Avanti HRS10321B Handleiding
Lees hieronder de 📖 handleiding in het Nederlandse voor Avanti HRS10321B (4 pagina's) in de categorie Kluis. Deze handleiding was nuttig voor 36 personen en werd door 2 gebruikers gemiddeld met 4.5 sterren beoordeeld
Pagina 1/4
MODEL HRS10321B
SECURITY SAFE
INSTALLATION AND USAGE INSTRUCTIONS
Your Avanti Room Security Safe is supplied with the following:
1 – Security Safe Unit
2 – Emergency Access Keys
1 – Installation / Usage Guide
1 – Felt Liner
Installation Screw Kit
4 – Rubber Feet
INSTALLING YOUR SECURITY SAFE
When installing your safe, be sure the location is sturdy enough to support the unit and is both
secure and easy to access.
Safe can be installed onto either a concrete or wooden surface.
When installing use a 25/64” (10mm) drill bit and screws.
To prevent removal of your security safe, it is recommended to use Allen type screws (not included)
to affix the unit to the installation location.
INITIAL SETUP AND CONFIGURATION.
After you have installed the unit in its final location, proceed to set up digital access controls.
1) Using the emergency Access Key, open the safe.
2) Open the battery compartment cover.
3) Following the image shown in the battery compartment install 4 AA sized batteries.
4) Close the battery compartment cover.
5) Using the keypad, enter the initial setup password “1234” or the administrator password
“888888”.
NOTE:
Battery Life / Level: Always replace all of the batteries at the same time. If at any time the battery
level is too low to operate the security safe, use the emergency access key.
Safety / Security Feature: If the passcode is entered incorrectly more than 3 times the keypad will
go into lock mode. After approximately (1 5) fifteen minutes the keypad will return to normal
working function.
Interior Light: When the safe is unlocked using the keypad, the interior light will turn on and will
turn off automatically after approximately 30 seconds.
Automatic Door Opening: When the safe is unlocked using the keypad the door will automatically
open slightly outward to allow easy / quick access to contents stored in the safe.
RESETTING THE ADMINISTRATOR PASSWORD
To reset the access code read and follow the steps below.
1) With the door open, press the “ ” s,Clear key twice, the Yellow Light flashe enter old master code
(default “ ”8-8-8-8-8-8 )
2) one acoustic signals ( will come (It“beep”) ’s mean old master code is right, if old master code is
wrong, three beep beep beep acoustic signals (“ ” “ ” “ ”) will come), enter a new master code of 6 digits ,
one aco ustic signals (“beep”) will come.
3) Re long - inter the new master code, the Green Light flashes and one acoustic signals (“beep~ )”,
indicates new master code changed successfully.
GUEST / USER CODE SETUP
To reset the access code read and follow the steps below.
1) With the door CLOSED, enter a new 3 – 6 digit code and press the “LOCK” key to confirm the new
pass code.
2) You will hear and see the security lock engage.
3) Enter the new pass code to open the security safe.
4) Close the door and enter the new code set up in step # 1 and press the “LOCK” key.
5) If the Guest / User enters the wrong pass code three (3) times in a row the keypad will go into
security-lock mode and will remain locked for approximately (1 (15) fifteen minutes. After the 5)
f ifteen minutes has elapsed the keypad will return to normal operation.
Avanti Products
Miami, FL 33172
In the event of service is sues, please call the
Customer Hotline at 1-800 220 5570– -
Additional Instructions:
Manual Operation (Open using the key).
• User will need to remove the key hole cover by peeling away the key hole cover label.
• Insert the emergency access key into the lock and turn clockwise to open the safe.
• While the door is open, change the batteries on the control panel
Battery Override ( 9 Volt Square battery required)
In the even the batteries are low or need to be changed, you can open the unit either manually by using the
access key or via external battery supply.
Using a 9 Volt square battery, touch the batter terminals to the two round metal pads on the front of the control
to give temporary power to the controls.
While the battery is in place, enter the preset passcode and the door will open giving you access to the safe
and the battery compartment.
Avanti Products
Miami, FL 33172
In the event of service issues, please call the
Customer Hotline at 1-800 220 5570– -
Product specificaties
| Merk: | Avanti |
| Categorie: | Kluis |
| Model: | HRS10321B |
Heb je hulp nodig?
Als je hulp nodig hebt met Avanti HRS10321B stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Kluis Avanti
24 Mei 2023
11 Mei 2023
Handleiding Kluis
- Kluis Philips
- Kluis Honeywell
- Kluis Abus
- Kluis Burg-Wachter
- Kluis Duralock
- Kluis EasySafe
- Kluis Ferm
- Kluis Filex
- Kluis FireKing
- Kluis First Alert
- Kluis Fluke
- Kluis Hama
- Kluis Handson
- Kluis M-Locks
- Kluis Master Lock
- Kluis Nauta
- Kluis Nedis
- Kluis Perel
- Kluis Phoenix
- Kluis Protector
- Kluis Renkforce
- Kluis ROMA
- Kluis Rottner
- Kluis Royal Safe
- Kluis Royal Sovereign
- Kluis Salvus
- Kluis Sentry
- Kluis Sistec
- Kluis SMC
- Kluis Sygonix
- Kluis Technomax
- Kluis Thule
- Kluis Toolland
- Kluis Topcraft
- Kluis Tulox
- Kluis Varo
- Kluis Westfalia
- Kluis Workzone
- Kluis Yale
- Kluis Jewel
- Kluis Juwel
- Kluis Olympia
- Kluis Oxloc
- Kluis First Austria
- Kluis Guzzanti
- Kluis Steren
- Kluis Barska
- Kluis Conrad
- Kluis SereneLife
- Kluis Challenge
- Kluis Hard Head
- Kluis Kidde
- Kluis SentrySafe
- Kluis CAWI
- Kluis Kreator
- Kluis Fichero
- Kluis Kreator-Varo
- Kluis Rottner Tresor
- Kluis Olymp
- Kluis Suncast
- Kluis Winholt
- Kluis Homak Security
- Kluis NOFIRE
Nieuwste handleidingen voor Kluis
16 April 2024
11 Maart 2024
11 Maart 2024
11 Maart 2024
11 Maart 2024
7 Maart 2024
7 Maart 2024
7 Maart 2024
7 Maart 2024
7 Maart 2024