Chapin 6428 Handleiding
Bekijk gratis de handleiding van Chapin 6428 (12 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 11 mensen en kreeg gemiddeld 3.6 sterren uit 6 reviews. Heb je een vraag over Chapin 6428 of wil je andere gebruikers van dit product iets vragen? Stel een vraag
Pagina 1/12
WARNING
Please call 800-950-4458 or visit www.chapinmfg.com if you are
missing any parts, having trouble assembling, or have any quesons
regarding the safe operaon of this product.
DO NOT RETURN TO THE STORE.
MODEL 6428
Carefully Read These Instrucons Before Use
015832 R0318
SPRAY BOOM KIT
1E
WARNING
INTRODUCTION
The purpose of this manual is to assist you in the assembly, operaon and maintenance of your sprayer
or accessories. Please read through this manual completely too fully understand how to operate and
maintain your equipment. This product has been manufactured to provide years of dependable service,
proper operaon and maintenance will ensure its dependability. Keep your manual in a safe, convenient
place for future reference. Always menon the model and part number in any correspondence.
ASSEMBLY INSTRUCTIONS
The following instrucons are intended for the aachment of the seven foot boom to a Chapin spot
sprayer, lawn trailer, 3-point sprayer or ATV kit.
Spray Boom Aachment
NOTE: Depending on ATV/UTV, Chapin mounng bracket (P/N 6330, not shown) may be necessary for
secure mounng.
1. Using four of the supplied bolts and nuts (items 1 & 2), aach the two Upright Aaching
Brackets (item 3) to a mounng bracket assembly (sold separately Chapin P/N 6330), or to
exisng ATV/UTV rack.
2. Using two of the supplied bolts and nuts (items 1 & 2), aach the Horizontal Boom Frame (item 4)
to the two Upright Aaching Brackets (item 3). Depending on the height one wishes to set the
boom to, use one of the top three holes of the Upright Aaching Brackets. Recommended nozzle
height is 12-24 inches from the ground.
3. Thread the Swivel Nut (item 5) to the water source.
**Note: with the blue stock nozzle it is recommended to not use boom assembly with a system of
less than 1.7 GPM and no less than 1.0gpm with the green nozzle.
IMPROPER USE OR FAILURE TO FOLLOW INSTRUCTIONS CAN RESULT IN PRODUCT
FAILURE OR INJURIES. FOR SAFE USE OF THIS PRODUCT YOU MUST READ AND
FOLLOW ALL INSTRUCTIONS BEFORE USING.
4
2
5
3
3
1
1
2
2E
OPERATING INSTRUCTIONS
Using the boom nozzles
1. Choose the nozzle best equipped for the applicaon at hand. See Nozzle Flow Chart for ow rates
and spray angle.
2. While spraying water only raise or lower the boom to acquire the desired coverage. If you see dry
spots while spraying you need to raise the boom; too much soluon in the paern areas means you
need to lower the boom. Generally, the proper height will be from 13 to 18 inches o the ground.
3. Reference the product you’re spraying for desired mix rao.
NOZZLE FLOW RATE CHART
Nozzle
Pressure
(PSI)
Flow Rate
(GPM)
Green
P/N
013665
Blue
P/N
015525
10
30
20
0.23
0.45
0.36
10
30
20
0.43
0.83
0.65
* Note: all ow rates are per nozzle
CLEANING & STORAGE
Most spray materials are highly corrosive. The most important aspect of long dependable service from
the sprayer is a thorough cleaning immediately following each use. In addion, the residue of one type of
chemical could cause an undesirable eect when a dierent chemical is used for a dierent purpose.
The most eecve cleaning method is to pump several rinses of clean water through the tank, pump,
hoses, boom, spray gun, etc. A neutralizing agent such as a soluon of Nutra-Sol, a detergent or
household ammonia as recommended by the chemical manufacturer can assist in removal of a persistent
chemical. When the system is thoroughly cleaned, drain the tank, sucon line, pump hoses, etc.
The following steps should be followed for the maintenance and storage of your sprayer.
1. Wash and ush out sprayer aer compleon of each phase of your program. Flush out sprayer
when changing chemicals. Use of a detergent is advisable if the chemical manufacturer does not
make specic cleaning recommendaons. Flush system completely, including nozzles. Never use
metal objects to open clogged nozzles.
2. Clean sprayer thoroughly before storing at the end of the spraying season. Permanent type
an-freeze added to the nal rinse will leave a rust inhibing lm in parts of the sprayer.
Product specificaties
| Merk: | Chapin |
| Categorie: | Niet gecategoriseerd |
| Model: | 6428 |
Heb je hulp nodig?
Als je hulp nodig hebt met Chapin 6428 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Niet gecategoriseerd Chapin
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025
16 Juni 2025
Handleiding Niet gecategoriseerd
- Pulox
- Wacker Neuson
- OJ ELECTRONICS
- Hatco
- Hapro
- Kata
- Mio
- Technics
- Maxsa
- Emga
- AstrHori
- Berner
- Crane Song
- Soul
- Cranborne Audio
Nieuwste handleidingen voor Niet gecategoriseerd
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025
19 Juni 2025