Chief DMA1S Handleiding

Bekijk gratis de handleiding van Chief DMA1S (2 pagina’s), behorend tot de categorie Flat panel steun. Deze gids werd als nuttig beoordeeld door 22 mensen en kreeg gemiddeld 4.1 sterren uit 7 reviews. Heb je een vraag over Chief DMA1S of wil je andere gebruikers van dit product iets vragen? Stel een vraag

Quick Setup Guide

For complete installation instructions, refer to the

Installation Manual included with this product.

This Quick Setup Guide is meant to provide only an overview

of the various installation steps.

ALWAYS read the Installation Instructions in its entirety before

beginning the Installation.

DMA

DMA

x2

or

x2

desk

Option A

Step 1: Clamp Base to Desk Edge Option

Loosen clamp screw on base, place on desk

and tighten.

Reattach removed piece of clamp and

screws and tighten clamp screw.

8800-003249, Rev0010/2020

Option B

Step 1: Clamp Base through Grommet Hole Option

Remove lower piece of clamp from assembly by removing two

button head cap screws and install remaining part of clamp

through grommet hole.

DMA1 Single Monitor Arm

DMA2 Dual Monitor Arm

Tools Required for Installation

Parts

#2

5/32” (included)

A (1)

[Arm assembly]

(DMA1 shown)

B (1)

[Base assembly]

(DMA1 shown)

H (1)

5/32”

D (4/8)*

M4 x 20mm

E (4/8)*

M10 x 5.3 x 10

F (4/8)*

M4 x 4mm

G (12)*

#10-32-3/8

C (4/8)*

M4 x 10mm

DISCLAIMER

Legrand | AV and its ailiated corporations and subsidiaries (collectively “Legrand | AV”), intend

to make this manual accurate and complete. However, Legrand | AV makes no claim that the

information contained herein covers all details, conditions or variations, nor does it provide

for every possible contingency in connection with the installation or use of this product. The

information contained in this document is subject to change without notice or obligation of any

kind. Legrand | AV makes no representation of warranty, expressed or implied, regarding the

information contained herein. Legrand | AV assumes no responsibility for accuracy, completeness

or suiciency of the information contained in this document.

WEIGHT CAPACITY WARNING

Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is

the installer’s responsibility to make sure the combined weight of all components and accessories

attached to the DMA Series Monitor Arm up to (and including) the display is between the weight

ranges listed below. Use with products heavier than the maximum weight indicated may result in

collapse of the mount and its accessories causing possible injury. Use with products lighter than

the minimum weight indicated may result in the mount not functioning properly.

Product specificaties