Atlas Sound PD-5VH Handleiding
Atlas Sound
Speaker
PD-5VH
Bekijk gratis de handleiding van Atlas Sound PD-5VH (2 pagina’s), behorend tot de categorie Speaker. Deze gids werd als nuttig beoordeeld door 4 mensen en kreeg gemiddeld 4.6 sterren uit 2.5 reviews. Heb je een vraag over Atlas Sound PD-5VH of wil je andere gebruikers van dit product iets vragen? Stel een vraag
Pagina 1/2
Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3332 • FAX: (800) 765-3435
©2004 ATLAS SOUND LP Printed in U.S.A. 000604 ATS001741 RevB 6/04 487010
INSTALLATION INSTRUCTIONS
ATLAS SOUND PD-30(T)(-16),
PD-5V(H)(T),PD60A(T)
GENERAL DESCRIPTION
• High efficiency compression drivers with various power levels available
• Environment resistant construction for indoor/outdoor use
• Various horn types available for different coverage patterns and SPL’s
• Field replaceable diaphragms
PD-30(T)(-16)
Field connections are made to the 2 screw terminals located under the clear cover plate. Terminal 2 is positive with respect
to terminal 1. For the transformer equipped models, a screwdriver adjustable tap selector is also located beneath the
cover plate. Set the tap to the desired power level by lining up the screwdriver slot with the correct tap position. Do
not use
positions 6 or 7 (PD-30T) for a 70.7V line. It is recommended that the proper high pass filter be installed to limit low
frequency reproduction and to prolong diaphragm life. Low frequency cut off is a parameter of the horn attached
to this driver. Check with Atlas Sound for recommendations. See Capacitor Selection Chart for the proper value on
this document.
PD5VH(T)
Field connections for the
non transformer version are located on the outside of the sound chamber and are marked “1”
and “2”. Pin 2 is positive with respect to pin 1.
For the transformer equipped version, field connections are made to the screw terminals located on the rear of the driver
assembly, beneath the clear protective cover. On this model, connect the common of your speaker line to the terminal
labeled “C”, the positive of your speaker line to the appropriate tap terminal.
It is recommended that the proper high pass filter be installed to limit low frequency reproduction and to prolong
diaphragm life. Low frequency cut off is a parameter of the horn attached to this driver. Check with Atlas Sound
for recommendations. See Capacitor Selection Chart for the proper value on this document
.
SPECIFICATIONS
MODEL POWER
RATING
PLANE WAVE
FREQ. RESPONSE
LOW FREQ. LIMIT
@ FULL POWER
SOUND
LEVEL˚
IMPEDANCE POWER
TAPS
VOICE
COIL
DIMENSIONS WEIGHT
PD-5VH
40W 110 - 4,100 Hz
(±5DB)
250Hz 110.7 (AVG)
110 - 4,200 Hz (±5db)
16 (Nom.) – 2”
(5CM)
5 1/8” H x 6
3/8” W (17.5cm
x 16.2cm)
4.10 lbs.
(1.9Kgs.)
PD-5VT 40W 190 - 4,200 Hz
(±5db)
300 Hz 111.2 (avg)
190 - 4,200 Hz (±5dB)
2K, 1K, 500,
250, 125, 16
70.7V
@ -
2.5, 5, 10,
20, 40
6 7/8” H x
6 3/8” W
7 lbs.
(3.2Kgs)
SPECIFICATIONS
MODEL
POWER
RATING
PLANE WAVE
FREQ. RESPONSE
LOW FREQ. LIMIT
@ FULL POWER
SOUND
LEVEL˚
IMPEDANCE POWER
TAPS
VOICE
COIL
DIMENSIONS WEIGHT
PD-30
30W
300 - 3,900 Hz
(±5dB)
500Hz
113.6 (avg) 300 -
3,900 Hz (±5dB)
8 (Nom.) –
1.5”
(3.2cm)
4.5” H x 4.5”
Dia. (11.4cm x
11.4cm)
3 lbs.
(1.45Kgs.)
PD-30-16
16 (Nom.)
_
4.75 lbs.
(2.1Kgs)
PD-30T 45, 89, 167,
333, 666,
1300, 2500
70.7V@ -
1.8, 3.7,
7.5, 15, 30
INSTALLATION INSTRUCTIONS
ATLAS SOUND PD-30(T)(-16),
PD-5V(H)(T),PD60A(T)
PD60A(T)
Field connections are made to the screw terminals located on the rear of the driver assembly, beneath the clear protective
cover. On the transformer equipped models, connect the common of your speaker line to the terminal labeled “C”, and the
positive of your speaker line to the appropriate tap terminal.
On the non transformer equipped assembly, terminal 2 is positive with respect to terminal 1. It is recommended that the
proper high pass filter be installed to limit low frequency reproduction and to prolong diaphragm life. Low frequency cut off
is a parameter of the horn attached to this driver. Check with Atlas Sound for recommendations. See Capacitor Selection
Chart for the proper value on this document
IMPORTANT!
To determine the proper capacitor to limit low frequency reproduction, find the low frequency cutoff for the compression
driver you are using, locate this figure on the chart below on the left hand vertical column. Next, using the tap value you
are using in Watts from the top horizontal column, follow down to find the recommended capacitor value.
Use non polarized electrolytic capacitors rated at 150VDC or greater, wired in series with the positive lead of the speaker
line, one per driver.
Note: When non-standard values are indicated, use closest smaller value.
Capacitor Selection Chart
Horn
Low Freq
Cut-Off
60 W
83 OHMS
40 W
125 OHMS
30 W
169 OHMS
20 W
250 OHMS
15 W
333 OHMS
10 W
500 OHMS
VOICE COIL
16 OHMS 8 OHMS
100 Hz 20 uf 12 uf 10 uf 6 uf 5 uf 3 uf 100 uf 200 uf
125 hz 15 uf 10 uf 7.5 uf 5 uf 4 uf 2.4 uf 80 uf 160 uf
150 hz 12 uf 8 uf 6 uf 4 uf 3 uf 2 uf 66 uf 132 uf
200 hz 10 uf 6 uf 5 uf 3 uf 2.5 uf 1.5 uf 50 uf 100 uf
250 hz 7.5 uf 5 uf 3.7 uf 2.5 uf 2 uf 1.2 uf 40 uf 80 uf
300 hz 6 uf 4 uf 3 uf 2 uf 1.5 uf 1 uf 33 uf 66 uf
400 hz 5 uf 3 uf 2.5 uf 1.5 uf 1.25 uf .75 uf 25 uf 50 uf
500 hz 4.7 uf 2.5 uf 2.3 uf 1.2 uf 1.1 uf .6 uf 20 uf 40 uf
650 hz 3 uf 2 uf 1.5 uf 1 uf .75 uf .5 uf 15 uf 30 uf
800 hz 2.5 uf 1.5 uf 1.2 uf .75 uf .6 uf .4 uf 12.5 uf 25 uf
1000 hz 2 uf 1.2 uf 1 uf .6 uf .5 uf .3 uf 10 uf 20 uf
1200 hz 1.5 uf 1 uf .75 uf .5 uf .4 uf .25 uf 8.2 uf 16.4 uf
1600 hz 1.1 uf .7 uf .55 uf .35 uf .22 uf .17 uf 6.2 uf 12.4 uf
Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3332 • FAX: (800) 765-3435
©2004 ATLAS SOUND LP Printed in U.S.A. 000604 ATS001741 RevB 6/04 487010
SPECIFICATIONS
MODEL POWER
RATING
PLANE WAVE
FREQ. RESPONSE
LOW FREQ. LIMIT
@ FULL POWER
SOUND
LEVEL˚
IMPEDANCE POWER
TAPS
VOICE
COIL
DIMENSIONS WEIGHT
PD-60A
60W
100 - 3,700 Hz
(±5dB)
300Hz
112.7 (AVG)
100 - 3,700 Hz (±5db)
16 (Nom.) –
2”
(5CM)
6 7/8” H x 6
3/8” W
(17.5cm x
16.2cm)
6.2 lbs.
(2.8Kgs.)
PD-60 2K, 1K, 500, AT
250, 125,
18, 16
70.7V@ -
2.5, 5, 10,
20, 40, 60
8 lbs.
(3.6Kgs)
Product specificaties
| Merk: | Atlas Sound |
| Categorie: | Speaker |
| Model: | PD-5VH |
Heb je hulp nodig?
Als je hulp nodig hebt met Atlas Sound PD-5VH stel dan hieronder een vraag en andere gebruikers zullen je antwoorden
Handleiding Speaker Atlas Sound
19 Mei 2025
14 Mei 2025
14 Mei 2025
14 Mei 2025
14 Mei 2025
14 Mei 2025
14 Mei 2025
14 Mei 2025
14 Mei 2025
14 Mei 2025
Handleiding Speaker
- Russound
- Rocketfish
- Induction Dynamics
- Pyle
- Arcam
- ZAPUVO
- Exibel
- Technika
- Musway
- Celestion
- Logik
- R-MUSIC
- Perfect Choice
- Amina
- Mission
Nieuwste handleidingen voor Speaker
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025
17 Juni 2025