Dyson Airblade Wash+Dry Handleiding

Dyson Handendroger Airblade Wash+Dry

Bekijk gratis de handleiding van Dyson Airblade Wash+Dry (160 pagina’s), behorend tot de categorie Handendroger. Deze gids werd als nuttig beoordeeld door 12 mensen en kreeg gemiddeld 4.8 sterren uit 6.5 reviews. Heb je een vraag over Dyson Airblade Wash+Dry of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Download PDF

Pagina 1/160

GB/ROI/IN/JM/MT/PH/SG

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

BEFORE INSTALLING OR USING THIS UNIT READ ALL INSTRUCTIONS AND

CAUTIONARY MARKINGS IN THIS MANUAL AND THE INSTALLATION NOTES.

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS,

OBSERVE THE FOLLOWING:

1. This unit is not intended for use by persons (including children) with reduced

physical, sensory or reasoning capabilities, or lack of experience and knowledge,

unless they have been given supervision or instruction concerning use of the unit

by a person responsible for their safety.

2. Do not allow the unit to be used for any purpose other than washing and drying

hands. Use this unit only in the manner intended by the manufacturer. If you have

questions, contact the manufacturer.

3. Before servicing, switch the power off at the service panel. Ensure the switch is

locked to prevent the power from being switched on accidentally. If the means of

switching off the power cannot be locked, securely fasten a prominent warning

device, such as a tag, to the service panel.

Children should be supervised to ensure that they do not play with the unit.

DO NOT USE ANY PRESSURE WASHING EQUIPMENT FOR CLEANING ON OR

NEAR THIS UNIT.

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT USE THIS

APPLIANCE WITH ANY SOLID-STATE SPEED CONTROL DEVICE.

ALL INSTALLATION AND REPAIR WORK (PLUMBING AND ELECTRICAL) SHOULD

BE CARRIED OUT BY A QUALIFIED PERSON OR DYSON SERVICE ENGINEER IN

ACCORDANCE WITH CURRENT LOCAL CODES OR REGULATIONS.

CAUTION

Your hand dryer should be located indoors. Operating temperature range 0°C (32°F)

to 40°C (104°F). To reduce the risk of fire or electric shock, do not expose the internal

mechanisms/components of this unit to moisture.

ROI

THANK YOU FOR CHOOSING TO

BUY A DYSON AIRBLADE WASH+DRY

HAND DRYER

DYSON CUSTOMER CARE

Your hand dryer is covered for 5 years from the date of purchase, subject to the terms

of the limited guarantee.

If you have any questions about your hand dryer, call the Dyson Helpline with your

serial number and details of where and when you bought the unit.

Note your serial number here for future reference.

This illustration is for example purposes only.

Your serial number can be found on the bottom right hand corner of the backplate, on

a registration sheet in the box, and also on the large information sticker which can be

found around the tap when the unit is unpacked.

A comprehensive installation guide is enclosed with the hand dryer packaging.

This contains detailed information on the correct installation of the unit, which MUST

be adhered to completely, including routing of electrical cables. Damage caused by

incorrect installation is not covered by your warranty.

The fitting of an in-line filter is advised to prevent any damage that may affect

your guarantee.

27.11.2017 12:51 - C92757_WD04_OPMAN_INT_X588-OWNERS-MANUAL-PART 3- TEXT.indd_15_0c2s_15_0c2s

ROI

LOOKING AFTER YOUR HAND DRYER

WARNING

This product is not to be used in sinks where a plug is fitted. Before engaging the water

flow ensure that the plughole is clear of any obstructions and that water can drain freely.

HOW TO USE

Place your hands beneath the Dyson hand dryer and it will automatically, creating sheets of air

to scrape water from your hands.

For best dry time results:

• Keep your hands flat and parallel to the appliance surface, approximately 5 mm from the

blade, drawing your hands through the airflow from your wrists to finger tips.

• Move your hands slowly through the airflow keeping a consistent speed, approx. 2.5 seconds

per side, alternating between front and back each time.

• Keep you hands flat, close the gaps between your fingers and keep your thumbs in to ensure

that the whole of your hand is drawn through the airflow.

TROUBLESHOOTING GUIDE

WARNING: RISK OF ELECTRIC SHOCK!

Problem Action

The hand dryer fails to start. Check that the fuse/circuit breaker is working

and that the power is connected. Must be

performed by a qualified electrician.

Ensure that the cleaning cap is removed and

that the sensors are clean and unobstructed.

If a safe method of switching is available,

turn the unit on and off. If a safe method is

not available, a qualified electrician must

perform this task.

The hand dryer is turning on and

off erratically.

Ensure that the sensors are clean and free

from obstructions.

Check that the sensor cable from the tap is

securely connected. Must be performed by a

qualified electrician.

The hand dryer sometimes cuts out when

in use but resumes operation after a period

of time.

Check that the air inlet is clean and free

of dust.

Remove any dust from the air inlet.

Ensure that the air inlet is free from

obstructions and has sufficient clearance

(see installation instructions).

The dry time of the hand dryer has increased. Inspect the inlet grille for dust and remove.

Inspect the filter and change if required.

Ensure that the hose is securely attached to

the base of the tap and no leaks are present.

Must be performed by a qualified electrician.

NOTE: Ensure water feed is completely flushed of debris, copper filings etc. prior to

connecting to the product. Failure to do so will damage the solenoid valve.

The instructions in this manual and the installation guide must be followed completely,

as failure to do so may result in incorrect operation, damage to property and/or

personal injury. It is recommended that an isolation valve is fitted with this product

during installation. Dyson will not be held liable for any damage to property or

personal injury, or any loss of business or revenue, if you, your staff, your installer

or service engineers have not followed the instructions given in this manual and the

installation guide.

27.11.2017 12:51 - C92757_WD04_OPMAN_INT_X588-OWNERS-MANUAL-PART 3- TEXT.indd_15_0c2s_15_0c2s

Product specificaties

Merk:	Dyson
Categorie:	Handendroger
Model:	Airblade Wash+Dry
Kleur van het product:	Roestvrijstaal
Gewicht:	4300 g
Breedte:	303 mm
Diepte:	286 mm
Hoogte:	159 mm
Gewicht verpakking:	6800 g
Breedte verpakking:	284 mm
Diepte verpakking:	291 mm
Hoogte verpakking:	303 mm
Soort:	Automatisch
Motor vermogen:	1000 W
Materiaal behuizing:	Roestvrijstaal
Internationale veiligheidscode (IP):	IP35
Anti - bacteriële coating:	Ja
Stroomverbruik (in standby):	0.5 W
Certificering:	NSF, HACCP
Filter type:	HEPA
Hoogte, in bedrijf:	0 - 2000 m
Automatisce uitschakel tijd:	30 s
Luchtsnelheid:	549 km/h
AC-ingangsspanning:	200 - 240 V
AC-ingangsfrequentie:	50 - 60 Hz
Bedrijfstemperatuur (T-T):	0 - 40 °C
Type motor:	Borstelloos
Geluidsvermogensniveau:	81 dB
Droogtijd:	14 s