Blebox parkingsensor Handleiding

Bekijk gratis de handleiding van Blebox parkingsensor (2 pagina’s), behorend tot de categorie Niet gecategoriseerd. Deze gids werd als nuttig beoordeeld door 69 mensen en kreeg gemiddeld 4.6 sterren uit 4 reviews. Heb je een vraag over Blebox parkingsensor of wil je andere gebruikers van dit product iets vragen? Stel een vraag

SAFETY RULES

Connect only in accordance with the diagram presented in the

manual. Improper connections may be dangerous, it can damage

the controller, and loss of the warranty.

Do not connect the device to loads exceeding the permitted

values.

DANGER! Risk of electric shock! Even with the device turned o,

the outputs may be live. All assembly work should be ALWAYS

performed with the disconnected power circuit.

The installation of the device to a power mains that does not

meet the quality requirements dened by EN 50081-1, EN

50082-1, UL508, EN 60950, will result in the loss of the warranty.

PARKING SENSOR LED / LED RGB LIGHTING CONTROLLER

Before installing the sensor, disconnect the voltage in the supplied circuit.

Remember that all assembly work should be carried out with the power

supply disconnected.

The sensor should be mounted in a place protected from adverse environ-

mental conditions. It is advisable that the device is mounted in a stable and

stationary position.

Connect the LED strips and power supply to the device according to the

diagram.

Optionally, connect the LED lamp indicating the occupancy of the parking

space. When the vehicle is within range of the sensor, the lamp will remain on

continuously.

1

INSTALLATION

sensor

bumper/number plate

frame/light

source

Mount the device vertically at the height of the farthest part of the car

(usually a bumper or license plate) as in the drawing below, so that the

connector is at the bottom.

Connect the power supply. Bring your hand or paper closer to the ParkingSen-

sor sensor, the color of the light should change with the detector:

2

FIRST START-UP

3

MOVEMENT OF THE VIRTUAL WALL

the time of the color illumination (red / blue / green) is 10 seconds, while the

optional LED lighting shines during the entire period of occupancy of the

parking space.

the range of the color changes are established in relation to the virtual wall. By

default, the virtual wall is at a physical distance of 2 cm from the sensor. It can

be adjusted in the physical range 2 cm..250 cm of the sensor by performing

the following steps:

1.

2.

3.

4.

5.

place a at object (for example, a piece of cardboard) in front of the

sensor at the desired distance, such as a virtual wall;

connect the power supply; wait 5 seconds; disconnect the power supply;

connect the power supply; wait 10 seconds; disconnect the power

supply;

connect the power supply; wait 15 seconds; disconnect the power

supply;

connect the power supply; wait until the LED strip turn on white and

then turn o, which means that the conguration has been saved; check

if the virtual wall works as expected.

CONNECTION DIAGRAM

green color

blue color

red colour

pulsing red color

you can move forward safely

you are close to the obstacle

stop the vehicle

stop the vehicle immediately!

option of signaling the occupied

space

LED STRIP

110 / 230V

12 - 24 V

+

power

supply

G

R

B

BRG-0+

LED STRIP*

*

-

Product specificaties