Coleman Evanston Handleiding

Coleman Tent Evanston

Lees hieronder de đź“– handleiding in het Nederlandse voor Coleman Evanston (2 pagina's) in de categorie Tent. Deze handleiding was nuttig voor 52 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/2
STITCH LINE
EVANSTONTM 6TENT MODEL 2000001589
Pole Descriptions
Pole Pole Pole
Description Qty. Dia. Repair Kit Replacement Kit
Main Pole, black 2 11mm 501000539 501000549
Main Pole, grey 1 11mm 501000539 501000549
Rainfly Pole, black, long 1 11mm 501000539 501000549
Awning Pole, black, short 1 6.9mm 501000542 501000552
Before you begin
Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or sharp
objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential lightning strikes
or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent property damage
or personal injury.
• For best results in windy conditions, position narrow end of tent into
the wind.
• Enlist the help of at least one other person to assist you when it is time
to assemble the tent.
To Set Up Tent
1. Unfold tent and spread out on a clean, level surface with the door
facing the desired direction. (Fig. 1)
2. Assemble all poles by interlocking the shock-corded, sections
together.
3. Insert black Main Poles through the black trimmed sleeves on top
of tent forming an X”.
4. Insert grey Main Pole through grey trimmed sleeve, in front of tent.
Make sure grey Main Poles overlap the black Main Poles. (Fig. 1)
Fig. 1
Door
Grey, Shock-corded
Main Pole
Black, Shock-corded Main Poles
Sleeves with Black Trim
Sleeve with
Grey Trim
5. Insert end of each black Main Pole into pins located in the corners
of the tent. (Fig. 2 & 2A)
6. Go to opposite end of each black Main Pole and gradually apply
pressure to each forming arches. Insert the pin into each pole end
at the corners of tent. (Fig. 2 & 2A)
7. Insert end of the grey Main Pole into pin located on the sides of the
tent. (Fig. 2 & 2B)
8. Go to opposite end of the grey Main Pole and gradually apply pres-
sure to form an arch. Insert the pin into pole end at the side of tent.
(Fig. 2 & 2B)
Fig. 2
Door
2A
2B
Front of Tent
9. Attach frame clips along edges of tent
to the black & grey Main Poles.
(Fig. 3)
Fig. 3
10. Stretch tent until taut, then secure metal loops
located on both sides and four corners of tent
with stakes. (Fig. 4)
Fig. 4
To Attach Rainfly
1. Drape Rainfly over tent with dark blue vestibule flaps located at the
front of the tent. (Fig 5).
NOTE: Hook and loop fasteners, located on seams of underside of
Rainfly, should be centered over black & grey Main Poles.
2. Insert the long, black, Rainfly Pole with through sleeve in underside
of Rainfly above front door of tent. (Fig. 5)
Fig. 5
Sleeve with Grey Trim
Black, Shock-corded
Rainfly Pole
Rainfly
Front of Tent
Door
Fig. 6
Awning Pole
Rainfly Sleeve
Back of Tent
3. Insert short, black, thin Awning Pole through sleeve in underside of
Rainfly above window at back of tent. (Fig. 6)
4. Insert metal tip into grommet on tent seam at back of tent (Fig. 7).
Go to opposite end of Awning Pole and gradually apply pressure to
pole forming an arch; then insert metal tip into grommet.
Vestibule Flaps
Awning
Pole
Grommet
Front of Tent
Fig. 7
(continued on other side)
5. Insert end of each black Rainfly Pole into
pin on either side of front door. (Fig. 8)
6. Go to opposite end of Rainfly Pole and
gradually apply pressure to form an arch.
Insert the pin into pole end at other side of
the door. (Fig. 8)
7. Locate all hook & loop fasteners on under
side of Rainfly and wrap around all Main
Poles, Awning & Rainfly Pole to secure.
(Fig. 9)
NOTE: Make sure longer hook & loop
fastener on Rainfly is secured around grey
and black Main Poles where they cross.
(Fig. 10)
Fig. 8
Fig. 9
Fig. 10
STITCH LINE
4010003997 (20081114)
Things You Should Know:
• Under certain conditions (cold weather, high humidity, etc.) condensa-
tion will form on the inside of your tent. Condensation is caused by water
vapor from your breath, perspiration, or any wet clothing inside the tent.
It is NOT LEAKAGE through the tent fabric. It can be minimized by
removing wet clothing from your tent and by providing good ventila-
tion through the tent.
• Tree limbs, tree sap, bird droppings, or moisture steadily dripping off
tree limbs can cause damage to the tent fabric and its coating resulting
in leaks or loss of flame-resistant properties.
• Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use a separate storage bag.
• Stakes should be removed by pulling on the stake itself. NEVER PULL ON
THE TENT TO REMOVE STAKES AS THIS COULD RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
• Tent poles should not be left telescoped together during storage.
• Do not leave your tent set-up for weeks at a time. Be aware that exposure
to ultraviolet rays from the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away
from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA • PRINTED IN CHINA
© 2008 The Coleman Company, Inc.
Coleman®, , and are registered trademarks and Evanston TM
is a trademark of
The Coleman Company, Inc.
11B
Fig. 11
11C
Cooler Access
The smaller zippered opening at the side of tent is
designed for added ventilation and easy access to
your beverage cooler.
1. To use as a vent, unzip flap to expose screen.
2. To use as a cooler access, unzip other flap to
make an avenue to bring beverages into tent. (Fig. 13)
To Store
1. All poles and stakes must be placed in the storage bag to
prevent damage to the fabric items placed in the carry case.
2. Make sure tent is clean and dry before placing in carry case.
3. Remove rainfly, spread out on floor of tent, then unzip door & vents
before taking tent down for storage.
4. Neatly fold tent to width of pole storage bag, place on tent, roll
tightly, and place in carry case.
5. Store in a clean, dry area.
Electrical Cord Access
1. Unzip the access panel in the lower
left corner of tent and bring in an
electrical cord.
NOTE: Use only UL approved cords
rated for outdoor usage. (Fig. 12)
Fig. 13
Fig. 12
To Attach Rainfly
(continued)
8. Stretch elastic straps and hook clip on each to the metal loops at the front and back corners of the tent. (Fig. 11 & 11A)
9. Extend out vestibule flaps and secure with metal stakes through the loops in the web straps. (Fig. 11 & 11B)
10. Stretch guylines until taut, then secure with stakes. (Fig. 11 & 11C)
11A


Product specificaties

Merk: Coleman
Categorie: Tent
Model: Evanston

Heb je hulp nodig?

Als je hulp nodig hebt met Coleman Evanston stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Tent Coleman

Handleiding Tent

Nieuwste handleidingen voor Tent