Dormakaba HSW-ES Handleiding

Dormakaba Niet gecategoriseerd HSW-ES

Lees hieronder de 📖 handleiding in het Nederlandse voor Dormakaba HSW-ES (53 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/53

HSW-ES Sliding Glass Walls

Easy Safe

Installation instructions

940001 – 05-2019

| | EN

2HSW-ES 05-2019940001

dormakaba HSW-ES Sliding Glass Walls Installation Instructions

Table of Contents

Table of contents

1 Technical specifications 3

1.1 Overview 3

1.1.1 General information 3

1.1.2 Intended use 3

1.1.3 Glass requirements/fittings/mounting 3

1.1.4 Requirements for glass panel 3

1.1.5 Safety instructions 3

1.1.6 Symbols used - Safety/Installation 3

1.1.7 Maintenance, care, repair 3

1.1.8 Disposal 3

1.2 Specification - technical data 4

1.3 Tempered laminate glass (TLG) and

adhesive specifications 4

1.4 Tools required 4

1.5 Installation options/Overall top of door

components 5

1.6 Installation options/Bottom of door

components 6

1.7 Installation options/Bottom of door

components (continued) 7

2 Installation instructions - Prepare track 8

2.1 Determine the track arrangement 8

2.2 Install single-action pivoting end panel

retaining clip 9

2.3 Install door track stop in stacking area 10

2.4 Installing the track 11

2.5 Installing upper pivot block 12

2.6 Install rollers in track 13

2.7 Install revision piece 14

2.8 Prepare the roller pattern in the track 15

3 Installation instructions -

DA & SA pivoting end panel 16

3.1 Preparing the DA & SA pivoting end panel

(with monolithic glass only) 16

3.2 Preparing the DA & SA pivoting end panel

(with tempered laminated glass only) 17

3.3 Preparing the upper pivot block 18

3.4 Install floor pivot or BTS80 closer 19

3.5 Install pivot into end panel carrier profile 20

3.6 Install top cover gasket 21

3.7 Installing top covers 21

3.8 Install DA & SA pivoting end panel into track 22

3.9 Secure end panel in track 23

4 Installation instructions -

Sliding panel 24

4.1 Preparing the sliding panel

(with monolithic glass only) 24

4.2 Preparing the sliding panel

(with tempered laminated glass only) 25

4.3 Install sliding panel onto rollers and

adjust door height 26

4.4 Install gasket and top cover 27

5 Installation instructions -

Double-action sliding panel with ITS96 28

5.1 Preparing the DA sliding panel

(with monolithic glass) 28

5.2 Preparing the DA sliding panel

(with tempered laminated glass only) 29

5.3 Installing three piece lock 30

5.4 Prep for installing two piece lock

(when required) 31

5.5 Install top cover and carrier profile gaskets 31

5.6 Installing three piece lock (continued) 32

5.7 Install two piece lock (continued) 33

5.8 Installing DA sliding panels onto rollers and

adjust door height 34

5.9 Secure three piece lock to track 35

5.10 Secure two piece lock to track 36

5.11 ITS96 closer adjustment 37

5.12 ITS96 hold open (optional) and spring force

adjustment 38

6 Installation instructions -

Fixed panel door 39

6.1 Preparing the fixed panel door

(with monolithic glass only) 39

6.2 Preparing the fixed panel door

(with tempered laminated glass only) 40

6.3 Installing the fixed panel holders 41

6.4 Installing the saddle and fixed panel door 42

6.5 Adjusting and securing fixed panel door 43

6.6 Install gasket and top cover 44

7 Installation instructions -

Alignment, covers, end caps, miscellaneous 45

7.1 Aligning panels into stacking area 45

7.2 Aligning panels side by side in straight run 46

7.3 Secure carrier profile file connecting inserts

and end caps 47

7.4 Drilling for ES locking bolt strike 48

7.5 Secure bottom rail covers and rail lock

preparation 49

7.6 Installing the brush 50

7.7 Selecting the proper end cap 51

7.8 Secure the end caps 52

dormakaba HSW-ES Sliding Glass Walls Installation Instructions

HSW-ES 05-2019940001 3

Technical specifications

1 Technical specifications

1.1 Overview

These instructions are for installation of HSW-ES Sliding Wall

Systems for the following mounting and style versions:

1. Ceiling mount

.. General information

• dormakaba requires use of tempered laminated or

tempered monolithic glass.

• dormakaba glass hardware is not suitable for harsh

environment; for example, applications where chemicals

(e.g. chlorine) are used such as indoor swimming pools,

saunas, or salt-water pools.

• Never move sliding panels faster than walking speed and

always stop the door manually before it reaches end

position.

• Do not slide doors with excessive force. Ensure proper

installation of limiting stop to prevent door from opening

too far.

• Do not swing doors with excessive force. Recommended

install of limiting stop to prevent door from opening too

far.

.. Intended use

• For sliding doors in wet or dry indoor areas only.

• For manual slow opening and closing only.

.. Glass requirements/fittings/mounting

• The structural support must be able to bear permanent

loads. Track must be level to /” [] over ’ []

non-cumulative. Maximum deflection ±1/8” [±3] over 10’

[3048] non-cumulative. Finished floor must be level to

within ±1/8” [±3] over 10’ [3048] non-cumulative.

• Fasteners must be sufficiently dimensioned for the

substructure/wall and weight of the door.

• When adjusting glass components, always stick to the

required clearance for the respective hardware. Adjust

clearance so glass does not come in contact with any

hard surfaces such as glass, metal or concrete.

• Do not use excessive force when installing the glass (avoid

over tightening screws.)

.. Requirements for glass panel

• dormakaba requires use of fully tempered glass, which

complies with ASTM C  and ASTM C .

Secondary heat soaking processes are recommended but

not required. This applies to both tempered monolithic

and tempered laminated glass.

• Clamping area must be flat and uncoated (no self-

cleaning coating!)

• Never use glass with conchoidal fractures and/or

damaged edges.

.. Safety instructions

• Installation requires two people.

• Always wear protective clothing.

• Only properly qualified and specially trained staff are

authorized to mount dormakaba glass hardware.

• Due to crushing hazards and possible injury caused by

breakage of glass during mounting, corresponding

protective clothing (especially gloves and protective

goggles) is required.

• Never clamp metal fitting hardware directly to glass

surface.

.. Symbols used - Safety/Installation

CAUTION

Mounting components must meet the

requirements of substructure/wall and door

weight. Please read the technical information

for fittings.

WARNING

Risk of breaking glass. When installing the

door, support the door panel with a block of

wood or similar object.

WARNING

Risk of pinching. When sliding the panels

ensure hands and body parts are free from

between the closing edges.

TIPS AND RECOMMENDATIONS

CLOSING EDGE OF DOOR

.. Maintenance, care, repair

• Immediately replace damaged parts.

• Always use original dormakaba parts.

• Clean clamping area with alcohol-based standard

commercial cleaning agent before mounting the glass

hardware.

• Use a damp cloth for occasional cleaning.

• Always use silicone - and oil-free cleaners (e.g. acetone).

• Check glass hardware at regular intervals for proper

positioning, smooth operation and correct adjustment.

• High traffic door systems require inspection by properly

trained or qualified staff (specialized companies or

installation firms.)

.. Disposal

Disposal in accordance with local, state and national

regulations.

Product specificaties

Merk:	Dormakaba
Categorie:	Niet gecategoriseerd
Model:	HSW-ES

Heb je hulp nodig?

Als je hulp nodig hebt met Dormakaba HSW-ES stel dan hieronder een vraag en andere gebruikers zullen je antwoorden

Uw naam*

Jouw email*

Schrijf hier uw vraag

Handleiding Niet gecategoriseerd Dormakaba

Dormakaba Keyscan EC1500 Handleiding

9 Juli 2023

Dormakaba RCI S2500A Handleiding

9 Juli 2023

Dormakaba EAC Handleiding

9 Juli 2023

Dormakaba CLM9000 Handleiding

9 Juli 2023

Dormakaba DKX Type III Handleiding

9 Juli 2023

Dormakaba 9800 Handleiding

9 Juli 2023

Dormakaba HSW-GP Handleiding

9 Juli 2023

Dormakaba DKX-10 Handleiding

9 Juli 2023

Dormakaba Confidant RFID Kit 1 Handleiding

9 Juli 2023

Dormakaba DKX Type IV Handleiding

9 Juli 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Playtive IAN 327221 Handleiding

1 Mei 2024

Samsung UN32J4001AF Handleiding

1 Mei 2024

Bauknecht KSI 18GF2 P2 Handleiding

27 April 2024

Fakir Artemis TS 150 Handleiding

26 April 2024

Sony UTX-M03 Handleiding

26 April 2024

Sony URX-P03 Handleiding

26 April 2024

Sony WRU-806B Handleiding

26 April 2024

Sony UTX-B03 Handleiding

26 April 2024

Sony UTX-P03 Handleiding

26 April 2024

Sony ODS-L10 Handleiding

26 April 2024