Chief CMSFAN Handleiding

Chief Projector accessoire CMSFAN

Lees hieronder de 📖 handleiding in het Nederlandse voor Chief CMSFAN (4 pagina's) in de categorie Projector accessoire. Deze handleiding was nuttig voor 30 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/4

I N S T A L L A T I O N I N S T R U C T I O N S

Ceiling AV Enclosure 12V Fan Kit

Spanish Product Description

German Product Description

Portuguese Product Description

Italian Product Description

Dutch Product Description

French Product Description

CMSFAN

CMSFAN Installation Instructions

DISCLAIMER

Milestone AV Technologies and its affiliated corporations and

subsidiaries (collectively "Milestone"), intend to make this

manual accurate and complete. However, Milestone makes no

claim that the information contained herein covers all details,

conditions or variations, nor does it provide for every possible

contingency in connection with the installation or use of this

product. The information contained in this document is subject

to change without notice or obligation of any kind. Milestone

makes no representation of warranty, expressed or implied,

regarding the information contained herein. Milestone assumes

no responsibility for accuracy, completeness or sufficiency of

the information contained in this document.

Chief® is a registered trademark of Milestone AV Technologies.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: A WARNING alerts you to the possibility of

serious injury or death if you do not follow the instructions.

CAUTION: A CAUTION alerts you to the possibility of

damage or destruction of equipment if you do not follow the

corresponding instructions.

WARNING: Failure to read, thoroughly understand, and

follow all instructions can result in serious personal injury,

damage to equipment, or voiding of factory warranty! It is the

installer’s responsibility to make sure all components are

properly assembled and installed using the instructions

provided.

WARNING: Use this fan kit only for its intended use as

described in these instructions. Do not use attachments not

recommended by the manufacturer.

WARNING: Never operate this fan kit if it is damaged.

Return the fan kit to a service center for examination and

repair.

WARNING: Do not use this product outdoors.

NOTE: Spacings - To ensure safe operation of the equipment

installed in the enclosure, per National Electric Code,

ANSI/NFPA 70 Article 725.136(D)(1), a minimum

separation of 6mm (0.25 in.) between power cords and

signal or communication cables must be maintained.

In the U.S., the equipment shall be installed per the applicable

requirements of the National Electrical Code, ANSI/NFPA 70.

In Canada, the equipment shall be installed per the applicable

requirements of the Canadian Electrical Code, CSA C22.1.

IMPORTANT ! : The CMSFAN is designed to be installed

in the Listed Chief CMS491-491C-492-492C above-

ceiling suspended storage boxes (not included).

--SAVE THESE INSTRUCTIONS--

DIMENSIONS

DIMENSIONS: INCHES

[MILLIMETERS]

Installation Instructions CMSFAN

TOOLS / PARTS FOR INSTALLATION

A (1)

[CMSFAN] B (2)

10-24 x 1/2" C (2)

10-24 x 1/2"

D (1)

[Power supply]

[self-drilling]

[Phillips drill bit]

NOTE: The CMSFAN (A) is attached within either the CMS491

or CMS492 ceiling boxes in two different manners:

• By tapping attachment holes in correct location; or

• By removing Phillips screws already located in

attachment holes.

INSTALLATION

1. Determine where the CMSFAN (A) will be installed above

the ventilation areas in CMS491/CMS492. (See Figure 1)

2. Proceed to appropriate section (Install CMSFAN to

Existing Attachment Holes or Install CMSFAN by

Creating Attachment Holes) section.

Install CMSFAN to Existing Attachment Holes

3. Remove Phillips head screws from either of two locations

where CMSFAN (A) may be attached. (See Figure 1)

Figure 1

4. Attach CMSFAN (A) into the ceiling box using either the

screws removed in Step 3, or two 10-24 x 1/2" Phillips pan

head screws (B). (See Figure 2)

Figure 2

Install CMSFAN by Creating Attachment Holes

5. Hold CMSFAN (A) in desired location in ceiling box above a

ventilation area.

6. Attach fan into place, using two 10-24 x 1/2" Phillips self-

drilling screws (C). (See Figure 2)

COMPLETING INSTALLATION

1. Attach power supply (D) to CMSFAN (A). (See Figure 3)

Figure 3

Ventilation areas

x 2

Ventilation areas

(CMS492 shown)

x 2

(A)

(CMS492 shown)

(D)

(A)

Product specificaties

Merk:	Chief
Categorie:	Projector accessoire
Model:	CMSFAN
Kleur van het product:	Zilver
Materiaal:	Staal
Merkcompatibiliteit:	Chief
Code geharmoniseerd systeem (HS):	85299097