Cameo F4 FC PO IP65 Handleiding

Cameo Lamp F4 FC PO IP65

Lees hieronder de 📖 handleiding in het Nederlandse voor Cameo F4 FC PO IP65 (104 pagina's) in de categorie Lamp. Deze handleiding was nuttig voor 18 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/104
USER´S MANUAL
BEDIENUNGSANLEITUNG
MANUEL D´UTILISATION
MANUAL DE USUARIO
INSTRUKCJA OBSŁUGI
MANUALE D´USO
F4 FC PO IP65
POLE-OPERATED OUTDOOR FRESNEL SPOTLIGHT WITH RGBW LED
CLF4FCPOIP
RGB W
V1.40
CONTENTS / INHALTSVERZEICHNIS / CONTENU / CONTENIDO / TREŚĆ / CONTENUTO
ENGLISH
SAFETY INFORMATION 3
INTRODUCTION 4
CONNECTIONS, CONTROL AND DISPLAY ELEMENTS 5
OPERATION 6
USING THE OPERATING POLE FOR SETUP, INSTALLATION, AND
CONFIGURATION 14
BARN DOOR AND FILTER FRAME INSTALLATION /
DISASSEMBLY / CLEANING OF LENSES 14
DMX TECHNOLOGY 15
TECHNICAL SPECIFICATIONS 16
MANUFACTURER’S DECLARATIONS 17
DMX CONTROL 98
DEUTSCH
SICHERHEITSHINWEISE 18
EINFÜHRUNG 19
ANSCHLÜSSE, BEDIEN- UND ANZEIGEELEMENTE 20
BEDIENUNG 21
AUFSTELLUNG, MONTAGE UND EINSTELLEN PER
BEDIENSTANGE 30
TORBLENDE UND FILTERRAHMEN MONTIEREN /
DEMONTIEREN / LINSEN REINIGEN 30
DMX TECHNIK 31
TECHNISCHE DATEN 32
HERSTELLERERKLÄRUNGEN 33
DMX STEUERUNG 98
FRANCAIS
MESURES PRÉVENTIVES 34
INTRODUCTION 35
RACCORDEMENTS, ÉLÉMENTS DE COMMANDE ET
D’AFFICHAGE 36
COMMANDE 37
INSTALLATION, MONTAGE ET AJUSTEMENT PAR BARRE
DE RÉGLAGE 46
MONTAGE/DÉMONTAGE DU VOLET COUPE-FLUX ET DU
CADRE POUR FILTRE / NETTOYAGE DES LENTILLES 47
TECHNOLOGIE DMX 47
CARACTÉRISTIQUES TECHNIQUES 48
DÉCLARATIONS DU FABRICANT 49
PILOTAGE EN MODE DMX 98
ESPAÑOL
MEDIDAS DE SEGURIDAD 50
INTRODUCCIÓN 51
CONEXIONES, ELEMENTOS DE MANEJO Y ELEMENTOS
DE VISUALIZACIÓN 52
FUNCIONAMIENTO 53
COLOCACIÓN, MONTAJE Y AJUSTE MEDIANTE BARRA 62
MONTAR/DESMONTAR LA VISERA Y EL BASTIDOR DE FILTRO /
LIMPIAR LAS LENTES 63
TECNOLOGÍA DMX 63
DATOS TÉCNICOS 64
DECLARACIONES DEL FABRICANTE 65
CONTROL DMX 98
POLSKI
ŚRODKI OSTROŻNOŚCI 66
WPROWADZENIE 67
GNIAZDA, ELEMENTY OBSŁUGI I WSKAŹNIKI 68
OBSŁUGA 69
INSTALACJA, MONTAŻ I REGULACJA ZA POMOCĄ DRĄŻKA
OPERACYJNEGO 78
MONTWRÓT REFLEKTORA IRAMKI FILTRA / DEMONTAŻ /
CZYSZCZENIE SOCZEWEK 79
TECHNIKA DMX 79
DANE TECHNICZNE 80
OŚWIADCZENIA PRODUCENTA 81
STEROWANIE DMX 98
ITALIANO
MISURE PRECAUZIONALI 82
INTRODUZIONE 83
COLLEGAMENTI, ELEMENTI DI COMANDO E DI INDICAZIONE 84
UTILIZZO 85
INSTALLAZIONE, MONTAGGIO E IMPOSTAZIONE TRAMITE
ASTA DI COMANDO 94
MONTAGGIO E SMONTAGGIO DEL PARALUCE E DEL
PORTAFILTRO / PULIZIA DELLE LENTI 95
TECNOLOGIA DMX 95
DATI TECNICI 96
DICHIARAZIONI DEL PRODUTTORE 97
CONTROLLO DMX 98
3
DMX DEUTSCHFRANCAISESPAÑOL ENGLISHITALIANO POLSKI
ENGLISH
YOU‘VE MADE THE RIGHT CHOICE!
We have designed this product to operate reliably over many years. Please read this User‘s Manual carefully, so that you can begin making
optimum use of your Cameo Light product quickly. Learn more about Cameo Light on our website WWW. .COM.CAMEOLIGHT
INTENDED USE!
The product is a device for event technology!
The product has been developed for professional use in the field of event technology and is not suitable for use in households!
Furthermore, this product is only intended for qualified users with expert knowledge of event technology!
Use of the product outside of the specified technical data and operating conditions is considered improper use!
Liability for damage and third-party damage to persons and property due to improper use is excluded!
SAFETY INFORMATION
1. Please read these instructions carefully.
2. Keep all information and instructions in a safe place.
3. Follow the instructions.
4. Observe all safety warnings. Never remove safety warnings or other information from the equipment.
5. Use the equipment only in the intended manner and for the intended purpose.
6. Use only sufciently stable and compatible stands and/or mounts (for fixed installations). Make certain that wall mounts are properly
installed and secured. Make certain that the equipment is installed securely and cannot fall down.
7. During installation, observ e the applicable safety regulations for your country.
8. Never install and operate the equipment near radiators, heat registers, ovens or other sources of heat. Make certain that the equipment is
always installed so that is cooled sufficiently and cannot overheat.
9. Never place sources of ignition, e.g., burning candles, on the equipment.
10. Ventilation slits must not be blocked.
11. This appliance is designed exclusively for indoor use, do not use this equipment in the immediate vicinity of water (does not apply
to special outdoor equipment - in this case, observe the special instructions noted below). Do not expose this equipment to flammable
materials, fluids or gases.
12. Make certain that dripping or splashed water cannot enter the equipment. Do not place containers filled with liquids, such as vases or
drinking vessels, on the equipment.
13. Make certain that objects cannot fall into the device.
14. Use this equipment only with the accessories recommended and intended by the manufacturer.
15. Do not open or modify this equipment.
16. After connecting the equipment, check all cables in order to prevent damage or accidents, e.g., due to tripping hazards.
17. During transport, make certain that the equipment cannot fall down and possibly cause property damage and personal injuries.
18. If your equipment is no longer functioning properly, ifuids or objects have gotten inside the equipment or if it has been damaged in
anot her way, switch it off immediately and unplug it from the mains outlet (if it is a powered device). This equipment may only be repaired
by authorized, qualified personnel.
19. Clean the equipment using a dry cloth.
20. Comply with all applicable disposal laws in your country. During disposal of packaging, please separate plastic and paper/cardboard.
21. Plastic bags must be kept out of reach of children.
FOR EQUIPMENT THAT CONNECTS TO THE POWER MAINS:
22. CAUTION: If the power cord of the device is equipped with an earthing contact, then it must be connected to an outlet with a protective
ground. Never deactivate the protective ground of a power cord.
23. If the equipment has been exposed to strong fluctuations in temperature (for example, after transport), do not switch it on immediately.
Moisture and condensation could damage the equipment. Do not switch on the equipment until it has reached room temperature.
24. Before connecting the equipment to the power outlet, first verify that the mains voltage and frequency match the values specified on the
equipment. If the equipment has a voltage selection switch, connect the equipment to the power outlet only if the equipment values and the
mains power values match. If the included power cord or power adapter does not fit in your wall outlet, contact your electrician.
25. Do not step on the power cord. Make certain that the power cable does not become kinked, especially at the mains outlet and/or power
adapter and the equipment connector.
26. When connecting the equipment, make certain that the power cord or power adapter is always freely accessible. Always disconnect the
equipment from the power supply if the equipment is not in use or if you want to clean the equipment. Always unplug the power cord and
power adapter from the power outlet at the plug or adapter and not by pulling on the cord. Never touch the power cord and power adapter
with wet hands.
27. Whenever possible, avoid switching the equipment on and off in quick succession because otherwise this can shorten the useful life of
the equipment.
28. IMPORTANT INFORMATION: Replace fuses only with fuses of the same type and rating. If a fuse blows repeatedly, please contact an
authorised service centre.
29. To disconnect the equipment from the power mains completely, unplug the power cord or power adapter from the power outlet.
30. If your device is equipped with a Volex power connector, the mating Volex equipment connector must be unlocked before it can be re-
moved. However, this also means that the equipment can slide and fall down if the power cable is pulled, which can lead to personal injuries
and/or other damage. For this reason, always be careful when laying cables.
31. Unplug the power cord and power adapter from the power outlet if there is a risk of a lightning strike or before extended periods of disuse.
32. The device must only be installed in a voltage-free condition (disconnect the mains plug from the mains).


Product specificaties

Merk: Cameo
Categorie: Lamp
Model: F4 FC PO IP65

Heb je hulp nodig?

Als je hulp nodig hebt met Cameo F4 FC PO IP65 stel dan hieronder een vraag en andere gebruikers zullen je antwoorden




Handleiding Lamp Cameo

Handleiding Lamp

Nieuwste handleidingen voor Lamp