Byron BY202F Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Byron BY202F (2 pagina's) in de categorie Deurbel. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/2
Beep
31: plug Chime into a UK 3pin
socket, 220 – 240V ~ 50Hz.
2: Switch the socket on.
3: Chime will ‘Beep’ on Start
1: Push Button 5: Portable Chime
2: Melody Selector 6: Speaker
3: Bell Push Battery 7: Volume Control
4: Signal Sent LED 8: Strobe Alert
Strobe Alert:
Strobe Light will flashPress to switch the
Strobe Alert On or Off
Chime will ‘Beep’
3
â„¢Plug-in Strobe Alert
Wire Free Chime Kit
BY202F
1:
2:
4:
:3
1: Place a small flat screwdriver
into the locking clip on the
base of the Bell Push
2: Gently twist
3: The backing plate will unclip
1
6:
7:
5:
:8
To select the Chime Volume level, press the ‘VOL’
button on the chime There are 4 selectable volume
levels, the Door Chime is pre-set to the loudest
volume setting.
Volume
Default
Functions:
6 Selectable Melodies
1: Tubular 3-Note 4: Solo
2: Big Ben 5: Tubular Score
3: Tubular 2-Note 6: Clarinet
To select a melody for the Door Chime
1: Remove the Back Plate from the Bell
Push.
2: Press the Melody Select button.
3:The chime will play the newly selected
sound.
4: Press again to select the next melody.
Note: For Front/Back door setup, select a
different melody in one of the Bell Pushes.
CR2032
4
Beep
Beep
1: Press and hold the ‘VOL’
button on the Door Chime,
until the Chime goes
‘Beep Beep’ (6 Seconds).
2: Press the Bell Push within
60 seconds to learn the
Bell Push to the chime.
3: The Chime will ring to
confirm setup.
Note: Maximum of 6 Bell
Pushes can be learnt to a
single Chime.
4
Additional Chime
To add an additional Chime unit to the Door Chime kit
1: Press and hold the ‘VOL’ button on your New Door Chime, until the
Chime goes ‘Beep Beep’ (6 Seconds)
2: Press the Bell Push within 60 seconds to learn the additional
Chime to the Bell Push.
3: Chime will ring to confirm setup, wait 60 seconds for the Chime to
exit the learn mode before repressing the bell push.
Additional Bell Push
To add an additional Bell Push to the Door
Chime kit.
1: Press and hold the ‘VOL’ button on your
Door Chime, until the Chime goes
‘Beep Beep’ (6 Seconds).
2: Press the Bell Push within 60 seconds
to learn the additional Bell Push to the
Chime.
3: Chime will ring to confirm setup, wait 60 seconds for the Chime
to exit the learn mode before repressing the bell push.
For Front/back door setup, select a different melody in one of
the Bell Pushes - See Melody Selection.
Note: Maximum of 6 Bell Pushes can be learnt to a single Chime
Adding Additional Chime/Bell Push:
Front Door
Back Door
New Chime
Beep
Beep
1: Insert CR2032 battery
(Supplied) into the battery
holder.
2: Make sure the positive side
is facing upwards.
3: Replace back plate.
2
Warning: Make sure that the batteries are
replaced correctly to avoid battery failure.
Only replace with same or equivalent type.
Installation Guide:
3
Installation Guide: Bell Push
Installation Guide: Chime
Avoid locating the Bell Push/Chime on or directly near
metallic surfaces as this may reduce the operation
range.
UPVC Door Frames:
When locating the bell push onto a UPVC door, always
check the operating performance before final
installation, internal metal frame may affect
performance.
Note: Try adjusting the location of the Bell Push to the Left/Right or
place on external wall.
Range Guide
User Hints:
In case of the door chime does not sound, please check the
followings:
a) Flat batteries in either Push Button or Door Chime.
b) Wrong battery polarity in either Push Button or Door Chime.
c) For Plug-in Door Chimes make sure the socket is switched on.
d) Bell Push and Door Chime are not paired together, see setup
guide.
e) Materials in between the Bell Push & Chime will reduce the
operating range, move the Door Chime closer to the Bell Push
f) Wire free devices can be affected by external sources e.g. wire
free home alarms or power transformers/adapter
Plug-in Door Chime: BY202F
Power: 220 - 240V 50Hz
Range: 100 Metres
Indoor Use Only
Bell Push: BYT
Power: 1 x CR2032 3V DC Battery
(Included)
IP44 Weather Resistant
Type R2 Device - device where the sound output is created by the initial operation
of the control and where the period of sound output continues for the
designed duration irrespective of condition of the control.
IMPORTANT: There are no serviceable parts, do not repair.
Specification
433.92MHz
R&TTE
APPROVED
CH Byron Electrical United Kingdom. www.chbyron.com
A
B
DK
FIN
F
D
GR
LT
IRL
I
L
NL
P
E
S
UK
BG
CZ
EST
H
IS
LV
M
N
SK
SLO
CH
PL
RO
Project Manager
Mr G Hunter
GB: CH Byron
Byron House, Sherwood Rd
Astonfields, Bromsgrove
B60 3DR
UK
support@chbyron.com
9-5 Mon-Fri, Local call charges apply
V1.0
Tel: 0845 2301231 (UK)
www.chbyron.com
433.92MHz
R&TTE
APPROVED
CH Byron Electrical United Kingdom. www.chbyron.com
A
B
DK
FIN
F
D
GR
LT
IRL
I
L
NL
P
E
S
UK
BG
CZ
EST
H
IS
LV
M
N
SK
SLO
CH
PL
RO
Project Manager
Mr G Hunter
V1.0
Bell Push: BYT
Power: 1 x CR2032 3V DC Battery
(Included)
IP44 Weather Resistant
Type R2 Device - device where the sound output is created by the initial operation
of the control and where the period of sound output continues for the
designed duration irrespective of condition of the control.
IMPORTANT: There are no serviceable parts, do not repair.
Specification
Place the door Chime within the operating range, transmis-
sion of the wire free signal through
Walls, Doors and Ceilings etc, may reduce the operating
range. Chime unit for INDOOR use only.
Diagram for illustration purposes only
2
‘CLICK’
1: Using back plate as a
template.
2: Making sure UP arrows
points UP.
2: Mark and drill holes.
3: Insert wall plugs and attach
to wall using screws
provided.
4: Clip the Bell Push on to the
back plate making sure the
Bell Push ‘Clicks’ in to
place.
Note: The Bell Push can be
installed using a suitable
double sided adhesive tab or
tape when drilling is not
sutiable.
1
Resetting Chime:
Reset Chime unit to factory settings.
1: Press and hold the ‘VOL’ button on your Door Chime,
until the Chime goes ‘Beep Beep’ (6 Seconds)
2: Release the ‘VOL’ button
3: Re-press and hold the ‘VOL’ button on your Door Chime,
until the Chime goes ‘Beep’ (6 Seconds)
4: The Chime is now reset.
Vol
Beep
Beep
Beep
Vol
Beep
Beep
Changing Batteries:
Bell Push:
1: Remove back plate from the
Bell Push.
2: Remove old battery from the
holder.
3: Replace with new ‘CR2032’ 3V
battery.
4: Insert into holder making sure
‘+’ is facing up.
5: Test Chime Kit.
Always dispose of old batteries in an environmentally friendly way.
Product specificaties
| Merk: | Byron |
| Categorie: | Deurbel |
| Model: | BY202F |
Heb je hulp nodig?
Als je hulp nodig hebt met Byron BY202F stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Deurbel Byron
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
25 Juni 2023
Handleiding Deurbel
- Deurbel Philips
- Deurbel Panasonic
- Deurbel Fysic
- Deurbel Grundig
- Deurbel Honeywell
- Deurbel Inventum
- Deurbel Quigg
- Deurbel Acti
- Deurbel Alecto
- Deurbel Axis
- Deurbel Balay
- Deurbel Baseline
- Deurbel Beafon
- Deurbel Bellman
- Deurbel Bitron Video
- Deurbel Delta
- Deurbel Denver
- Deurbel Desa
- Deurbel DIO
- Deurbel Doorsafe
- Deurbel Ebench
- Deurbel Eken
- Deurbel Elektrobock
- Deurbel Elro
- Deurbel Envivo
- Deurbel Eufy
- Deurbel Ezviz
- Deurbel Fagor
- Deurbel Foscam
- Deurbel Friedland
- Deurbel Geemarc
- Deurbel GeoVision
- Deurbel Gira
- Deurbel GlobalTronics
- Deurbel Grothe
- Deurbel Hama
- Deurbel Hauck
- Deurbel Heidemann
- Deurbel Hikvision
- Deurbel HQ
- Deurbel Intersteel
- Deurbel KlikaanKlikuit
- Deurbel Konig
- Deurbel Kruidvat
- Deurbel Lifetec
- Deurbel Lorex
- Deurbel LSC SmartConnect (Action)
- Deurbel Marquant
- Deurbel ME
- Deurbel Melinera
- Deurbel Mercury
- Deurbel Merlin
- Deurbel Mr Safe
- Deurbel Nedis
- Deurbel Nest
- Deurbel Perel
- Deurbel Plieger
- Deurbel Profile
- Deurbel Renkforce
- Deurbel Ring
- Deurbel SecuFirst
- Deurbel Sencor
- Deurbel Silvercrest
- Deurbel Sinji
- Deurbel SkyBell
- Deurbel Smart
- Deurbel Smartwares
- Deurbel Somfy
- Deurbel Swissvoice
- Deurbel Toa
- Deurbel Tronic
- Deurbel Trust
- Deurbel Ubiquiti
- Deurbel Unitec
- Deurbel Urmet
- Deurbel V-Tac
- Deurbel Velleman
- Deurbel Zmodo
- Deurbel Jacob Jensen
- Deurbel Olympia
- Deurbel Orbegozo
- Deurbel Caliber
- Deurbel Exibel
- Deurbel Steren
- Deurbel DoorBird
- Deurbel Aspes
- Deurbel EMOS
- Deurbel Infiniton
- Deurbel Arlo
- Deurbel Avidsen
- Deurbel Imou
- Deurbel Techly
- Deurbel Extel
- Deurbel M-e
- Deurbel NuTone
- Deurbel REV
- Deurbel Oricom
- Deurbel Cata
- Deurbel Chacon
- Deurbel ACE
- Deurbel Nexa
- Deurbel Swann
- Deurbel Milectric
- Deurbel Apelson
- Deurbel Hombli
- Deurbel Reolink
- Deurbel Fanvil
- Deurbel EQ3
- Deurbel X-Sense
- Deurbel ORNO
- Deurbel Brilliant
- Deurbel Bell4U
- Deurbel Legrand
- Deurbel Intertechno
- Deurbel EKO
- Deurbel Pentatech
- Deurbel ZAMEL
- Deurbel AVANTEK
- Deurbel ALC
Nieuwste handleidingen voor Deurbel
3 April 2024
3 April 2024
3 April 2024
3 April 2024
3 April 2024
3 April 2024
3 April 2024
3 April 2024
3 April 2024
3 April 2024