Byron BY103 Handleiding

Bekijk gratis de handleiding van Byron BY103 (4 pagina’s), behorend tot de categorie Deurbel. Deze gids werd als nuttig beoordeeld door 29 mensen en kreeg gemiddeld 4.7 sterren uit 6 reviews. Heb je een vraag over Byron BY103 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

1: Place a small flat screwdriver

into the locking clip on the

base of the Bell Push.

2: Gently twist.

3: The backing plate will unclip.

1

Functions:

4 Selectable Melodies

1: Ding Dong (Repeat) 3: Alarm

2: Westminster 4: Ding Dong Ding

4

To select a melody for the Door Chime

1: Remove the Back Plate from the Bell

Push.

2: Press the Melody Select button.

3:The chime will play the newly selected

sound.

4: Press again to select the next melody.

Note: For Front/Back door setup, select a

different melody in one of the Bell Pushes.

CR2032

Adding Additional Chime/Bell Push:

1: Insert CR2032 battery

(Supplied) into the battery

holder.

2: Make sure the positive side

is facing upwards.

3: Replace back plate.

2

Warning: Make sure that the batteries are

replaced correctly to avoid battery failure.

Only replace with same or equivalent type.

3

1: Plug Chime into a UK 3pin

socket, 220 – 240V ~ 50Hz.

2: Switch the socket on.

Beep

Beep

1: The Chime will ‘Beep Beep’.

2: Press the Bell Push within

60 seconds to learn the

Bell Push to the chime.

3: The Chime will ring to

confirm setup.

Note: Maximum of 2

Bell Pushes can be learnt to a

single Chime for Front/Back

4

Additional Bell Push

To add an additional Bell Push to the Door Chime kit

1: Unplug the Door Chime and wait for 10

seconds.

2: Plug the Door Chime into the Socket and

switch the socket on.

3: Press both Bell Pushes within 60 seconds, to pair

the additional Bell Push to the Chime.

4: Chime will ring to confirm setup, wait 60 seconds

for Chime to exit the learn mode before repressing the

Bell Push5.

5: For Front/Back door setup, select a different melody in one of the

Bell Pushes - See Melody Selection.

Note: Maximum of 2 Bell Pushes can be learnt to a single

Door Chime.

Front Door

Back Door

New Chime

Additional Chime

To add an additional Chime unit to the Door Chime kit

1: Unplug the NEW Door Chime and wait for 10

seconds

2: Plug the Door Chime into the Socket and switch the socket On.

3: The Chime will ‘Beep Beep’ to indicate that it has entered

the Learn mode.

4: Press the Bell Push within 60 seconds, to pair the additional

Chime to the Bell Push.

5: Chime will ring to confirm setup, wait 60 seconds for the Chime

to exit the learn mode before repressing the Bell Push.

Beep

Beep

BY103

1: Push Button 5: Plug-through Chime

2: Melody Selector 6: Speaker

3: Bell Push Battery

4: Signal Sent LED

1:

2:

4:

:3

6:

5:

3

Plug-in any standard electrical product,

220–240V ~50Hz.

e.g. table light, upto a Max Load of

1000W

Avoid using low voltage Transformers, as

this may reduce the operating range of

the Door Chime

Plug-through Socket:

Melody selection:

™Plug-through

Wire Free Chime Kit

Product specificaties