Emko EAOM-102 Handleiding

Bekijk gratis de handleiding van Emko EAOM-102 (10 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 12 mensen en kreeg gemiddeld 4.9 sterren uit 5 reviews. Heb je een vraag over Emko EAOM-102 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

.

EMKO ELEKTRONIK SAN. Ve TIC. A.S. DEMIRTAS ORG. SAN. BOLG. KARANFIL SOK. TR 16369 BURSA / TURKEY

PHONE : + 90 224 2611900-pbx FAX : + 90 224 2611912 hhtp:\\www.emkoelektronik.com.tr e-mail:[email protected]om.tr

Pages 1 / 10

EAOM-10.2

•

Designed for diesel

generators.

•

Long life membrane front key

pad.

•

EEPROM internal memory.

AUTOMATIC TRANSFER

SWITCH & START UNIT

FOR DIESEL

GENERATORS

1. GENERAL INFORMATION

EAOM-10.2 Automatic Transfer Unit is designed to be

automatically engaged in case of energy failures in generators of

various capacities. The Automatic Transfer Unit is capable of

disengaging and thus protecting either the generator or the

energy receiving system (load) depending upon the type of

failure. Any failures are indicated on the Failure Led Indicators

upon the Transfer Unit and could be stored in memory until

failure deletion. In case of any failure, the unit is also capable of

giving a vocal warning (horn) and either a Yellow or Red Alarm

warning output depending upon the type of failure and in order to

warn the operator in charge. The front board of the Automatic

Transfer Unit features push-buttons to select the run mode, to

silence the horn, to delete failures and to test the bulb, as well as

led indicators to show failures and run modes. EAOM-10.2

Automatic Transfer Unit which features serial communication

outlet (RS-232) is capable of connecting to personal computers

(PC). This connection enables the operator to observe the

mains, generator voltages, speed information, failures and relay

outlet status on the computer display. Added to this, the

programme parameter values stored in the Automatic Transfer

Unit could be changed and current values could be observed.

Also, the programme parameters of the Automatical Transfer

Board could be changed by means of a special programmer. Led

indicators for failures and run modes could be tested by means

of a bulb test.

Product specificaties