CRUX CCH-01W Handleiding


Lees hieronder de 📖 handleiding in het Nederlandse voor CRUX CCH-01W (1 pagina's) in de categorie Achteruitrijcamera. Deze handleiding was nuttig voor 24 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/1
Crux Interfacing Solutions • 6860 Canby Ave., Suite 116, Reseda, CA 91335
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.052318
CCH-01W
JEEP WRANGLER License Plate Mount Camera
2007 - 2017
- Installs on your Wrangler’s license plate bracket, keeping the rugged appeal of your Jeep.
- 120° wide viewing angle.
- 0.4 Lux minimum for night driving.
- Selectable Parking Guide Line ON or OFF.
PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM:
CCH-01W CAMERA EXTENSION CABLE
*NOTE: To power the camera, use RED Wire A or B. If tapping power from the radio or RVC Interface, make sure to
insulate RED Wire A to avoid it from shorng. If you will be tapping power from the reverse light +12V, insulate RED
Wire B to avoid it from shorng. With either connecon the Black GROUND wire needs to be connected to a solid chassis
ground. For vehicles with manual transmission, we recommend tapping +12V power from the reverse light.
WHITE Wire: Connect to show parking guide line. Disconnect to remove. Insulate with tape to avoid from shorng.
R
INTERFACING SOLUTIONS
Sightline
CAMERAS
WHITE Wire
Parking Guideline
Regulator
Extension Coax Cable
GROUND
RED Wire (A)*
RED Wire (B)*
Make sure the arrows
line up and push in
the connectors well.
To Aftermarket Radio
Backup Camera Input
OR
Reverse Camera Interface
Backup Camera Input
LICENSE PLATE
CAMERA
1. Remove the stock license plate light at the back of the vehicle.
2. Install the camera assembly to where the stock license plate light was.
3. Connect the built-in license plate light of the camera to the stock license plate power connecon.
4. Connect the power of the camera to your reverse light wires:
Red wire to +12V
Black wire to Ground
5. Connect the video cable of the camera to the extension cord provided.
6. Run the video extension cable to the back of the radio.
7. Connect the video cable to your in-dash aermarket mulmedia or navigaon receiver’s camera input.
8. Put the gear in reverse to see the image from the camera.
INSTALLATION PROCEDURE:


Product specificaties

Merk: CRUX
Categorie: Achteruitrijcamera
Model: CCH-01W

Heb je hulp nodig?

Als je hulp nodig hebt met CRUX CCH-01W stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Achteruitrijcamera CRUX

Handleiding Achteruitrijcamera

Nieuwste handleidingen voor Achteruitrijcamera