Conceptronic NMC01L Handleiding

Bekijk gratis de handleiding van Conceptronic NMC01L (2 pagina’s), behorend tot de categorie UPS. Deze gids werd als nuttig beoordeeld door 2 mensen en kreeg gemiddeld 4.5 sterren uit 3 reviews. Heb je een vraag over Conceptronic NMC01L of wil je andere gebruikers van dit product iets vragen? Stel een vraag

POWER MANAGEMENT CARD

NMC01L

The Power Management Card allows a UPS/ATS

system and environmental sensor to be managed,

monitored, and configured.

INSTALLATION GUIDE

NOTE: The Power Management Card is hot-swappable, so you do not

need to turn off the device to install it.

4. Connect an Ethernet cable to the

Ethernet port of the Power

Management Card.

3. Insert and tighten the retaining

screws.

2. Install the Power Management

Card into the expansion slot.

1. Remove the two retaining

screws of the expansion slot,

and then remove the cover.

Definitions for LED Indicators

Step 2. Configure the IP address for the Power

Management Card

Method 1: Using the Power Device Network Utility

1. Install the Power Device Network Utility available for download on the

Network Power Management product web page at

http://www.powermonitor.software/#PowerDeviceSoftware.

2. After installation completes, run the “Power Device Network Utility”.

3. The main dialog of the Power Device Network Utility program is shown

in Figure 1. The configuration tool will display all Power Management

devices present on the same network subnet. The "Refresh" button is

used to search the local network subnet again.

4. Select the Power Management Card you are setting up. Click on the

Tools menu and select “Device Setup” or double click the Power

Management Card you want to configure.

5. You can modify the IP Address,

Subnet Mask, and Gateway

address for the Device MAC

Address listed in the Device

Network Settings window, as

shown in Figure 2. The factory

default IP Address is

192.168.20.177 and the default

Subnet Mask is 255.255.255.0.

6. Modify the IP, subnet mask or

gateway address. Enter the new

addresses into the corresponding

fields and then click “Save”.

Link LED color

Off

On(Yellow)

Tx/Rx LED color

Off

On(Green)

Flash

Condition

The Power Management Card is not

connected to the Network/ or the Power

Management Card power is off

The Power Management Card is connected to

the Network

　

The Power Management Card power is off

The Power Management Card power is on

- Receiving/transmitting data packet

- Reset finished

Step 1. Hardware Installation

Figure 1. The main window of the “Power Device Network Utility” program.

Figure 2. The Device Network setting window.

Tx/Rx

Link

Universal

PMCARD

Universal

Tx/Rx

PMCARD

LINK IndicatorTx/Rx Indicator

Ethernet PortUniversal Port

Tx/RxLinkUniversal

PMCARD-L

Quick Start Guide

Product specificaties