CTA Digital AUT-VDMC Handleiding
Pagina's 2 Niet gecategoriseerd
Bekijk de handleiding van CTA Digital AUT-VDMC gratis online of download de PDF. Deze handleiding is 0 keer bekeken. Vraag over dit model? Stel een vraag

Vehicle Dash Mount w/ Custom Flex Arms
AUT-VDMC
INSTALLATION - MANUAL
INSTALLATION:
1.Installing the Mount to Vehicle :
1A. Drill holes on the surface as shown above
with power drill tool (not provided).
1B. Place vehicle dash mount (B) aligning the holes
drilled on surface and then screw in the provided p1-x4
screws (C) through the base with a screw driver (not
provided) until securely tightened.
A
A
CONTENTS:
x4
C
x3
Foam
Pads
B
1mm
5mm
10mm
x1
A
Drilling into the dash, wall, or roof will be a permanent installation and may cause damage if not
installed properly. Use caution and consult a mobile install professional to avoid drilling into the gas
tank,electrical system or other highly sensitive vehicle components.
D
T10 23*65mm
Security Allen Key
M5*25mm Screw
x1
**Screwdriver for illustration
only and not included

2.Attaching Foam Pad to Tablet Holder :
3. Inserting Tablet to Holder :
4. Adjustability
A
B
3A. Press quick release button on side of tablet
holder (A) to release the adjustable end.
3B. Insert tablet corner against the spring arm. Push adjustable arm
down against opposite corner (A). Be sure it is as snug as possible.
4A.Twist the screw
knobs counter
clock-wise to loosen
joints
4B. Adjust the
arm to desired
position then twist
the screw knob
clock-wise until
securely
tightened.
2A. Select the appropiate foam pad (B) according to the thickness of your tablet (or tablet in its case), then
press adhesive side into center of the tablet holder.
1mm
5mm
10mm
Please be sure to fasten all the screws were
tightened securely while using the stand.
Not for use while driving.
Max loading :1KG
Caution
- Use this table to determine the appropiate
foam pad (B) to use with your tablet.
Note:
sizes refer to total tablet size with or
without a case
Tablet Thickness:
Foam Pad
Thickness:
1mm0.67-1.06in / 17-27mm
0.51- 0.91in / 13-23mm
0.31- 0.71in / 8-18mm
5mm
10mm
A
**Tablet for illustration
only and not included
A
A
5. Removing an Arm Segment
Arm is designed in a manner where you can remove or add
segments as needed in a secure manner.
5B. Remove the
screw cap cover on
the end of the knob
using your fingers to
take off. There will be
a cavity and a hex
screw on the inside.
5A. Identify the
various joints on the
mount and locate the
location where you
would like to
remove/add a
segment.
5C. Using provided
security allen key (D),
rotate
CLOCKWISE to loosen.
Then turn the knob
upside down for the hex
nut to fall out once
loosened. Then rotate off
the knob and segment
can be removed.
Product specificaties
| Merk: | CTA Digital |
| Categorie: | Niet gecategoriseerd |
| Model: | AUT-VDMC |
Heb je hulp nodig?
Als je hulp nodig hebt met CTA Digital AUT-VDMC stel dan hieronder een vraag en andere gebruikers zullen je antwoorden