Ditek DTK-800 Handleiding

Bekijk gratis de handleiding van Ditek DTK-800 (2 pagina’s), behorend tot de categorie UPS. Deze gids werd als nuttig beoordeeld door 37 mensen en kreeg gemiddeld 4.1 sterren uit 9 reviews. Heb je een vraag over Ditek DTK-800 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Line Interactive UPS

400V VAA-800







Inspection

The following items are inside the box:

● UPS unit ● User manual USB cable●

Remove the and inspect UPS from its package it for damage that

may have occurred during shipping. If any damage is discovered,

re-pack the unit and return it to the place of purchase.







 

Connect to Utility Power

Connect AC power cord to utility power. he UPS will Tbegin

charging the internal batterysallow the battery to . For best result,

charge 6 hours prior to initial use.for a minimum of







Connect /Computer Ethernet

This UPS provides surge protection for a single Ethernet

connection.Remove existingEthernet cablefrom PC and insert

into UPS “IN” . connectorUsing an additional Ethernet cable,

insert into PC network adapter and UPS “OUT” connector.

Battery backup outlets

AC input

Fuse/Circuit breaker

USB com. port

Ethernet surge protection







Plug in Equipment

Plug your equipment to Battery Backup Outlets on the rear panel of

the UPS.

NOTE: Make the allsure that UPS is on to protect powered

important from devices data loss power failure. during

CAUTION: NEVER connect a laser printer or scanner to the

battery of UPS. The backup outlets equipment may draw

significantly power to overload UPS. the

Connect USB Cable and Install Software

Connect one end of the other to the USB cable to PC and the USB

port the rear of the UPS. at

Download the latest version of ViewPower software USB from

https://www.diteksurgeprotection.com/ups-software.html to your

hard drive. Follow on-screen instructions to complete the software

installation.

Operation Display

UPS

Mode LCD Description

UPS

Power on

When UPS is powered

on, it will enter this mode

for 4 seconds.

AC Mode

When AVR is

functioning, icon will

flash every second.

LCD information will be

displayed in the following

order when LCD is

touched.

1.Output voltage

2.Input voltage

3.Load level

4.Battery capacity

Overload

in AC

mode icon will flash.

When overload occurs,

alarm will beep every 0.5

second.

Battery

Mode

When battery level is

low, icon will flash.

Alarm will beep every 10

seconds and LCD

information will be

displayed in the following

order when LCD is

touched.

1.Output voltage

2.Input voltage

3.Load level

4.Battery capacity

Overload

in battery

mode icon will flash.

When overload occurs,

alarm will beep every 0.5

second.

NOTE: If shuts off, you thebacklight may it activate by touching

screen.

Fault Code Table:

Fault condition LCD Solutions

Output short

circuited

Disconnect short-circuited loads

and restart the UPS again.

Overload fault Disconnect all output loads and

restart the UPS again.

Overcharge Call for service immediately.

Bad or severely

discharged battery

Please replace the battery.

High output voltage

fault

Call for service immediately.

Over-temperature Turn off the unit and wait for1.

cooling.

2. Or remove excessive loads

and wait for cooling.

If fault alarm occurs, please call for service immediately.

www.diteksurgeprotection.com 1-800-753-2345

INT-100177-001 PN: 191-608 REV 01

Product specificaties