Daytronic 5M14 Handleiding

Bekijk gratis de handleiding van Daytronic 5M14 (10 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 22 mensen en kreeg gemiddeld 4.4 sterren uit 5 reviews. Heb je een vraag over Daytronic 5M14 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

1GENERALDESCRIPTIONANDSPECIFICATIONS

The Model 5M14(V) is a precision conditioner designed for TC-based temperature

measurements requiring high input isolation. With built-in reference-junction compen-

sation, it accepts up to four independent temperature signals fromTypes E, J, K, N, R,

S, and T Thermocouples. All four thermocouple inputs must be of the same type.

Sensors may be grounded or ungrounded, in any desired mix. An amplifier-

per-channel design with chopper stabilization and active low-pass filtering allows

highly responsive, amplified analog signals with or without linearization correction.

For the Model 5M14,the analog output signal is 5 Vdc and the 5M14Vis 10 Vdc. These

are

nominal full scale voltages since the Module is based on a millivolt per degree C value.

All setup of the module is accomplished via the front panel configuration switch settings

- polarity over-range, TC type, filter setting, extended gain, and linearized or non-linearized

output.

Model 5M14 Thermocouple Module

Access switch settings via the front

panel of the 5M14 by gently pulling the

clear plastic cover (from the bottom

side) so the cover rotates open from

5M14

1.A.1.5M14

DIN Thermocouple Conditioner

MODEL5M14(V)

QUADISOLATEDTHERMOCOUPLE

CONDITIONERModule

GENERALDESCRIPTIONANDSPECIFICATIONS5M14.1

or without power to the unit. Once

completed, return the cover to the

View of Side Label of the Model 5M14 Thermocouple Module

the top. Use a small tool or finger to

place the switches to the left or right

position as you face the front of the

module. This process can be done with

original position.

Open Thermocouple Detection (OTC)

Can be set per individual TC input to

saturate the analog output signal full -

scale positive or negative.

Note: when this condition exists the analog

output can be as much as 12 Vdc. When

an OTC condition occurs, the yellow LED

indicator on the front of the module

will illuminate.

92338.00

Product specificaties