CyberPower CPS320SL Handleiding

CyberPower UPS CPS320SL

Lees hieronder de 📖 handleiding in het Nederlandse voor CyberPower CPS320SL (16 pagina's) in de categorie UPS. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16

User Manual for:

CPS320SL / CPS375SL / CPS500SL /

CPS575SL / CPS650SL

and PowerPanel™ Software

ADDITIONAL INSTALLATION TIPS CAN BE FOUND AT:

http://www.cyberpowersystems.com/faq_sl.htm

TABLE OF CONTENTS

Description……………………. ………1 LED Indicators……………………………..7

Determining Power Requirements…..1 Troubleshooting Guide……………………8

Hardware Installation Guide………….2 Specifications………………………………8

Software Installation Guide…………..3 Battery Replacement Instructions…….….9

Software User Manual………………..4 Warranty…………………………………...10

Thank you for purchasing a CyberPower Systems Product. To enjoy all the features and benefits of this Uninterruptible Power System

(UPS), please read and follow all installation and operation instructions completely. This UPS is designed to provide guaranteed power

protection for connected electronic equipment. The accompanying PowerPanel™ software saves data, closes open applications and

automatically shuts down your computer system in an intelligent and orderly manner.

IMPORTANT SAFETY INSTRUCTIONS

(SAVE THESE INSTRUCTIONS)

This manual contains important safety instructions. Please read and follow all instructions carefully during installation and

operation of unit. Read this manual thoroughly before attempting to unpack, install, or operate.

CAUTION! To prevent the risk of fire or electric shock, install in a temperature and humidity controlled indoor area, free of

conductive contaminants. (Please see specifications for acceptable temperature and humidity range).

CAUTION! To reduce the risk of electric shock, do not remove the cover except to service the battery. No user serviceable

parts inside except for battery.

CAUTION! Hazardous live parts inside can be energized by the battery even when the AC input power is disconnected.

CAUTION! UPS must be connected to an AC power outlet with fuse or circuit breaker protection. Do not plug into an outlet

that is not grounded. If you need to de-energize this equipment, turn off and unplug the unit.

CAUTION! To avoid electrical shock, turn off the unit and unplug it from the AC power source before servicing the battery or

installing a computer component.

DO NOT USE FOR MEDICAL OR LIFE SUPPORT EQUIPMENT! CyberPower Systems does not sell products for life

support or medical applications. DO NOT use in any circumstance that would affect operation or safety of any life support

equipment or with any medical applications or patient care.

DO NOT USE WITH OR NEAR AQUARIUMS! To reduce the risk of fire or electric shock, do not use with or near an

aquarium. Condensation from the aquarium can cause the unit to short out.

CPS320SL / CPS375SL / CPS500SL / CPS575SL / CPS650SL

Guaranteed Uninterruptible Power System

DESCRIPTION

INSPECTION

The box should contain the following:

(1) PowerPanel™ software (floppy disk); (1) serial interface cable (DB-9);

(1) telephone communication cable; (1) user manual; (1) warranty registration card;

(1) UPS unit.

HOW TO DETERMINE THE POWER REQUIREMENTS OF YOUR EQUIPMENT

1. Make sure that the total Volt-Amp (VA) requirements of your computer, monitor and peripherals does not exceed 1440 VA.

2. Insure that the equipment plugged into the three battery power-supplied outlets does not exceed the UPS unit’s rated capacity

(320VA/185W for CPS320SL, 375VA/210W for CPS375SL, 500VA/275W for CPS500SL, 575VA/320W for CPS575SL and

650VA/350W for CPS650SL). If rated unit capacities are exceeded, an overload condition may occur and cause the UPS unit to

shut down and the circuit breaker to trip.

3. If the power requirements of your equipment are listed in units other than Volt-Amps (VA), convert Watts (W) or Amps (A) into VA

by doing the calculations below. Note: The below equation only calculates the maximum amount of VA that the equipment can

use, not what is typically used by the equipment at any one time. Users should expect usage requirements to be approximately

60% of below value.

TO ESTIMATE POWER REQUIREMENTS:

Watts (W) x 1.82 = VA or Amps (A) x 120 = VA

Add the totals up for all pieces of equipment and multiply this total by .6 to calculate actual requirements.

There are many factors that can effect the amount of power that your computer system will require. The total load that you will be

placing on the battery-powered outlets should not exceed 80% of the unit’s capacity.

X Battery/Surge Outlets

Provides three battery powered/surge outlets for connected

equipment and insures temporary uninterrupted operation

of your equipment during a power failure.

Y Full-Time Surge Protection Outlets

Provides three always on surge suppression outlets.

Z Power Switch

Can be used as a mater on/off switch for equipment

connected to the battery power supplied outlets.

[ Electrical Wiring Fault Indicator

This LED indicator will illuminate to warn the user that a

wiring problem exists, such as bad ground, miss ground or

reversed wiring. If this is illuminated, user is advised to

disconnect all electrical equipment from the outlet and have

an electrician check to ensure the outlet is properly wired.

\ Power On Indicator

This LED is illuminated when the utility condition is normal

and the UPS outlets are providing power, free of surges

and spikes.

] Circuit Breake

Located on the side of the UPS, the circuit breaker serves to

provide overload and fault protection. Under normal operating

conditions, the circuit breaker is depressed.

^ Serial Port to PC

This port allows connection and communication from the DB-9

serial port on the computer to the UPS unit. The UPS

communicates its status to the PowerPanel™ software. This

interface is also compatible with the UPS service provided by

Windows NT and Windows 2000.

_ Communication Protection Ports

Communication protection ports will protect any standard modem,

fax or telephone line.

` Outlets Designed for AC Adapters

Allows six AC power adapter blocks to be plugged into the UPS

without blocking adjacent outlets.

Product specificaties

Merk:	CyberPower
Categorie:	UPS
Model:	CPS320SL
Kleur van het product:	Zwart
Snoerlengte:	1.8 m
LED-indicatoren:	Ja
Vormfactor:	Compact
Certificering:	UL1778, cUL, FCC DOC Class B
Responstijd:	4 ms
Duurzaamheidscertificaten:	RoHS
Uitgangsvermogen:	185 W
Stroomspanning bescherming:	Overbelasting
Frequentie:	60 Hz
Modem (RJ-11) poort:	3
Bedrijfstemperatuur (T-T):	0 - 35 °C
Relatieve vochtigheid in bedrijf (V-V):	0 - 95 procent
Batterijtechnologie:	Sealed Lead Acid (VRLA)
Surge energy rating:	450 J
Aantal AC uitgangen:	6 AC-uitgang(en)
Nominale input voltage:	120 V
Stopcontacttypes:	NEMA 5–15R
Stroom (max.):	36 A
Input-connectietype:	NEMA 5-15P
Output power capacity:	0.32 kVA
Ingang operation voltage (min):	- V
Ingang operation voltage (max):	- V
Uitgang operation voltage (min):	- V
Uitgang operation voltage (max):	- V
Typische backup tijd op halve lading:	0 min
Output-aansluitingen:	NEMA 5-15R