as well as other occasions
where you need apowerful yet compact light source.
Technical Specications
Light source: 1× white CREE LED 5 W
Power supply: Li-Pol 1 200 mAh
Modes: 100 %, 50 %, 20 %, o + SOS ashing
Range: 75 m
Light duration: 3 hours
Max. luminous ux: 230 lm
Dimensions: 61 × 31 × 33 mm
Weight: 60 g
Description of Control Elements and Parts
1 – Manual on/o button
2 – Button for turning IR sensor on/o
3 – CREE LED 5 W
4 – IR sensor
5 – Micro USB connector cover
Turning the Headlight on Manually
1. Pressing button 1 on the top turns on the headlight – the CREE LED will glow at 100 % power.
2. Press button 1 on the top of the headlight again – the CREE LED will glow at 50 % power.
3. Press button 1 on the top of the headlight again – the CREE LED will glow at 20 % power.
4. Pressing button 1 on the top again turns o the headlight.
Manually Turning on SOS Signal
1. Hold down button 1 on the top of the headlight for 2 s – the CREE LED will ash SOS signal.
2. Pressing button 1 on the top again turns o the headlight.
Turning on the Headlight Contactlessly via IR Sensor
1. Pressing button 2 on the top of the headlight turns on the IR sensor.
2. The lamp will turn on once the IR sensor is activated.
3. Moving your hand in front of the spotlight will turn o the lamp.
4. Pressing button 2 on the top of the headlight turns o the IR sensor.
5. The IR sensor can also be activated while manual mode is on by pressing button 2. The IR sensor does not work with black rubber materials.
Charging the Accumulator
The lamp's accumulator must be charged before rst use.
Charge the lamp in dry indoor areas at atemperature of +5 °C to +45 °C.
If the lamp is not used for an extended period of time, it is necessary to recharge the accumulator before further use. The accumulator
self-discharges and must be recharged at least once every 3 months to prevent its voltage from dropping and the accumulator potentially
being rendered unusable.
Charging procedure:
1. Turn the rubber blank on the lamp body until the power connector is visible and connect the power cable.
2. The lamp body will glow red while charging. Once the lamp (accumulator) is fully charged, it will glow green.
3. After fully charging, remove the power cable and turn the rubber blank on the lamp so that water, humidity or dust cannot enter
into the head lamp.
Warning
When new, the lamp must rst be charged before use.
3
The lamp's accumulator must be kept charged to prevent the voltage from dropping below the threshold level. Therefore, it is recommend-
ed to recharge the lamp at least once every 3 months even when it is not being used. Temperature for lamp charging +5 °C to +45 °C.
If the lamp does not glow or the light is weak, immediately recharge.
If the accumulator is damaged or destroyed due to non-observance of the above rules, complaints led within the warranty period
regarding the lamp (accumulator) will not be accepted.
Recharge the head lamp in dry indoor areas.
Do not throw the head lamp or the accumulator into are and do not disassemble or short-circuit it.
After depletion, the accumulator becomes hazardous waste. After depletion, do not dispose of the accumulator in municipal waste.
Turn the accumulator in at take-back sites such as the shop where the lamp was purchased.
This device is not intended for use by children or persons whose physical, sensory or mental disability or lack of experience and expertise
prevents safe use, unless they are supervised by aperson responsible for their safety.
Keep the lamp out of reach of children.
LED light sources have a50 000 hour service life and are therefore not replaceable.
After exhausting, the entire lamp can be disposed of.
Includes:
Headlight | Micro USB power cable | Manual
Do not dispose with domestic waste. Use special collection points for sorted waste. Contact local authorities for information about
collection points. If the electronic devices would be disposed on land ll, dangerous substanoes may reach groundwater and sub-
sequently food chain, where it could aect human health.
CZ | Nabíjecí LED CREE čelovka sIR sensorem
Charakteristika
Zdrojem světla čelovky je vysoce výkonný CREE LED chip. Tato čelovka má zabudovaný Li-Pol akumulátor, který je možné dobíjet přes kabel
smicro-USB konektorem. Nízká hmotnost amalý rozměr je ideální pro použití i outdoorových aktivitách, ale idalších činnostech, kde je
potřeba výkonný azároveň kompaktní zdroj světla.
Technická specikace
Zdroj světla: 1× bílá CREE LED 5 W
Napájení: Li-Pol 1 200 mAh
Režimy: 100 %, 50 %, 20 %, vypnuto + SOS blikání
Dosvit: 75 m
Doba svícení: 3 hodin
Max. světelný tok: 230 lm
Rozměry: 61 × 31 × 33 mm
Hmotnost: 60 g
Popis ovládacích prvků ačástí
1 – Tlačítko pro manuální rozsvícení/zhasnutí
2 – Tlačítko pro zapnutí/vypnutí IR senzoru
3 – CREE LED 5 W
4 – IR sensor
5 – Kryt konektoru Micro USB
Manuální rozsvíce čelovky
1. Stiskem tlačítka 1 na horní straně čelovku rozsviťte – svítí CREE LED na 100 % výkonu.
2. Dalším stiskem tlačítka 1 na horní straně čelovky – svítí CREE LED na 50 % výkonu.
3. Dalším stiskem tlačítka 1 na horní straně čelovky – svítí CREE LED na 20 % výkonu.
4. Dalším stiskem tlačítka 1 na horní straně čelovku zhasnete.
Manuální zapnutí SOS signálu
1. Stiskem tlačítka 1 na horní straně čelovky po dobu 2 s – CREE LED bliká SOS signál.
2. Dalším stiskem tlačítka 1 na horní straně čelovku zhasnete.


Product specificaties

Merk: EMOS
Categorie: Lamp
Model: P3534

Heb je hulp nodig?

Als je hulp nodig hebt met EMOS P3534 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Lamp EMOS

EMOS

EMOS ZM1120 Handleiding

13 Maart 2024
EMOS

EMOS P4009 Handleiding

13 Maart 2024
EMOS

EMOS ZM1121 Handleiding

13 Maart 2024
EMOS

EMOS ZM1122 Handleiding

13 Maart 2024
EMOS

EMOS Z7630B Handleiding

14 November 2023
EMOS

EMOS Z7630W Handleiding

14 November 2023
EMOS

EMOS ZD3241 Handleiding

23 Augustus 2023
EMOS

EMOS P4526 Handleiding

12 Juni 2023

Handleiding Lamp

Nieuwste handleidingen voor Lamp