Aurel TXSAW433 Handleiding

Bekijk gratis de handleiding van Aurel TXSAW433 (5 pagina’s), behorend tot de categorie Receiver. Deze gids werd als nuttig beoordeeld door 52 mensen en kreeg gemiddeld 4.4 sterren uit 4 reviews. Heb je een vraag over Aurel TXSAW433 of wil je andere gebruikers van dit product iets vragen? Stel een vraag

TX--SAW/433 sZ

Instruction Manual

Technical features are subject to change without notice. AUR°EL S.p.A does not feel responsible for any damage caused by the device’s misuse.

AUR°EL S.p.A. Via Foro dei Tigli, 4 --- 47015 Modigliana (FC) – ITALY Rev. A, 19092001

Tel.: +390546941124 –1 Fax: +390546941660 Pag of 5

http://www.aurel.it - email: aurel@aurel.it

TX--SAW / 433 sZ Transmitter

SAW Transmitter module with external antenna, for utilisations with ON-OFF modulation of a RF carrier with digital data.

Pin-out

Connections

Pin 1--413 Ground GND Connections. To be externally connected to a single ground plate.

(see fig. 3)

Pin 2 Input Mod.TTL 0÷5V type data input with a minimum 5KΩresistance. Connection

utilized only if the supply to pin 15 is +12V ±10% (see fig. 2)

Pin 3 Input Mod.TTL 0÷5V type data input with a minimum 5KΩresistance. Connection

utilized only if the supply to pin 15 is +5V ±10% (see fig. 2)

Pin 11 RF output RF output with a characteristic impedence of 50Ω

Pin 15 +VConnection to the positive pole of the +5V ±10% supply

Max voltage values allowed

Description Max Unity Remarks

Voltage supply (Vs) to pin 15 13,5 V

Technical features [ETS 300 200]

Description Min Typical Max Unity Remarks

Working frequency centre 433.82434.02 433.92 MHz See notes 1 and 2

Voltage supply (Vs) 4.5 5.5 5 V

Absorbed current 4mA

RF output power (E.R.P.) +10dBmSee note 1

Output impedance pin 11 50Ω

RF spurious emissions -50dBm See note 1

Modulation frequency 4kHz

Input high logic level 4.55.5 5 V

Input low logic level 0 0.2 V

Working temperature -20 +80 °C See fig. 5

Working temperature [ETS 300 200] -20 +55 °C See fig. 5

Dimensions 38.1 x 13.2 x 3 mm See Pin-out

Note1: Values have been obtained by applying the test system shown in Fig. 1 and maximum 5,5 V power supply.

Note2: The minimum and maximum showed values are determined by the device’s construction tolerance.

To define the working frequency of the device, add to these values the deviation caused by the thermal variations (see fig. 3).

Note3: To keep the parameters within the limits established by the rules in force, (see para. “Reference Rules”), it is recommended to

supply the circuit with not more than 5,5V and to comply with all the recommendations specified in para “Device usage”.

Messrs AUR°EL declines all responsibilities in case the a.m. recommendations are disregarded.

Lot (Week/Year) Code

1

15

Product specificaties