Electro Harmonix Hot Tubes Handleiding

Bekijk gratis de handleiding van Electro Harmonix Hot Tubes (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 53 mensen en kreeg gemiddeld 4.9 sterren uit 8 reviews. Heb je een vraag over Electro Harmonix Hot Tubes of wil je andere gebruikers van dit product iets vragen? Stel een vraag

1

HOT TUBES

Congratulations on your purchase of the Hot Tubes overdrive, a faithful reissue of the

original 1970s Electro-Harmonix classic, now in a compact pedalboard-friendly

enclosure. Since its initial release in 1978, countless musicians have prized the

scorching tube amp simulation the Hot Tubes delivers. They consider the original Hot

Tubes to be indispensable, so it is rarely available on the vintage market. Now there

is no need to search. The Hot Tubes reissue gives you the exact same tone and drive

as the original.

- CONTROLS -

OVERDRIVE Knob – Controls the amount of input gain and distortion delivered by

the Hot Tubes. As you turn OVERDRIVE clockwise, the distortion ranges from mild

tube-like breakup to saturated distortion.

TONE Knob – Creates a range of tones from warm bass to bright treble as the knob

is turned clockwise.

VOL Knob – Sets the output volume of the HOT TUBES.

TONE Switch – When this switch is set to OFF, the HOT TUBES Tone knob is

disabled, resulting in a more powerful, direct tone. When the TONE SWITCH is set to

ON, the TONE KNOB behaves normally.

FOOTSWITCH and LED – The footswitch selects whether the HOT TUBES is

engaged or in true bypass mode. When the effect is engaged, the LED will be lit.

INPUT Jack – This ¼” jack is the audio input for the HOT TUBES. The input

impedance is 100k. Ω

AMP Jack – This ¼” jack is the audio output from the HOT TUBES. The output

impedance depends on the VOLUME setting, ranging from 350 to 3k. Ω Ω

9V Power Jack – The HOT TUBES can run off of a 9V battery or you can use an

optional 9VDC AC Adapter capable of delivering at least 50mA to the 9V power jack.

The AC Adapter must have a center negative plug. The battery may be left in or

taken out when using an AC Adapter. The Hot Tubes draws 18mA at 9VDC.

- CHANGING THE BATTERY -

To change the 9-volt battery, you must remove the 4 screws on the bottom of the

HOT TUBES. Once the screws are removed, you can take off the bottom

plate and change the battery. Please do not touch the circuit board while the bottom

plate is off or you risk damaging a component.

Product specificaties