Brinsea OvaEasy 190 Advance Handleiding

Brinsea Niet gecategoriseerd OvaEasy 190 Advance

Lees hieronder de đź“– handleiding in het Nederlandse voor Brinsea OvaEasy 190 Advance (16 pagina's) in de categorie Niet gecategoriseerd. Deze handleiding was nuttig voor 35 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld

Pagina 1/16
MJ192 GB Issue 02
1
OVA-EASY
190 and 380
ADVANCE
User Instructions
Contents
Section Subject Page
1 Introduction 2
2 Unpacking 3
3 Location and Installation 3
4 Quick Reference 3
5 Digital Control System 5
6 Storage of eggs 7
7 Temperature 7
8 Humidity and Ventilation 8
9 Egg Turning 10
10 Egg Setting 11
11 Hatching 11
12 Cleaning up 12
13 Troubleshooting 12
14 Servicing and Calibration 14
15 Specifications 16
MJ192 GB Issue 02
2
1 Introduction
These instructions detail the operation of your new 190 or 380 egg Digital Cabinet Incubator with programmable
automatic egg turning system. Please read these instructions carefully before setting up your machine to achieve best
results and keep these instructions safe for future reference. This document includes recommended procedures for
successful hatching but incubation involves the control and manipulation of a large number of factors and in certain
circumstances different procedures may be necessary. Your incubator is designed to allow the user to vary the
incubation conditions to suit a wide range of species in different ambient conditions and the specific set-up for every
situation is beyond the scope of these instructions.
There is a range of books available covering incubation techniques, for more information or to request a book list please
don’t hesitate to contact us.
The Ova-Easy Advance incubators are available with the option of the Advance Humidity Pump for automatic humidity
control. Operating instructions for this module are supplied separately.
Fig. 1 Functional Features of the Ova-Easy 190 and 380 Advance Cabinet Incubators with Programmable
Automatic Turning.
Clear Door
Hatching
Tray(s) with
Cover
Setting Shelves
(x3) with
Programmable
Automatic Egg
Turning
Removable
Water
Evaporation
Tray
Ventilation
Control
Digital
Display
Insulated Panels
Control
Buttons
Output for
optional
Advance
Humidity
Pump
MJ192 GB Issue 02
3
2 Unpacking & Assembly
2.1 Your incubator has been supplied in protective packaging. Please remove all tape, strapping and packing from
the incubator parts. Retain the carton and packing materials to enable the unit to be repacked.
2.2 Please check that parts are all present and undamaged.
2.3 Check also that the electrical supply matches the machine’s requirements (marked on the technical label on the
outside of the box and on the top cover of the Incubator).
2.4 To register your new Brinsea product please visit www.brinsea.co.uk and follow the link on the right hand side
of the home page to qualify for your free 2 year guarantee.
2.5 Go to www.Brinsea.co.uk and register as a free member of the Brinsea Email Group to receive the latest news
and information such as advance notice about new products, special offers, exclusive competitions and much
more.
3 Location and Installation
THE INCUBATOR MUST BE PLACED IN AN INDOOR AREA NOT SUBJECT TO SPLASHES OF WATER
OR WET CONDITIONS AND OUT OF REACH OF ANIMALS AND CHILDREN.
3.1 Your incubator will give best results in a room free from wide temperature variations and with generous
ventilation – particularly if several incubators are running at the same time. Ensure that the room temperature
cannot drop on a cold night. Ideally thermostatically control the room at between 20 and 25°C (68 and 77°F).
Never allow the room temperature to drop below 15°C (59°F) and ensure that the incubator cannot be exposed to
direct sunlight.
3.2 Always place the incubator upright on a flat level surface. The 190 size incubator weighs 20Kg and the 380 size
incubator weighs 27Kg. Ensure the surface is adequate to support the weight of the machine and contents.
3.3 Open the door, slide out the Evaporation Tray and fill with 1:200 mix of water and Brinsea disinfectant solution.
The water level should be no higher than approx 1” (2.5cm) from the top. The evaporating block is not normally
needed unless very high humidity levels (e.g. for hatching) are required or the optional Advance Humidity Pump
is being used. Close the door.
3.4 Plug the incubator supply cable into a suitable outlet ensuring that the cable is not pulled tight. The incubator
fans will start, the buzzer sound and the LCD display will show the air temperature and humidity.
4 Quick Reference (please read relevant section for detail)
This quick reference is intended to allow users to quickly set up the incubator and learn the key features of the control
system. Please read the rest of the instructions to obtain a full understanding of each feature.
PRESS BOTH BUTTONS TO UNLOCK THE MAIN MENU
SELECT THE OPTION / RETURN TO THE MENU.
GO FORWARD ONE SCREEN / INCREASE THE VALUE / DISPLAY IN CELSIUS.
GO BACK ONE SCREEN / DECREASE THE VALUE / DISPLAY IN FAHRENHEIT.
PRESS BOTH BUTTONS TO TURN NOW (THEN ANY BUTTON TO PAUSE / STOP)

Product specificaties

Merk: Brinsea
Categorie: Niet gecategoriseerd
Model: OvaEasy 190 Advance

Heb je hulp nodig?

Als je hulp nodig hebt met Brinsea OvaEasy 190 Advance stel dan hieronder een vraag en andere gebruikers zullen je antwoorden


Handleiding Niet gecategoriseerd Brinsea

Brinsea

Brinsea Octagon 20 Advance Handleiding

9 Juli 2023
Brinsea

Brinsea Octagon 20 ECO Handleiding

5 Juli 2023
Brinsea

Brinsea Hatchmaster Handleiding

2 Juli 2023
Brinsea

Brinsea OvaEasy 190 Advance Handleiding

26 Juni 2023
Brinsea

Brinsea OvaEasy 190 Advance EX Handleiding

23 Juni 2023

Handleiding Niet gecategoriseerd

Nieuwste handleidingen voor Niet gecategoriseerd

Playtive

Playtive IAN 327221 Handleiding

1 Mei 2024
Samsung

Samsung UN32J4001AF Handleiding

1 Mei 2024
Bauknecht

Bauknecht KSI 18GF2 P2 Handleiding

27 April 2024
Fakir

Fakir Artemis TS 150 Handleiding

26 April 2024
Sony

Sony UTX-M03 Handleiding

26 April 2024
Sony

Sony URX-P03 Handleiding

26 April 2024
Sony

Sony WRU-806B Handleiding

26 April 2024
Sony

Sony UTX-B03 Handleiding

26 April 2024
Sony

Sony UTX-P03 Handleiding

26 April 2024
Sony

Sony ODS-L10 Handleiding

26 April 2024